1996 FORD ESCORT manual radio set

106 [ST03615(ALL)08/95]The automatic transaxle console-mounted
gearshift will lock only when you turn the key
to LOCK. When the gearshift is in any gear
position but P (Park), the ignition key cannot be
turned to LOCK or be removed from the
steering column.
[ST03620(ALL)02/95]
If you have a manual transaxle, you must push
the key in while turning to the LOCK position
in order to remove the key.
*
[ST03625(ALL)01/95]
LOCK is the only position that allows you to
remove the key. The LOCK feature helps to
protect your vehicle from theft.
[ST03635(ALL)09/95]
OFF (if equipped) allows you to shut off the
engine and all accessories without locking the
steering wheel.
*
[ST03650(ALL)07/95]
ACC (accessory) allows some of your vehicle's
electrical accessories such as the radio and the
windshield wipers to operate while the engine is
not running.
[ST03850(ALL)02/95]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
make sure they work before you start the
engine. (The brake system warning light will
remain lit if the parking brake is set or if there
is a problem with the brake system.) The key
returns to the ON position once the engine is
started and remains in this position while the
engine runs.
[ST03900(ALL)02/95]
START cranks the engine. Release the key once
the engine starts so that you do not damage the
starter. The key should return to ON when you
release it. The START position also allows you
to test the brake system warning light.
File:04ctste.ex
Update:Tue Sep 19 14:42:54 1995

199 %
*
[AS01900(ALL)08/95]
How to tune radio stations
*
[AS02000(ALL)08/95]
There are four ways for you to tune in a
particular station. You can manually locate the
station using the ªSCAN/TUNEº button,
ªSEEKº the station, ªSCANº to the station or
select the station by using the memory buttons,
which you can set to any desired frequency.
These four methods are described below.
*
[AS02100(ALL)08/95]
q
Using the ªSCAN/TUNEº button to manually
tune
*
[AS02200(ALL)08/95]
You can change the frequency up or down
one increment at a time (FM changes in
increments of 200kHz; AM changes in
increments of 10kHz) by first pressing the
ªSCAN/TUNEº button twice (display shows
ªTUNEº), then Ðwithin approximately five
secondsÐpressing and releasing either the
top
aor bottom
bhalf of the ªSEEKº
button. To change frequencies quickly, press
andhold downeither the top or bottom half
of the ªSEEKº button. While you are
manually tuning, the display will show a
blinking ªMº.
*
[AS02300(ALL)08/95]
Manual tuning adjusts your radio to any
allowable broadcast frequency, whether or
not a station is present on that frequency.
(SeeAll About Radio Frequenciesin this
section.)
*
[AS02400(ALL)08/95]
q
Using the ªSEEKº function
*
[AS02500(ALL)08/95]
This feature on your radio allows you to
automatically select listenable stations up or
down the frequency band. Press the top
a
half of the ªSEEKº button to select the next
listenable station up the frequency band.
Press the bottom
bhalf of the button to
select the next listenable station down the
frequency band. By pressing and holding the
button, listenable stations can be passed over
to reach the desired station.
File:09ctase.ex
Update:Tue Sep 19 14:51:59 1995

201
*
[AS03515(ALL)08/95]
q
Using the Automatic Memory Load feature
*
[AS03520(ALL)03/95]
If no stations are in memory preset, you can
activate theAuto Memory Loadfeature by
pressing and holding the ªAUTO PRESETº
buttonfor approximately three seconds.
Auto Memory Load sets all memory buttons
in AM, FM1 and FM2 sequentially by seeking
out the first six strong stations for the
respective band and storing them in memory
buttons 1-5. (FM2 will store the second set of
strong stations from the FM band.)
*
[AS03525(ALL)08/95]
With Auto Memory Store, you can
continually set strong stations into your
memory buttons without losing your existing
memory presets, which is especially handy
while traveling. Your radio will automatically
set your memory buttons to the strong local
stations so you don't have to continually
manually tune to existing stations.
*
[AS03530(ALL)08/95]
Activate Auto Memory Store by pushing the
ªAUTO PRESETº button once. Your radio
will set the first five strong stations of the
band you are in (AM, FM1 or FM2) into the
memory buttons. The display will show
ªAUTO,º then run through the frequencies,
stopping momentarily on the stations being
set into the memory buttons. The radio is
now in the ªAUTOº mode and the display
will show ªAUTOº each time a preset is
activated.
*
[AS03535(ALL)08/95]
NOTE: If there are fewer than five strong
stations in the frequency band, the
remaining unfilled buttons will store
the last strong station detected on the
band.
File:09ctase.ex
Update:Tue Sep 19 14:51:59 1995

