3. Raise the vehicle by turning the jack handle clockwise.
Raise
the vehicle far enough off the ground so there is
enough room for the spxe tire to fit.
4. Remove all the wheel
nuts and take off the
flat tire.
5. Remove any rust or dirt
from the wheel bolts,
mounting surfaces and
spare wheel.
5-28
ProCarManuals.com
Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned and balanced
carefully at the factory
to give you the longest tire life
and best overall performance.
In most cases, you will not need to have your wheels
aligned again. However, if you notice unusual tire wear
or your vehicle pulling one way or the other, the
alignment may need
to be reset. If you notice your
vehicle vibrating when driving
on a smooth road, your
wheels may need
to be rebalanced.
Wheel Replacement
Replace any wheel that is bent, cracked, or badly rusted
or corroded.
If wheel nuts keep corning loose, the wheel,
wheel bolts
and wheel nuts should be replaced. If the
wheel leaks
air, replace it (except some aluminum
wheels, which
can sometimes be repaired). See your
Geo dealer if any of these conditions exist.
Your dealer will know the kind
of wheel you need.
Each new wheel
should have the same load-carrying
capacity, diameter, width, offset
and be mounted the
same way as
the one it replaces.
If you need to replace any of your wheels, wheel bolts
or wheel nuts, replace them only with new
GM original
equipment parts. This way, you will be sure to have the
right wheel, wheel bolts and wheel nuts for your
Geo model.
Using the wrong replacement wheels, wheel bolts
or wheel nuts on your vehicle can be dangerous. It
could affect the braking and handling of your
vehicle, make your tires lose air and make
you lose
control.
You could have a collision in which you or
others could be injured. Always use the correct
wheel, wheel bolts and wheel nuts for replacement.
NOTICE:
The wrong wheel can also cause problems with
bearing life, brake cooling, speedometer or
odometer calibration, headlamp aim, bumper
height, vehicle
ground clearance and tire or tire
chain clearance to the body and
chassis.
~~
See “Changing a Flat Tire” in the Index for more
information.
6-46
ProCarManuals.com
Short TriplCity Maintenance Schedule
45,000 Miles (75 000 km)
El Change engine oil and filter (or every
3 months, whxhever occurs first).
An Emission Control Service.
17 Clean and repack the front wheel bearings
(or at each brake relining, whichever
occurs first).
in dusty conditions. Replace filter if
necessary.
An Emission Control Service. ?
0 Change manual transmission fluid (or every
15 months, whichever occurs first).
17 Inspect the valve lash and adjust if
necessary. An Emission Control Service.
0 Check engine idle speed and adjust it to
underhood< label specifications.
An Emission Control Service.?
0 Inspect air cleaner filter if you are driving
0 Inspect the loclung front hubs (if equipped)
for correct operation (or every
3 months,
whichever occurs first). Repair or replace
as necessary.
0 Inspect propeller shafts and u-joints for
looseness and damage (or every
15 months,
whichever occurs first). Inspect more
frequently
if used off-road or for pulling
a trailer. Tighten u-joint
flange bolts
if necessary.
I DATE I ACTUAL MILEAGE ISERVICED BY: I
7-17
ProCarManuals.com
