1996 FORD EXPLORER gas type

Driving Your Explorer
289
%*
[DR36600(ALL)01/93]
Hitches
*
[DR36800(ALL)12/91]
Do not install a single or multi-clamp type bumper hitch, or a
hitch which attaches to the axle. Underbody mounted hitches
are acceptable if installed properly. Follow towing instructions
of a reputable rental agency.
*
[DR37000(ALL)12/92]
Whenever a trailer hitch and hardware are removed, make sure
all mounting holes in the underbody are properly sealed to
prevent noxious gases or water from entering.
[DR37100( X)01/95]
Trailer tow/step bumper
[DR37150( X)03/93]
The rear bumper has an integral hitch and only requires a ball
with a 3/4 inch shank diameter. The bumper has a Class II
capability (3500 lb/1590 kg trailer weight and 350 lb/159 kg
tongue weight).
[DR37250( X)01/95]
Use a frame mounted weight distributing hitch for trailers over
3,500 lb. (1590 kg).
*
[DR37550(ALL)03/91]
NOTE: The rated capacities (as shown in this guide) for
trailer towing with the factory bumper are only valid
when the trailer hitch ball is installed directly into the
ball hole in the bumper. Addition of bracketry to
either lower the hitch ball position or extend the hitch
ball rearward will significantly increase the loads on
the bumper and its attachments. This can result in the
failure of the bumper or the bumper attachments. Use
of any type of hitch extensions should be considered
abuse.
*
[DR37575(ALL)03/91]
If it is necessary to relocate the trailer hitch ball position a
frame mounted trailer hitch must be installed.
File:10undrx.ex
Update:Thu Feb 29 09:12:36 1996