202
*
[AS03540(ALL)08/95]
After all stations have been filled, the radio
will begin playing the station stored on
memory button 1.
*
[AS03545(ALL)08/95]
To deactivate the Auto Memory Store mode
and return to the manually-set memory
button stations (or those stations set using
Auto Memory Load), simply push the
ªAUTO PRESETº button. Display will show
ªAUTOº then ªOFF.º The next time Auto
Memory Store is activated on that band, the
radio will store the next set of five strong
stations.
*
[AS04400(ALL)08/95]
Using the ªAUDIOº button to adjust the
tone balance and speaker output
*
[AS04500(ALL)08/95]
q
Increasing or decreasing bass response
*
[AS04600(ALL)08/95]
Push the ªAUDIOº button repeatedly until
the display reads ªBASS.º Push the ª+º side
of the ªVOLº button to increase bass (more
ªlowsº), and push the ª-º side to decrease
bass (less ªlowsº).
*
[AS04700(ALL)08/95]
q
Increasing or decreasing treble response
*
[AS04800(ALL)08/95]
Push the ªAUDIOº button repeatedly until
the display reads ªTREB.º Push the ª+º side
of the ªVOLº button to increase treble (more
ªhighsº), and push the ª-º side to decrease
treble (less ªhighsº).
*
[AS05050(ALL)08/95]
q
Adjusting speaker balance
*
[AS05100(ALL)08/95]
Balance control allows you to adjust the
sound distribution between the right and left
speakers. Push the ªAUDIOº button
repeatedly until the display reads ªBAL.º
Push the ª+º side of the ªVOLº button to
shift the sound to the right speakers, and
push the ª-º side to shift the sound to the
left speakers.
File:09ctase.ex
Update:Tue Sep 19 14:51:59 1995

213
%*
[AS21905(ALL)08/95]
Electronic Stereo and Stereo
Cassette Radios
*
[AS21910(ALL)08/95]
Using the Controls on Your New Radio
*
[AS21915(ALL)08/95]
How to turn the radio on and adjust the
volume
*
[AS21920(ALL)08/95]
Press the ªPOWERº button to turn the radio on.
Press it again to turn it off.
*
[AS22050(ALL)04/94]
Press the right (+) side of the ªVOLUMEº
button to increase the volume. Press the left (-)
side of the button to decrease the volume.
Illuminated bars in the display show the relative
volume level.
*
[AS22100(ALL)08/95]
Selecting the AM or FM frequency band
*
[AS22210(ALL)07/95]
Push the ªAM/FMº button to select the desired
frequency band. Pushing the button more than
once will alternate between AM, FM1 and FM2.
These functions are used with the station
memory buttons described underHow to tune
radio stations.
*
[AS22300(ALL)08/95]
How to tune radio stations (Stereo Radio)
*
[AS22400(ALL)08/95]
There are three ways for you to tune in to a
particular station. You can manually locate the
station by using the ªTUNEº button, ªSEEKº the
station or select the station by using the memory
preset buttons, which you can set to any desired
frequency.
File:09ctase.ex
Update:Tue Sep 19 14:51:59 1995

214 %
*
[AS22450(ALL)08/95]
How to tune radio stations (Stereo Cassette
Radio)
*
[AS22475(ALL)08/95]
There are four ways for you to tune in to a
particular station. You can manually locate the
station by using Automatic Music Search
(ªAMSº), ªSEEKº the station, ªSCANº to the
station or select the station by using the memory
buttons, which you can set to any desired
frequency.
*
[AS22500(ALL)09/95]
q
Using the ªTUNEº function (Stereo Radio)
*
[AS22600(ALL)08/95]
You can change the frequency up or down
one increment at a time by pressing and
releasing either the right (+) or left (S) side
of the ªTUNEº button. To change frequencies
quickly, press and hold down either the right
or left side of the ªTUNEº button.
*
[AS22650(ALL)08/95]
q
Using the ªAMSº function to manually tune
your radio (Stereo Cassette Radio)
*
[AS22675(ALL)08/95]
You can change the frequency up or down
one increment at a time by first pressing the
ªAMSº button (display shows ªTUNEº) then
within approximately five seconds pressing
and releasing either the right
aor left
b
side of the ªSEEKº button. To change
frequencies quickly, press andhold down
either the right or left side of the ªSEEKº
button.
*
[AS22700(ALL)08/95]
Manual tuning adjusts your radio to any
allowable broadcast frequency, whether or
not a station is present on that frequency.
(SeeAll About Radio Frequenciesin this
section.)
File:09ctase.ex
Update:Tue Sep 19 14:51:59 1995