1996 FORD PROBE coolant level

61 [LG06360(ALL)05/95]
3. Check the oil level when the vehicle is on
level ground.
[LG06370(ALL)11/91]
4. Add only as much oil as the engine needs
before you drive the vehicle again. Do not
overfill the oil reservoir. For more
information, seeAdding engine oilin the
Index.
*
[LG06400(ALL)01/95]
Engine Coolant Temperature Gauge
*
[LG06500(ALL)03/95]
This gauge indicates the temperature of the
engine coolant, not the coolant level. If the
coolant is not at its proper level or mixture, the
gauge indication will not be accurate.
*
[LG06600(ALL)03/94]
The pointer usually moves from C (cold) into
the NORMAL band as your vehicle warms up.
Under most driving conditions, the pointer
should stay in the NORMAL band. If you are
driving in heavy traffic or on an extended grade
in hot weather, the pointer may reach to the top
of the NORMAL band.
*
[LG06700(ALL)05/95]
If, under any circumstances, the pointer moves
above the NORMAL band, the engine coolant is
overheating and continued operation may cause
engine damage.
*
[LG06800(ALL)01/95]
If your engine coolant overheats:
*
[LG06900(ALL)03/95]
1. Pull off the road as soon as it is safely
possible.
*
[LG07000(ALL)04/95]
2. Shut off the engine immediately or severe
engine damage could result.
*
[LG07100(ALL)05/95]
3. Let the engine cool.
*
[LG07200(ALL)03/95]
4. Check the coolant level following the
instructions on checking and adding coolant
to your engine. (SeeEngine coolantin the
Index.) If you do not follow these
instructions, you or others could be injured.
File:prlgp.ex
Update:Fri Jun 23 19:38:06 1995

221
*
[SV17400(ALL)03/95]
Engine Coolant
*
[SV17500(ALL)02/95]
Checking the engine coolant
*
[SV17550(ALL)01/95]
NOTE: Be sure to read and understand
Precautions When Servicing Your Vehicle
at the beginning of this chapter.
*
[SV17600(ALL)05/95]
RWARNING
The cooling fan is automatic and may
come on at any time. Always disconnect
the negative terminal of the battery before
working near the fan.
[SV17900(ALL)02/92]
Inspect the coolant level with the dipstick
attached to the reservoir cap. Remove the cap,
wipe it clean and then put it back in the
reservoir. Remove it again. The coolant level
should be between L and F.
[SV17950(ALL)01/92]
If the coolant level is at or below the L line, add
enough 50/50 mixture of specified coolant and
water to bring the level to the F mark.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

222 [SV18200(ALL)01/92]
half page art:0032038-BEngine coolant recovery reservoir and dipstick
*
[SV18500(ALL)01/95]
Adding engine coolant
*
[SV18600(ALL)05/95]
RWARNING
Do not put engine coolant in the container
for the windshield washer fluid.
*
[SV18610(ALL)06/95]
If sprayed to clean the glass, engine coolant or
antifreeze could make it difficult to see through
the windshield.
[SV18650(ALL)02/95]
Add engine coolant only to the recovery
reservoir Ð not to the radiator.If the coolant
level is low, add to the engine coolant recovery
reservoir container a 50/50 mixture of water and
the type of coolant that Ford specifies. Check the
coolant level again the next few times you drive
your vehicle.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

226 %
*
[SV20600(ALL)01/95]
Use Ford Premium Cooling System Fluid or an
equivalent engine coolant that meets Ford
Specification ESE-M97B44-A. Do not use alcohol
or methanol antifreeze and do not use engine
coolant mixed with alcohol or methanol
antifreeze. If you do not use the proper coolant,
the aluminum radiator on your vehicle will
corrode.
*
[SV20700(ALL)04/93]
Leave the engine coolant in all year. Make sure
that the coolant will not freeze at the
temperature level in which you drive during
winter months. Keep an engine coolant in your
engine that has a protection rating of at least
-20ÊF (-29ÊC), orwhatever protection rating is
appropriate for the climate in which you live.
*
[SV20800(ALL)03/95]
To find out how much engine coolant mixture
your vehicle's coolant system can hold, seeRefill
capacities for fluidsin the Index.
*
[SV20900(ALL)02/95]
You may add water by itself only in an
emergency, but you should replace it with a
50/50 mixture as soon as possible.
*
[SV21000(ALL)01/95]
Have your dealer check the engine cooling
system for leaks if you have to add a quart
(liter) of engine coolant more than once a month.
*
[SV21200(ALL)05/95]
Engine coolant drain and flush
*
[SV21300(ALL)05/94]
The proper procedures to completely drain and
flush the engine cooling system can be found in
the Service Manual for your vehicle or you can
see your dealer. See the order form located
before this chapter. Follow these recommended
procedures to ensure that your vehicle has the
specified engine level and 50/50 mixture of
cooling system fluid and water.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

