1996 FORD EXPLORER radio

67
Starting Your Explorer
*
[ST01700(ALL)03/95]
Ignition
%*
[ST01800(ALL)01/95]
Understanding the Positions of the Ignition
[ST02000(ALL)04/94]
7-1/2 pica art:0021143-A
The positions of the key in the ignition lock cylinder.
%*
[ST02201(ALL)07/95]
ACCESSORY allows some of your vehicle's electrical accessories
such as the radio and the windshield wipers to operate while
the engine is not running.
*
[ST02301(ALL)01/95]
In order to turn the key from the ON or OFF position to the
ACCESSORY position, you must push the key release button if
your vehicle's manual transmission gearshift is mounted on the
floor.
*
[ST02401(ALL)08/95]
LOCK locks the steering wheel and gearshift lever.
*
[ST02501(ALL)05/95]
RWARNING
Turn the key to LOCK whenever you leave your vehicle.
Always set the parking brake fully and make sure that
the gearshift is securely latched in P (Park) (automatic
transmission) or in 1 (First) (manual transmission). Never
leave your vehicle unattended while it is running.
*
[ST02651(ALL)01/95]
LOCK is the only position that allows you to remove the key.
The LOCK feature helps to protect your vehicle from theft.
*
[ST02701(ALL)05/95]
If your key is stuck in the LOCK position and will not turn,
move your steering wheel left or right until the key turns freely.
File:04unstx.ex
Update:Thu Feb 29 09:22:05 1996

84
[LG04450(ALL)10/94]
Door Ajar Warning Light (If equipped)
*
[LG04460(ALL)08/94]
If the ignition switch is in the ON position and any door or the
liftgate is not completely closed, the light will illuminate.
[LG04480(ALL)10/94]
7-1/2 pica art:0021269-A
Door ajar warning light symbol
%*
[LG04500(ALL)03/95]
Check Engine Warning Light
*
[LG04600(ALL)05/95]
The Powertrain On-Board Diagnostic II (OBD II) system consists
of the hardware and software necessary to monitor the
operation of the powertrain. The OBD II system is designed to
check the function of the vehicle's powertrain control system
during normal operation. If an emission problem is detected, the
Check Engine Warning Light (in the cluster) is turned on.
*
[LG04650(ALL)05/95]
Modification or additions to the vehicle may cause incorrect
operation of the OBD II system. Additions such as burglar
alarms, cellular phones, and CB radios must be carefully
installed. Do not install these devices by tapping into or running
wires close to powertrain control system wires or components.
[LG04675(ALL)02/95]
The light comes on briefly when you turn the ignition key to
the ON position, but it should turn off when the engine cranks.
If the light does not come on when you turn the ignition to the
ON position or if it comes on and stays on when you are
driving, have your vehicle serviced as soon as conveniently
possible. This indicates a possible problem with one of the
engine's emission control systems.You do not need to have
your vehicle towed in.
File:05unlgx.ex
Update:Thu Feb 29 09:04:08 1996

110
[IP00400( X)03/95]
The main controls for the climate control system, lights, message
center, lamps, clocks and radio are on the instrument panel.
%*
[IP00475(ALL)09/95]
NOTE: Any cleaner or polish that increases the gloss (shine)
of the upper part of the instrument panel should be
avoided. The dull finish in this area is to help protect
the driver from undesirable windshield reflection.
%*
[IP00500(ALL)06/95]
The Climate Control Systems
*
[IP00601(ALL)12/91]
Your vehicle is equipped with a control assembly designed to
handle either a combination A/C-Heater System or a
Heater-Only System.
%*
[IP00801(ALL)10/93]
Instrument Panel Registers
*
[IP00901(ALL)02/95]
There are four registers in the instrument panel. Each of these
registers contains a louver assembly which can be manually
adjusted to direct airflow up, down, left and right. An
illustration of the register locations follows.
[IP01201(ALL)04/94]
7-1/2 pica art:0020099-D
Instrument panel registers
[IP01400(ALL)12/91]
Air Conditioning (A/C) Controls (Manual Air
Conditioning)
*
[IP01450(ALL)02/95]
The control for your air conditioning and heater system is
located at the center of the instrument panel below the radio
and will operate only when the ignition key is turned to the
ON position. Your air conditioner and heater will heat and/or
cool your vehicle interior depending on the function position
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

114
*
[IP02550(ALL)04/95]
Operating tips
*
[IP02600(ALL)02/95]
The following tips will help you to get the most satisfaction
from your air conditioning and heater system.
[IP02650(ALL)03/95]
n
In humid weather, selectVbefore starting your engine.
This will help to prevent windshield fogging. After a few
minutes of operation, you may select another function.
[IP02700(ALL)03/95]
n
To prevent humidity buildup inside your vehicle, always
drive with the air conditioner or heater system turned on.
*
[IP02750(ALL)03/95]
n
Do not put objects under the front seats that interfere with
the flow of air to the back seat area.
[IP02800(ALL)03/95]
n
Remove any snow, ice, or leaves from the air intake area of
your air conditioner and heater system that could block the
air intake. The intake area is located at the bottom of the
windshield.
[IP04500( X)03/95]
Electronic Automatic Temperature Control
(If equipped)
[IP04600( X)03/95]
The control for your Electronic Automatic Temperature Control
(EATC) is located at the center of the instrument panel below
the radio and will operate only when the ignition key is turned
on to the ON position.
[IP04700( X)03/95]
The EATC feature will maintain the temperature you select and
automatically control the airflow for your comfort. It also allows
you to override the automatic operation with manual override
buttons.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

