1996 FORD E SERIES air condition

32
*
[SR12200(BEF )06/95]
The air bag system uses a readiness light on the
instrument cluster or a tone to indicate the
condition of the system. When you turn the
ignition to the ON position, this light will
illuminate for approximately six (6) seconds and
then turn off. This indicates that the system is
operating normally.NOTE:Maintenance of the
air bag system is not required.
*
[SR12300(BEF )05/95]
A problem with the system is indicated by one
or more of the following: the readiness light will
either flash or stay lit, or it will not light, or a
group of five beeps will be heard.
*
[SR12360(BEF )05/95]
RWARNING
If any of these things happen, even
intermittently, have the air bag system
serviced at your Ford or Lincoln-Mercury
dealer immediately.
%*
[SR12400(BEF )03/95]
Tone generator
*
[SR12500(BEF )03/95]
The air bag readiness light indicates the air bag
system condition. However, a series of five sets
of five beeps will be heard only if the readiness
light does not work and there is a problem with
the air bag system. This also means that the Air
Bag Supplemental Restraint System (SRS) is in
need of service. The tone pattern will repeat
(five sets of five beeps) periodically until the
problem and light are repaired. Unless serviced,
the Air Bag Supplemental Restraint System may
not function properly in the event of a collision.
*
[SR12600(BEF )05/95]
RWARNING
Do not attempt to service, repair, or
modify the Air Bag Supplemental
Restraint System or its fuses. See your
Ford or Lincoln-Mercury dealer.
File:03ltsre.ex
Update:Wed Apr 17 08:51:22 1996

66
*
[ST09900( ALL)01/95]
Have the exhaust and body ventilation systems
checked whenever:
*
[ST10000( ALL)02/95]
q
your vehicle is raised for service
*
[ST10100( ALL)02/95]
q
the sound of the exhaust system changes
*
[ST10200( ALL)01/95]
q
your vehicle has been damaged in a collision
*
[ST10300( ALL)01/95]
Improve your ventilation by keeping all air inlet
vents clear of snow, leaves, and other debris.
*
[ST10400( ALL)03/95]
If the engine is idling while you are stopped in
an open area for long periods of time, open the
windows at least one inch (2.5 cm). Also, adjust
the heating or air conditioning to bring in
outside air.
[ST10500( E )03/91]
q
HEATING Ð Set fan speed on MEDIUM or
HIGH, with the function control lever on
FLOOR, DEFROST or VENT and the
temperature control lever on any desired
position.
[ST10700( E )03/91]
q
AIR CONDITIONING Ð Set fan speed on
MEDIUM or HIGH with the function control
lever on any position (except OFF or MAX)
and the temperature control lever at a
comfortable level.
File:04ltste.ex
Update:Wed Apr 17 08:49:38 1996

87 [IP01765( E )05/94]
Operational Air Conditioner and Heater
[IP01770( E )05/94]
The control for your Air Conditioning and
Heater system is located at the center of the
instrument panel and will operate only when the
ignition key is turned to the RUN position. Your
Air Conditioner & Heater will heat and/or cool
your vehicle interior depending on the Function
lever position and temperature you select. The
bottom lever is the Function Selector lever which
allows you to select heating or cooling and
determine where the air will be directed. The
top lever is the Temperature lever. The setting
or position of the top lever determines the
temperature of the air that flows into the
vehicle.
[IP01775( E )05/94]
quarter page art:0020984-A
Front and Rear A/C and Heater (Main and Auxiliary
system)
[IP01780( E )05/94]
quarter page art:0020985-A
A/C and Heater, front - Heater only, rear
File:06ltipe.ex
Update:Wed Apr 17 08:48:31 1996

88 [IP01785( E )04/95]To turn your Air Conditioner & Heater system
on, move the lower lever to any position except
OFF. This will turn the fan ON and allow air
flow into the vehicle. To turn your Air
Conditioner & Heater off, move the lower lever
to OFF. This will turn the fan off and stop air
flow from coming into the vehicle.
*
[IP01790( E )03/95]
Temperature selection
[IP01795( E )05/94]
The temperature lever is the top lever located
below the broken RED and BLUE band. The
RED part of the band (right side) is the heat or
WARM area. The BLUE area (left side) is the
cooling or COOL temperature area. Any position
selected between full right and full left will give
a temperature between the two extreme
temperatures.
[IP01800( E )04/95]
HFan speed adjustment
[IP01805( E )05/95]
The
Hknob (upper left) on the control is the
fan speed knob which controls the volume of air
flow. Rotate the
Hknob to the right to increase
fan speed and increase the amount of air
entering the vehicle. Four fan speed positions are
available and are indicated by LO, two separate
dots and HI beside the
Hcontrol knob. The HI
position provides the most air flow.
[IP01810( E )05/94]
Airflow selections (lower lever)
*
[IP01815( E )03/95]
VENT
[IP01820( E )05/94]
UseVENTto bring outside air through the
instrument panel registers. You can heat the air
in this position by moving the top lever into the
RED area. The air CANNOT be cooled below
the outside temperature regardless of the top
lever setting. SelectNORMAL A/CorMAX A/C
to get cooled air through the instrument panel
registers.
File:06ltipe.ex
Update:Wed Apr 17 08:48:31 1996

