1996 FORD BRONCO spare tire

120 [FV06701(B )05/90]For trucks with a swing away spare tire carrier,
you must release the carrier and swing it out of
the way before lowering the tailgate. See the
following illustration.
[FV06801(B )05/90]
one third page art:0020193-B
Bronco tailgate operation
[FV06901(B )05/90]
Latch lockout system for the tailgate
[FV07001(B )05/90]
The tailgate is equipped with a latch lockout
system which prevents you from opening it
unless the glass is completely down. The lockout
also prevents the glass from being raised unless
the tailgate is completely latched in the closed
position.
[FV07101(B )05/90]
RWARNING
When driving your vehicle make sure that
the tailgate door and window are closed
to prevent exhaust fumes from being
drawn into the vehicle. This will also
prevent passengers and cargo from falling
out.
File:ltfvb.ex
Update:Fri Jun 9 15:28:41 1995

218
*
[DR29950(BEF )06/92]
Do not use the sample numbers on the Safety
Compliance Certification Label shown. Use the
actual numbers from your vehicle certification
label.
*
[DR30001( ALL)06/92]
Understanding Loading/Towing
Information
*
[DR30050( ALL)03/94]
The following terms are used to describe the
ability to carry or tow a load:
*
[DR30101( ALL)01/93]
q
Base Curb Weight
*
[DR30150( ALL)01/93]
q
Payload
*
[DR30200( ALL)01/93]
q
GVW (Gross Vehicle Weight)
*
[DR30250( ALL)01/93]
q
GVWR (Gross Vehicle Weight Rating)
*
[DR30301( ALL)01/93]
q
GAWR (Gross Axle Weight Rating)
*
[DR30310( ALL)06/92]
q
GCWR (Gross Combined Weight Rating)
*
[DR30320( ALL)06/92]
q
Maximum Trailer Weight Rating
*
[DR30330( ALL)06/92]
q
Maximum Trailer Weight
*
[DR30340( ALL)06/92]
q
Trailer Weight Range
*
[DR30351( ALL)03/91]
Base Curb Weight
*
[DR30401( ALL)03/94]
The Base Curb Weight is the weight of the
vehicle including fuel, coolants, lubricants,
emergency tools, spare wheel and tire. It also
includes any equipment that isstandardon that
model. It does not include passengers, cargo or
optional equipment installed by factory, dealer,
aftermarket supplier or customer.
*
[DR30451( ALL)03/91]
Payload
*
[DR30501( ALL)03/91]
Payload is the combined, maximum allowable
weight of cargo, occupants and optional
equipment that the truck is designed to carry. It
is Gross Vehicle Weight Rating minus the base
curb weight.
File:ltdrb.ex
Update:Fri Jun 9 15:26:57 1995

241
*
[RE03400( ALL)05/95]
4. Remove the other end of the positive (+)
cable from the discharged battery.
*
[RE03500( ALL)04/95]
After the vehicle is started, let it idle for a while
to let the engine ªrelearnº its idle conditions.
Drive it around for a while with all electrical
accessories turned off to let the battery recharge.
You may need to use a battery charger to fully
recharge the battery.
*
[RE03550( ALL)03/95]
If you need to replace your battery, seeBattery
in theServicing Your Vehiclechapter.
%
*
[RE03600( ALL)03/95]
Changing a Tire
*
[RE03700( ALL)01/95]
If you get a flat tire while you are driving, do
not apply the brake heavily. Instead, gradually
decrease the speed. Hold the steering wheel
firmly and slowly move to a safe place on the
side of the road. Park on a level spot, turn off
the ignition, set the parking brake, and turn on
the hazard flashers.
*
[RE03800( ALL)03/95]
The Conventional Spare Tire
*
[RE03900(BEF )01/95]
If you have the conventional spare tire, you can
use it as a spare or as a regular tire. This spare
tire is identical to the other tires that come with
your vehicle, although the wheel may not match.
*
[RE04275(BEF )05/95]
RWARNING
To avoid injury, never run the engine
with one wheel off the ground, such as
when changing a tire.
*
[RE04280(BEF )10/94]
Extended use of other than matching size spare
tires on a Traction-Lok axle could result in a
permanent reduction in effectiveness. This loss of
effectiveness does not affect normal driving and
should not be noticeable to the driver.
File:ltreb.ex
Update:Fri Jun 9 15:25:48 1995

242
*
[RE05100(BEF )03/95]
Spare Tire Location
[RE07700(B )05/90]
The spare tire for your Bronco is mounted inside
on a carrier at the right rear quarter panel unless
you have an optional outside mounted spare
tire. To remove the spare tire, remove the wing
nut and plate. If so equipped, use a door key to
unlock the lock assembly and remove the plate.
To stow the spare tire, place the wheel on the
bolt and tighten the plate and wing nut, or lock
assembly, if so equipped.
[RE07800(B )02/89]
one third page art:0020271-A
Inside spare tire assembly
[RE08100(B )05/90]
one third page art:0020322-C
Spare tire mount
[RE08300(B )01/89]
The optional outside mounted spare tire is
mounted on a swing-away carrier that hinges on
the outside right rear corner of the truck.
File:ltreb.ex
Update:Fri Jun 9 15:25:48 1995

