1996 FORD ESCORT switch

17 [SR05050(ALL)06/94]
half page art:0070260-A
Label located on headliner (U.S. vehicles only)
[SR05150(ALL)06/94]
An additional warning label is located on the
headliner (U.S. vehicles only). On vehicles
equipped with a moon roof, the label is located
on the manual override access panel.
[SR05200(ALL)04/90]
What To Do If Your Shoulder Belt Does
Not Engage Properly
[SR05300(ALL)02/95]
If your shoulder belt does not move all the way
across to the locked position on the B-pillar,
follow these steps:
[SR05400(ALL)02/95]
1. Make sure the ignition switch is in the
LOCK position.
[SR05500(ALL)03/91]
2. Make sure your door is fully closed. The
shoulder belt does not work if your door is
open and will remain in the forward
position at the A-pillar.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

18 [SR05600(ALL)05/95]
RWARNING
The vehicle should not be driven unless
the doors are fully closed and the
shoulder belts are in the locked position.
[SR05700(ALL)10/89]
3. Unbuckle the shoulder belt by pressing the
red emergency release button on the buckle.
Then, reinsert the shoulder belt tongue into
the buckle until you hear a snap and feel the
latch engage.
[SR05800(ALL)02/95]
4. Turn the key to the ON position.
[SR05900(ALL)10/89]
5. If the shoulder belt doesn't move across you,
turn the ignition switch to the LOCK
position and then release the shoulder belt
from the buckle.
[SR06000(ALL)10/89]
6. Remove the access cap located in the lower
portion of the trim panel, rearward of the
front door opening.
[SR06100(ALL)12/89]
7. Pull the electrical wiring harness out through
the access hole and disconnect the connector.
The electrical wiring harness is located near
the internal hex nut. To disconnect the
connector, pull the left and right sides apart.
You may have to loosen the tape to
disconnect the electrical connector.
[SR06200(ALL)10/91]
8. Then, insert the emergency handle into the
hex nut inside the access hole. The
emergency handle is stored in the owner
portfolio in the glove compartment.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

25 %
*
[SR07625(ALL)08/95]
Automatic locking mode
*
[SR07630(ALL)06/95]
In this operating mode, the lap belt retractor will
remain locked and does not allow the occupant
freedom of movement. This mode provides the
following:
[SR07635(ALL)03/95]
q
A tight lap belt on the hips.
[SR07640(ALL)06/95]
q
Forward-facing child seat installation.
*
[SR07641(ALL)09/95]
RWARNING
Rear-facing infant seats should never be
placed in the front seat.
[SR07645(ALL)01/95]
This modemust be usedwhen installing a
forward-facing child seat on the front passenger
seat. To switch the retractor from the emergency
locking mode, perform the following steps:
[SR07650(ALL)01/95]
1. Buckle the lap belt.
[SR07655(ALL)01/95]
2. Grasp the lap belt below the child seat label.
Pull upward until all of the belt is extracted
and a click is heard. At this time, the lap
belt retractor is in the automatic locking
mode (child restraint mode).
*
[SR07660(ALL)07/95]
3. A clicking sound will contnue to be heard as
the belt is allowed to retract.
*
[SR07665(ALL)03/95]
4. Pull down on the belt to remove slack in the
belt.
[SR07670(ALL)01/95]
NOTE: When the lap belt is unbuckled and
allowed to retract completely, the
retractor will switch to the vehicle
sensitive (emergency) locking mode.
See the detailed instructions under
Safety Seats for Childrenin this
chapter.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

27 [SR08200(ALL)06/94]
If your shoulder belts stop working after a
collision, the fuel pump shut-off switch may
have been triggered. Minor parking lot bumping
and severe road impacts (such as potholes) may
trigger the switch even when there is no
apparent body damage. In many instances, you
might not even know that the switch has been
triggered. The shut-off switch cuts power to the
motors that move the shoulder belts in addition
to stopping the flow of fuel to the engine. To
reset the switch, seeEngine, starting after a
collisionin the Index.
[SR08300(ALL)04/93]
If your shoulder belts are not working properly,
get your vehicle serviced as soon as possible.
[SR08400(ALL)04/93]
If the fuel pump shut-off switch is not the cause
for the shoulder belt not moving, have the
system serviced by a qualified technician as soon
as possible.
[SR08450(ALL)04/91]
RWARNING
If the shoulder belt is released from the
emergency release buckle, store the tongue
end away from the seat tracks. Failure to
do this may result in the seat belt being
cut or torn when the seat is adjusted
forward or back. Any damaged shoulder
belt must be replaced.
[SR08500(E )07/93]
Manual Front Lap and Shoulder Belt
(Available only on Canadian vehicles)
[SR08580(E )08/95]
While in motion, the combination lap and
shoulder belt adjusts to your movement.
However, if you brake hard, turn hard, or if
your vehicle receives an impact of 5 mph
(8 km/h) or more, the lap and shoulder belt
locks and helps reduce your forward movement.
The retractor can be made to lock by jerking on
the belt.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