126
%*
[IP12300( X)06/95]
Rear Window Defroster (If equipped)
*
[IP12400( X)12/91]
The defroster for the rear window clears frost, fog, or thin ice
from both the inside and outside of the rear window.
[IP12500( X)10/94]
The control switch is located on the instrument panel to the
right of the radio.
[IP12700( X)08/94]
7-1/2 pica art:0020110-H
Rear window defroster switch
*
[IP12800( X)02/95]
To defrost the rear window:
*
[IP12900( X)02/95]1.
Clear any snow from the rear window.
*
[IP13000( X)09/93]2.
Get in your vehicle and start the engine.
[IP13200( X)06/94]3.
Push the switch and release. The indicator light turns on.
Push switch again to turn off.
*
[IP13300( X)02/05]
The defroster turns off automatically after approximately 10
minutes. If the window is not clear, turn on the defroster again.
It will also automatically shut off any time the engine is shut
off.
%*
[IP13400( X)09/95]
NOTE: Never use sharp instruments or window cleaners with
abrasives to clean the inside of your rear window. If
you do, you may damage the heating elements that
are bonded to the inside of the rear window and
cause damage to the rear window defroster.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

Instrument Panel Controls
127
[IP15800( X)10/94]
Liftgate Wiper and Washer (If equipped)
[IP15901( X)10/94]
The wiper/washer switch is to the right of the radio. To turn on
the wiper, rotate the wiper/washer switch to the WIPE position.
To select an interval wipe rotate switch between OFF and HI.
To turn on the washer, push the switch all the way in and hold
for spray. Release the button and the spray stops, but the wiper
continues to operate. To turn off the wiper, rotate the switch to
the OFF position.
[IP15950( X)12/92]
For information about refilling the liftgate washer fluid or
replacing your liftgate wiper blade, seeWindshield washer fluid
andWindshield wipersin the Index.
[IP16000( X)05/95]
7-1/2 pica art:0090189-A
Liftgate wiper/washer button
%*
[IP16800(ALL)01/95]
The Interior and Exterior Lights
%*
[IP16900(ALL)01/95]
Turning On the Exterior Lights
*
[IP17000(ALL)09/95]
To turn on your headlamps, parking lamps, marker lamps,
license plate lamps and tail lamps, use the headlamp control
knob to the left of the steering column.
[IP17100(ALL)09/95]1.
Rotate the headlamp control knob to the first position.
Parking lamps, tail lamps, license plate lamps and marker
lamps are now on.
[IP17200(ALL)06/94]2.
Rotate the headlamp control knob to the next position.
Headlamps are now on in addition to the above.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

Instrument Panel Controls
131
*
[IP17660( X)12/93]
n
The further you move the slide knob toward the right, the
longer the headlamps stay on after you leave your vehicle.
Similarly, if you move the slide knob only slightly toward
the left, the headlamps stay on for only a moment after you
turn your vehicle off.
%*
[IP17715(ALL)04/95]
Fog Lamps (If equipped)
[IP17725(ALL)03/95]
The fog lamps switch is located on the instrument panel to the
right of the radio and climate control.
[IP17730(ALL)05/95]
n
To turn the fog lamps on, turn on the low-beam headlamps,
then push the fog lamp switch. An indicator light will glow
when the lamps are on.
*
[IP17735(ALL)10/94]
n
To turn off, push the switch again.
[IP17750(ALL)05/95]
7-1/2 pica art:0090191-A
Fog lamp switch
*
[IP17760(ALL)02/93]
The fog lamps act as a supplement to the low beam headlamps
under limited visibility conditions such as rain, snow, dust or
fog and operate only when the low beam headlamps are on.
*
[IP17770(ALL)02/93]
To maximize fog lamp bulb life it is recommended that the fog
lamp switch be turned off after each use prior to turning off the
headlamps.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

134
[IP19875( X)09/95]
10-1/2 pica
art:0020975-B
Map lamps (if equipped)
%*
[IP19900( X)10/94]
High-mount Brakelamp
[IP19910( X)10/94]
The high-mount brakelamp is located outside the vehicle,
directly over the rear window.
[IP19920( X)10/94]
10-1/2 pica art:0021015-E
High-mount brakelamp
*
[IP20300(ALL)04/95]
Clock Controls on Electronic Radios
[IP20400(ALL)10/94]
The electronic radios have a built-in clock. For complete
operating instructions, refer toElectronic Sound Systemsin this
Owner Guide.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996