243 [RE08400(B )01/89]
To remove the outside mounted spare tire:
[RE08450(B )05/90]
quarter page art:0020275-A
Removal and installation of spare tire cover
[RE08500(B )05/90]
1. Lift the edge of the spare tire cover behind
the top of the tire and slide the cover over
the tire and downward.
[RE08600(B )01/89]
2. Remove the security lock, retaining nut and
mounting plate.
[RE08700(B )01/89]
3. Slide the tire outward and lift off the carrier.
[RE08800(B )01/89]
If you have difficulty removing the retaining
nut, turn the nut counterclockwise by using the
tapered end of the lug nut wrench in one of the
slots at either end of the retaining nut.
[RE08900(B )05/89]
To stow the outside mounted spare tire:
[RE09000(B )01/89]
1. Place the spare tire on the carrier over the
bolt, styled side in.
[RE09100(B )01/89]
2. Place the plate on the bolt and tighten the
retaining nut securely.
[RE09200(B )01/89]
3. Install security lock.
[RE09300(B )02/89]
4. Position the cover over the edge of the tire
with the drainage eyelet at the bottom. Slide
the cover upward, wrapping it around the
edge of the tire until the cover is completely
fitted.
File:ltreb.ex
Update:Fri Jun 9 15:25:48 1995

244 [RE09400(B )05/90]NOTE: If your truck has optional aluminum
wheels, you should slip the anti-scratch
spacer over the ªJº bolt between the
tire and carrier to prevent scratching
the aluminum styled-side surface.
[RE09500(B )05/91]
one third page art:0020273-C
Optional outside mounted spare tire and carrier
*
[RE15100(BEF )05/95]
RWARNING
Make sure the spare tire and jacking
equipment are stowed and secured in the
proper storage location.
%*
[RE15200( ALL)03/95]
Preparing to Change the Tire
*
[RE15250( ALL)12/91]
NOTE: To lift your vehicle by other than the
front or rear jacking points, be sure to
use only hoist adapters with a wide
contact surface.
*
[RE15300(B F )03/91]
1. Make sure that your vehicle will not move
or roll. If you have an automatic
transmission, put the gearshift in Park. If
you have a manual transmission, put the
gearshift in Reverse. Set the parking brake
and block the wheel that is diagonally
opposite the tire that you are changing.
*
[RE15335(B F )12/91]
NOTE: Make sure the ignition is in the OFF
position.
File:ltreb.ex
Update:Fri Jun 9 15:25:48 1995

245
*
[RE15350(B F )06/94]
If you have a four-wheel drive vehicles with
manual locking hubs, put transfer case lever in
2H, 4H, or 4L.
*
[RE15375(B F )05/95]
When one of the back wheels is off the ground,
the transmission alone will not prevent the
vehicle from moving or slipping off the jack,
even if the vehicle is in P (Park) or 1 (First). To
prevent the vehicle from moving when you
change a tire, be sure the parking brake is set,
then block the wheel (both directions) that is
diagonally opposite (other side and end of the
vehicle) to the tire that is being changed.
*
[RE15400(B F )05/95]
RWARNING
If the vehicle slips off the jack, you or
someone else could be seriously injured.
[RE15435(B F )05/95]
When the transfer case is in the N (Neutral)
position, the engine and transmission are
disconnected from the rest of the driveline.
Therefore, the vehicle is free to roll even if the
automatic transmission is in P (Park) or the
manual transmission is in gear.
*
[RE15440(B F )05/95]
RWARNING
Do not leave the vehicle unattended with
the transfer case in the N (Neutral)
position. Always set the parking brake
fully and turn off the ignition when
leaving the vehicle.
*
[RE15550(BEF )05/95]
2. Get out the spare tire and jack.
*
[RE15800(B F )10/92]
The jack and lug wrench are stowed under the
hood on the right front fender inner panel, and
the jack handle is on the radiator support.
File:ltreb.ex
Update:Fri Jun 9 15:25:48 1995

248 [RE18551(BE )11/89]
one third page art:0020296-AJacking point
*
[RE18701(B )08/91]
b. Turn the jack handle clockwise until the
wheel is completely off the ground.
*
[RE21151(BEF )10/92]
one third page art:0020939-B
*
[RE21400(BEF )01/95]
3. Remove the lug nuts with the lug nut
wrench.
*
[RE21500(BEF )01/95]
4. Replace the flat tire with the spare tire.
*
[RE21700(B )01/95]
5. Thread the lug nuts on the wheel studs with
the beveled face toward the wheel. Use the
lug nut wrench to screw the lug nut snug
against the wheel but do not tighten.
*
[RE22200(BEF )01/95]
6. Lower the vehicle by turning the jack handle
counterclockwise.
File:ltreb.ex
Update:Fri Jun 9 15:25:48 1995