1996 FORD CROWN VICTORIA height adjustment

12 [SR04695( ALL)03/95]NOTE: When the combination lap/shoulder
belt is unbuckled and allowed to
retract completely, the retractor will
switch back to the vehicle sensitive
(emergency) locking mode. See the
detailed instructions underSafety Seats
for Childrenin this chapter.
%*
[SR04795( GV)05/95]
Shoulder Belt Height Adjustment
*
[SR04800( GV)04/95]
Driver and right front passenger
*
[SR04900( GV)01/95]
You can adjust the shoulder belt height to one of
five (5) positions. To adjust, pinch the release
button (see Figures 1 and 2) and slide it up or
down until the belt rests across the middle of
your shoulder. Release the button and make sure
the adjuster is firmly in one of the five (5)
positions.
*
[SR04940( GV)02/95]
RWARNING
If the shoulder belt is off your shoulder
or on your upper arm, there is a greater
risk of severe injury in a collision.
[SR04950( GV)12/94]
BE SURE THE BELT IS PROPERLY
POSITIONED ON YOUR SHOULDER EACH
TIME YOU USE THE BELT.
File:rcsrv.ex
Update:Wed Jan 31 10:17:50 1996

193
*
[DR21600( ALL)01/95]
Tie down the load so that it does not shift and
change the weight on the hitch. This will
prevent damage to your vehicle and make your
vehicle easier to handle.
[DR21607( V)05/95]
Hook-Up and Adjustment Procedure Ð
Load Equalizing Hitch (option available in
Canada only)
*
[DR21610( GV)01/95]
Your vehicle is equipped with a rear air
suspension system. When hooking up a trailer
using a load equalizing hitch, always use the
following procedure:
*
[DR21615( GV)01/95]
1. Place the unloaded vehicle on a level
surface. With the ignition on and all doors
closed, allow the vehicle to level
automatically (approximately one to two
minutes).
*
[DR21620( GV)01/95]
2. Turn the air suspension switch on the right
side of the trunk to OFF.
*
[DR21625( GV)01/95]
3. Measure the height of a reference point on
the front and rear bumpers at the center of
the vehicle.
*
[DR21630( GV)01/95]
4. Attach trailer to vehicle and adjust the hitch
equalizer(s) so that the front bumper height
is 0 to 1/2 inch below the unloaded height.
After adjustment, the rear bumper should be
no higher than in step 3.
*
[DR21635( GV)01/95]
5. Turn the air suspension switch ON.
*
[DR21640( GV)01/95]
RWARNING
Adjusting an equalizing hitch so the rear
bumper of the vehicle is lower or higher
than it was unloaded will defeat the
function of the load equalizing hitch and
may cause unpredictable handling.
File:rcdrv.ex
Update:Wed Jan 31 10:36:47 1996