1996 FORD CONTOUR headlamp

96
[FV02500(ALL)05/94]
When you use the remote entry UNLOCK, TRUNK or PANIC
buttons, the illuminated entry system turns on the interior
lights for 12 seconds. You can turn these lights off by turning
the ignition to the ON position. The interior lights will not turn
off if you have turned them on manually or if a door is open.
[FV02550(ALL)05/94]
NOTE: The illuminated entry system will only work when
the dome light switch is in the ª12º position.
*
[FV02600(ALL)02/95]
Locking the doors
*
[FV02700(ALL)02/95]
To lock all the doors, press the LOCK button.
*
[FV02800(ALL)01/95]
If you would like a signal that the doors are being locked, press
the LOCK button again within five seconds. The doors will lock
again, the horn will beep and the low beam headlamps and tail
lamps will flash.
%*
[FV02900(ALL)02/95]
Activating the remote personal alarm
[FV03000(ALL)04/94]
If you wish to activate the remote personal alarm, press the
PANIC button. This will honk the horn and flash the low beam
headlamps and tail lamps for approximately two minutes
forty-five seconds. You can turn it off by pressing the PANIC
button again on the same transmitter or by turning the ignition
key to the ON position.
%*
[FV03100(ALL)02/95]
Replacing the batteries
*
[FV03200(ALL)02/95]
The remote entry transmitter is powered by two coin type
three-volt lithium 2016 batteries (included) that should last for
several years of normal use. If you notice a significant decrease
in operating range, the batteries should be replaced.
Replacement batteries can be purchased at most pharmacies,
watch stores or at your Ford or Lincoln-Mercury dealer.
File:cdfvo.ex
Update:Thu Jan 25 12:20:30 1996

195
Servicing Your Contour
%*
[SV00300(ALL)03/95]
Service Made Easy
*
[SV00400(ALL)01/95]
Ford has two goals for servicing your vehicle.
*
[SV00500(ALL)01/95]1.
When we can, we design parts that do not need to be
serviced.
*
[SV00600(ALL)01/95]2.
We want to make servicing your vehicle as easy as possible.
To help you:
*
[SV00700(ALL)01/95]
n
We highlight do-it-yourself items in yellow in the engine
compartment so that you can find them easily.
*
[SV00800(ALL)01/95]
n
When possible, we design parts Ð such as the headlamp
bulbs Ð that can be replaced without tools.
*
[SV00900(ALL)05/94]
n
We give you a Maintenance Schedule that makes tracking
routine service for your vehicle easy. The maintenance
schedule is located in theMaintenance Schedule and Record
booklet.
*
[SV01000(ALL)01/95]
This chapter tells you about the basic parts that you need to
check and service regularly.
*
[SV01150(ALL)02/95]
If your vehicle needs professional servicing, your dealership can
provide the parts and service required. Check yourWarranty
Information Bookletto find out which parts and services are
covered. Also see theCustomer Assistancechapter of this Owner
Guide.
*
[SV01250(ALL)03/95]
Ford Motor Company recommends that the Owner Maintenance
Checks listed in theMaintenance Schedule and Recordbooklet be
performed for the proper operation of your vehicle. In addition
to the conditions listed in theOwner Maintenance Checklist,be
alert for any unusual noise, vibration, or other indication that
your vehicle may need service. If you do notice something
unusual, see that your vehicle is serviced promptly.
File:cdsvo.ex
Update:Thu Jan 25 12:09:28 1996

244the circuit breakers continue to cut off electricity, have your
vehicle's electrical system checked.
*
[SV37200(ALL)02/95]
If you replace a circuit breaker, use one with the same
amperage rating. To remove a circuit breaker mounted in the
fuse panel, grip it with your finger and thumb and pull it
straight out of its socket.
*
[SV37500(ALL)03/95]
Lights and Bulb Replacement
*
[SV37600(ALL)01/95]
It is a good idea to check the operation of the following lights
frequently:
*
[SV37700(ALL)01/95]
n
headlamps
*
[SV37800(ALL)01/95]
n
tail lamps
*
[SV37900(ALL)01/95]
n
brakelamps
*
[SV37950(ALL)02/95]
n
high-mount brakelamp
*
[SV38000(ALL)01/95]
n
hazard flasher
*
[SV38100(ALL)01/95]
n
turn signals
*
[SV38200(ALL)01/95]
n
side markers
*
[SV38300(ALL)01/95]
n
license plate lamp
%*
[SV38400(ALL)01/95]
The alignment of your headlamps should be checked if:
*
[SV38500(ALL)01/95]
n
oncoming motorists frequently signal you to turn off your
vehicle's high beams when you do not have the high beams
on
*
[SV38600(ALL)01/95]
n
the headlamps do not seem to give you enough light to see
clearly at night
*
[SV38700(ALL)11/92]
n
the headlamps are not aligned so that they point slightly
down and to the right.
File:cdsvo.ex
Update:Thu Jan 25 12:09:28 1996