227 [SV21450(ALL)05/95]
Refilling the engine coolant Ð 2.0L engine
*
[SV21500(ALL)03/95]
When the entire engine cooling system is to be
drained and refilled, use the following
procedure:
*
[SV21600(ALL)01/89]
1. Remove the radiator cap.
*
[SV21700(ALL)06/89]
2. With the engine off and cool, add a 50/50
mixture of recommended engine cooling
system fluid and water until the radiator is
full.
*
[SV21800(ALL)07/93]
3. Replace and fully tighten the radiator cap,
then unscrew the cap to the first stop.
*
[SV21900(ALL)06/89]
4. Start and idle the engine until the radiator
upper hose is warm (this indicates the
thermostat is open and engine coolant is
flowing through the entire system).
[SV22000(ALL)04/95]
5. Shut the engine off and check the fluid level
in the radiator. Add more fluid if necessary.
[SV22005(ALL)03/94]
6. When the radiator is filled to the proper
level, replace the coolant system cap and
tighten both caps completely.
[SV22010(ALL)01/92]
Refilling the engine coolant Ð 2.5L engine
[SV22015(ALL)04/95]
When the entire cooling system is to be drained
and refilled, use the following procedure:
[SV22020(ALL)04/93]
1. Locate the radiator breather cap and the
coolant system cap in your engine
compartment. The cap on your right
(driver's side) is the radiator breather cap.
The cap on your left (passenger's side) is the
coolant system cap.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

229 [SV22035(ALL)02/92]
4. Replace the radiator breather cap and the
coolant system cap and tighten to the first
stop.
[SV22050(ALL)02/92]
5. Start and idle the engine until the radiator
upper hose is warm. The warm hose
indicates the thermostat is open and the
engine coolant is flowing through the entire
system.
[SV22060(ALL)02/92]
6. Shut the engine off and check the fluid level
in the radiator through the coolant system
cap opening. Add more fluid if necessary.
[SV22070(ALL)02/92]
7. When the radiator is filled to the proper
level, replace the coolant system cap and
tighten both caps completely.
%*
[SV22100(ALL)11/94]
Checking hoses
*
[SV22200(ALL)01/89]
Check all engine and heater system hoses and
hose connections for deterioration, leaks, and
loose hose clamps as specified in the
maintenance schedule. Repair or replace with
Motorcraft hoses or equivalent as necessary.
%
*
[SV22300(ALL)03/95]
Windshield Washer Fluid and
Wipers
*
[SV22350(ALL)03/95]
Washer Fluid
[SV22500(ALL)01/95]
Check the level of the windshield washer fluid
every time you stop for fuel. The reservoir for
the windshield washer fluid is located in the
engine compartment. Visual inspection can
determine if the washer fluid is adequate. Do
not operate the washer when the reservoir is
empty.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

247
*
[SV32800(ALL)03/95]
Power Steering Fluid
*
[SV32900(ALL)01/95]
Check the level of the power steering fluid at
least twice a year (i.e., every Spring and Fall).
*
[SV33000(ALL)03/95]
Checking and Adding Power Steering
Fluid
*
[SV33100(ALL)02/95]
1. Start the engine and let it run until the
power steering fluid reaches normal
operating temperature. The power steering
fluid will be at the right temperature when
the engine coolant temperature gauge in the
instrument cluster is near the center of the
NORMAL operating temperature range.
*
[SV33200(ALL)01/95]
2. While the engine idles, turn the steering
wheel back and forth several times. Make
sure that the cap assembly is installed at this
time.
*
[SV33300(ALL)01/95]
3. Turn the engine off and check the level on
the power steering reservoir.
[SV33550(ALL)08/91]
one third page art:0032043-A
Where to check for power steering fluid
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995