90 [IP01865( E )04/95]VDEFROST
[IP01870( E )05/95]
SelectVDEFROSTto obtain maximum air
flow to the windshield. Move the top lever into
the RED area for the air temperature required to
defrost. When the outside temperature is about
50ÊF (9ÊC) orwarmer, the air will be
dehumidified to remove moisture. The air can be
cooled or heated. Rotate the
Hknob to increase
the air flow.
*
[IP01875( E )05/94]
Operating Tips
*
[IP01880( E )02/95]
The following tips help you get the most
satisfaction from your air conditioner and heater
system:
[IP01885( E )04/95]
q
In humid weather, selectVDEFROST. This
will help to prevent windshield fogging. After
a few minutes of operation, you may select
another air flow position.
*
[IP01890( E )02/95]
q
To prevent humidity buildup inside your
vehicle, always drive with the air conditioner
and heater system turned on.
[IP01895( E )05/94]
q
Do not put objects under the front seats
unless your vehicle is equipped with an
underseat storage tray. Improperly stored
objects will interfere with the flow of air
under the seats to the back seat area.
[IP01899( E )05/95]
q
Remove any snow, ice, or leaves from the air
intake area of your Air Conditioner and
Heater System which could block the air
intake. The intake area is located at the
bottom of the windshield.
File:06ltipe.ex
Update:Wed Apr 17 08:48:31 1996

91
%*
[IP04010( E )12/91]
Auxiliary Heater and Air
Conditioner (If equipped)
*
[IP04020( E )03/93]
If your vehicle is equipped with a factory
installed auxiliary unit (heater or heater/air
conditioner), the front control assembly will
include separate switches for FRONT and REAR
fan control. Fan speed for front and rear systems
can be set as desired by adjusting these switches.
[IP04050( E )03/93]
In addition, on vehicles equipped with auxiliary
A/C, an auxiliary unit fan switch is located in
the headliner at a location between the front and
rear seats.
[IP04055( E )03/93]
q
To control the auxiliary fan with this switch,
the rear fan switch on the front control must
be in the REAR CONTROL position.
[IP04060( E )03/93]
NOTE: The air flow from the auxiliary unit is
discharged from the headliner
registers (if so equipped) or the A/C
register (untrimmed vehicles) when
front control selector is in MAX A/C,
NORM A/C and VENT only, and from
floor registers when front control is in
FLOOR FLR/DEF and DEF only.
[IP04065( E )03/93]
q
The auxiliary unit does not provide for
mixing of hot and cold air; adjustment of
temperature in the rear may be accomplished
by increasing or decreasing the rear fan
speed.
File:06ltipe.ex
Update:Wed Apr 17 08:48:31 1996

223
*
[DR30550( ALL)03/91]
Gross Vehicle Weight (GVW)
*
[DR30601( ALL)05/95]
If you add base curb weight and the weight of a
load (including passengers, cargo and optional
equipment) being carried at a particular time,
you get the Gross Vehicle Weight (GVW).
*
[DR30650( ALL)10/94]
It is important to remember that GVWis not a
limit or a specification.If an owner loads up a
vehicle and weighs it, that's the GVW at that
moment. If the owner piles on more of a load
and weighs it again, that becomes the
GVW...until such time as the vehicle is unloaded.
%*
[DR30701( ALL)03/91]
Gross Vehicle Weight Rating (GVWR)
*
[DR30750( ALL)10/94]
To avoid overloading a vehicle, the owner
should observe the manufacturer's specified
Gross Vehicle Weight Rating. The GVWR is the
maximum total weight of base vehicle,
passengers, optional components and cargo that
a particular vehicle was designed to carry.
%*
[DR30801( ALL)01/93]
Gross Axle Weight Rating (GAWR)
*
[DR30850( ALL)03/91]
We have all seen a car or a truck that is loaded
down in the rear and riding high in the front.
This is a dangerous condition that usually means
that the rear suspension components are under
severe strain and that vehicle handling is
impaired. There is more to carrying a load than
just payload or GVWR.
*
[DR30901( ALL)03/91]
Your Safety Compliance Certification Label not
only gives the GVWR, it also gives the Gross
Axle Weight Rating (GAWR) which is the
carrying capacity for each axle system. For
trucks, the rear axle will be designed to carry
more weight than the front.
File:10ltdre.ex
Update:Wed Apr 17 08:44:07 1996

241 [DR39700( E M)06/95]
When stopped in traffic for long periods of time
in hot weather, place the gearshift selector lever
in P (Park) to increase the engine idle speed.
This aids in engine cooling and air conditioner
efficiency. If the engine overheats, move the
Function Selector Lever to VENT to stop the
compressor and increase the engine speed for a
short time.
*
[DR39900( ALL)05/90]
Vehicles with trailers should not be parked on a
grade. However, if you must park on a grade,
place wheel chocks under the trailer's wheels as
follows:
*
[DR40000( ALL)05/95]
q
Apply the brake pedal and hold.
*
[DR40100( ALL)11/89]
q
Have another person place the wheel chocks
under the trailer wheels.
*
[DR40200( ALL)11/89]
q
With the chocks in place, release the foot
service brakes, making sure the chocks are
holding.
*
[DR40350( E M)03/91]
q
Apply the parking brake by pressing the
service brake pedal down firmly with your
right foot while applying the parking brake
pedal with your left foot.
*
[DR40575( E M)06/95]
q
Shift the gearshift lever into P (Park).
File:10ltdre.ex
Update:Wed Apr 17 08:44:07 1996