31 [SR08885(E )08/95]
This mode must be used when installing a
forward-facing child safety seat on the front
passenger seat. To switch the retractor from the
emergency locking mode to the automatic
locking mode, perform the following steps:
*
[SR08890(E )08/95]
1. Buckle the lap/shoulder combination belt.
*
[SR08895(E )08/95]
2. Grasp the shoulder portion of the belt and
pull downward until all of the belt is
extracted, and when allowed to retract, a
clicking sound will be heard. At this time,
the belt retractor is in the automatic locking
mode (child restraint mode).
*
[SR08900(E )08/95]
3. A clicking sound will continue to be heard
as the belt is allowed to retract. This
indicates that the retractor is in the
automatic locking mode.
[SR08905(E )08/95]
NOTE: When the combination lap/shoulder
belt is unbuckled and allowed to
retract completely, the retractor will
switch back to the vehicle sensitive
(emergency) locking mode. See the
detailed instructions underSafety Seats
for Childrenin this chapter.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

34
*
[SR08965(E )08/95]
Vehicle sensitive (emergency) locking mode
[SR08970(E )06/95]
In this operating mode, the lap belt retractor will
allow the occupant freedom of movement,
locking tight only on hard braking, hard
cornering or impacts of approximately 5 mph
(8 km/h) or more. The retractor can be made to
lock by jerking on the belt.
%*
[SR08975(E )08/95]
Automatic locking mode
*
[SR08980(E )06/95]
In this operating mode, the lap belt retractor will
remain locked and does not allow the occupant
freedom of movement. This mode provides the
following:
[SR08985(E )06/95]
q
A tight lap belt on the hips
[SR08990(E )06/95]
q
Forward-facing child seat installation.
*
[SR09000(E )09/95]
RWARNING
Rear-facing infant seats should never be
placed in the front seat.
[SR09005(E )06/95]
This modemust be usedwhen installing a
forward-facing child seat on the front passenger
seat. To switch the retractor from the emergency
locking mode to the automatic locking mode,
perform the following steps:
*
[SR09010(E )08/95]
1. Buckle the lap/shoulder combination belt.
*
[SR09015(E )06/95]
2. Grasp the lap portion of the belt below the
child seat label. Pull upward until all of the
belt is extracted and a click is heard. At this
time, the lap belt retractor is in the
automatic locking mode (child restraint
mode).
*
[SR09020(E )07/95]
3. A clicking sound will contnue to be heard as
the belt is allowed to retract.
[SR09025(E )06/95]
4. Push down on the child seat while you pull
down on the belt to remove slack in the belt.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

35
*
[SR09030(E )08/95]
NOTE: When the combination lap/shoulder
belt is unbuckled and allowed to
retract completely, the retractor will
switch to the vehicle sensitive
(emergency) locking mode. See the
detailed instructions underSafety Seats
for Childrenin this chapter.
[SR09600(E )03/91]
half page art:0000923-B
Combination lap and shoulder belt with a fixed tongue
(available only on Canadian vehicles)
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

72 [SR17100(ALL)09/95]
half page art:0070210-CChecking that the seat is secure
[SR17105(ALL)01/95]
7. Double check that the retractor is in the
automatic locking mode. Try to pull more
belt out of the retractor, if you cannot, the
belt is in the automatic locking mode.
[SR17110(ALL)01/95]
8. Check to make sure that the child seat is
properly secured prior to each use. If the lap
belt is not locked, repeat steps 4 through 7.
[SR17115(ALL)09/95]
NOTE: When the safety belt is unbuckled and
allowed to retract completely, the
retractor will switch to the vehicle
sensitive (emergency) locking mode.
See the detailed instructions under
Front Passenger Lap Belt Retractorin
this chapter.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995