Servicing Your Contour
245
*
[SV38800(ALL)03/95]
Headlamp Bulb
[SV38900(ALL)05/94]
The headlamps on your vehicle use replaceable bulbs, one for
high beam and one for low beam on each side. When the lamp
burns out, simply replace the bulb, rather than the whole lamp.
*
[SV39000(ALL)05/95]
RWARNING
Handle a halogen headlamp bulb carefully and keep out
of children's reach. Grasp the bulb only by its plastic
base and do not touch the glass. The oil from your hand
could cause the bulb to break the next time the
headlamps are operated.
*
[SV39100(ALL)01/95]
Do not remove the burned-out bulb unless you can immediately
replace it with a new one. If a bulb is removed for an extended
period of time, contaminants may enter the headlamp housing
and affect its performance.
*
[SV39300(ALL)03/95]
Removing the headlamp bulb
*
[SV39400(ALL)05/95]1.
Make sure that the headlamp knob is in the OFF position.
*
[SV39500(ALL)02/95]2.
Lift the hood and find the bulb in the headlamp socket.
[SV39850(ALL)04/94]3.
Remove the bulb assembly by turning it clockwise and
pulling it out of the headlamp socket.
[SV40050(ALL)04/94]4.
Remove the L-shaped bulb by pressing the retaining clip at
the base of the electrical connector and sliding the bulb out.
*
[SV40300(ALL)03/95]
Installing the headlamp bulb
[SV40450(ALL)04/94]1.
Without touching the glass on the bulb, insert the new bulb.
You may want to protect the bulb by holding it with a piece
of cloth or paper towel. Make sure the retaining clip at the
base of the electrical connector locks.
[SV40550(ALL)04/94]2.
Insert the bulb assembly in the headlamp socket. Turn it
counterclockwise to lock it in place.
File:cdsvo.ex
Update:Thu Jan 25 12:09:28 1996

246
[SV40700(ALL)04/94]3.
Turn the headlamps on and make sure that they work
properly. If the headlamp was correctly aligned before you
changed the bulb, you should not need to align it again.
*
[SV40750(ALL)02/95]
High-Mount Brakelamp Bulbs
[SV40841(ALL)02/94]
From the back seat, remove the back of the brakelamp
assembly. Depress the two retaining tabs on the ends of the
assembly and pull off the back.
[SV40843(ALL)02/94]
Turn the burned-out bulb counterclockwise and pull it out. Push
in the replacement bulb and turn it clockwise to lock it in the
socket. Replace the back of the brakelamp assembly, making
sure that the retaining tabs snap into place.
[SV40848(ALL)02/94]
17-1/2 pica
art:0000624-B
The high-mount brakelamp assembly
File:cdsvo.ex
Update:Thu Jan 25 12:09:28 1996

275
Brake-shift interlock.................. 140
Break-in period..................... 4
Brights (high beams)................. 59,84
Bulbs, replacing
halogen...................... 245
headlamps..................... 245
high-mount brakelamp................ 246
C
Canada, customer assistance.............. 186
Canada, warranty information.............. 3
Canadian Motor Vehicle Arbitration Plan (CAMVAP) . . . 187
Capacities for refilling fluids.............. 252
Carbon monoxide in exhaust............... 51
Car seats for children (see Child safety seats)....... 26
Cassette tape player (see Electronic sound system).... 134
Catalytic converter................... 248
Chains, tires...................... 228
Changing a tire.................... 168
Charging system warning light.............. 58
Childproof locks..................... 93
Child safety restraints
child safety belts................... 38
child safety seats................... 26
Child safety seats
and air bags................... 18,26
attaching with tether straps.............. 37
automatic locking mode (retractor)........... 26
in front seat..................... 29
in rear outboard seat................. 29
tether anchorage hardware............... 37
Chime
headlamps on..................... 60
key in ignition.................... 43
safety belt...................... 56
File:cdixo.ex
Update:Thu Jan 25 12:10:47 1996

276 Circuit breakers, checking and replacing......... 243
Cleaning your vehicle
CD player and discs................. 125
chrome and aluminum parts.............. 6
exterior....................... 5
exterior lamps.................... 79
fabric....................... 106
headlamps...................... 79
instrument panel................... 69
mirrors....................... 108
plastic parts..................... 6
polishing....................... 5
rear windows..................... 76
rustproofing..................... 6
safety belts...................... 16
tail lamps...................... 79
upholstery and interior trim............. 106
washing....................... 5
wheels....................... 229
windows....................... 76
Clutch
operation while driving............... 145
shifting the gears.................. 145
specifications.................... 254
Cold engine starting................... 46
Combination lap and shoulder belts............ 9
Compact disc player (see Electronic sound system).... 121
Compact disc radio (see Electronic sound system).... 116
Console, description.................. 110
Controls
instrument panel................... 69
mirrors....................... 107
steering column.................... 83
Coolant (see Engine coolant)
checking and adding................ 213
preparing for storage................ 256
refill capacities................... 252
File:cdixo.ex
Update:Thu Jan 25 12:10:47 1996

281
Gearshift
automatic operation................. 139
locking the gearshift.................. 41
positions...................... 140
shifting the gears.................. 145
shift-lock...................... 140
GVWR (Gross Vehicle Weight Rating)
calculating..................... 156
definition...................... 155
driving with a heavy load.............. 155
location...................... 155
H
Hazard flashers..................... 86
Headlamps
aiming....................... 244
checking alignment................. 244
cleaning....................... 79
daytime running lights................. 79
flashing....................... 84
high beam...................... 84
replacing bulbs................... 245
turning on and off.................. 77
warning chime.................... 60
Head restraints.................... 101
High beams
indicator light..................... 59
operation....................... 84
High-mount brakelamp
description..................... 246
replacing the bulb.................. 246
Hitch......................... 159
Hood
latch location.................... 198
lubrication specifications............... 254
release lever.................... 198
working under the hood............... 196
Horn.......................... 86
File:cdixo.ex
Update:Thu Jan 25 12:10:47 1996