Page 129 of 387

Your vehicle has air outlets that allow you to adjust the
direction and amount of airflow inside
the vehicle. Push
the outlet up
or down to direct airflow to your
preference. Increase
or reduce the amount of airflow by
opening and closing the louvers.
Ventilation Tips
Keep the hood and front air inlet free of ice, snow or
any other obstruction (such
as leaves). The heater
and defroster will work
far better, reducing the
chance
of fogging the inside of your windows.
When you enter a vehicle in cold weather, move the
fan control lever toward the fan symbol for a few
moments before driving off. This helps clear the
intake ducts of
snow and moisture, and reduces the
chance of fogging the inside of your windows.
0 Keep the air path under the front seats clear of
objects. This helps air to circulate throughout
your vehicle.
Defogging and Defrosting
Slide the air intake lever to CIRCULATE and the
airflow lever to DEFROST to direct air to the
windshield vents. Then slide the temperature control
lever toward the right and the fan lever toward the fan
symbol. When the windshield is clear, turn down the
fan
speed.
3-4
ProCarManuals.com
Page 204 of 387

I NOTICE:
If the other system isn’t a 12-volt system with a
negative ground, both vehicles can be damaged.
2. Get the vehicles close enough so the jumper cables
can reach, but be sure the vehicles aren’t touching
each other.
If they are, it could cause a ground
connection you don’t want. You wouldn’t be able to
start your Geo, and the bad grounding could damage
the electrical systems.
3. Turn off the ignition on both vehicles. Unplug
unnecessary
accessories plugged into the cigarette
lighter. Turn
off all lamps that aren’t needed as well
as radios.
This will avoid sparks and help save both
batteries.
In addition, it could save your ra.dio!
I NOTICE:
~~ ~
If you leave your radio on, it could be badly
damaged. The repairs wouldn’t be covered by
your warranty.
4. Open the hoods and locate the batteries. Find the
positive (+) and negative (-) terminals on each battery.
I A CAUTION:
An electric fan can start up even when the engine
is not running and can injure you. Keep hands,
clothing and tools away from any underhood
electric fan.
5-3
ProCarManuals.com
Page 213 of 387
Engine Overheating
You will find a coolant temperature gage on your Geo
instrument panel.
If Steam Is Coming From Your Engine
Steam from an overheated engine can burn you
badly, even if you just open the hood. Stay away
from the engine if you see or hear steam coming
from it. Just turn it off and get everyone away
from the vehicle until it cools down. Wait until
there is no sign
of steam or coolant before
opening the hood.
If you keep driving when your engine is
overheated, the liquids in it can catch fire. You or
others could be badly burned. Stop your engine if
it overheats, and get out
of the vehicle until the
engine
is cool.
I NOTICE:
If your engine catches fire because you keep
driving with no coolant,
your vehicle can be
badly damaged. The costly repairs would not be
covered
by your warranty.
5-12
ProCarManuals.com
Page 214 of 387

If No Steam Is Coming From Your Engine
If you get the overheat warning but see or hear no
steam, the problem may not be too serious. Sometimes
the engine can get a little
too hot when you:
Climb a long hill on a hot day.
0 Stop after high-speed driving.
Idle for long periods in traffic.
0 Tow a trailer.
If you get the overheat warning with no sign of steam,
try this for a minute or
so:
1. If you have an air conditioner, turn it off.
2. Turn on your heater to full hot at the highest fan
speed and open the window
as necessary.
3. If you’re in a traffic jam, shift to NEUTRAL (N);
otherwise, shift to the highest gear while
or
DRIVE (D) for automatic transmissions.
driving
-- AUTOMATIC OVERDRIVE @
If you no longer have the overheat warning, you can dnve.
Just to be safe, drive slower for about
10 minutes. If the
warning doesn’t come back on, you can dnve normally.
If the warning continues, pull over, stop, and park your
vehicle right away.
If there’s still no sign of steam, you can idle the engine
for two or three minutes while you’re parked, to
see if
the warning stops. But then, if you still have the
warning,
turn off the engine and get everyone out of the
vehicle
until it cools down.
You may decide not to lift the hood but to get service
help right away.
5-13
ProCarManuals.com
Page 243 of 387
Checking Things Under the Hood
A CAUTICV: I
An electric fan under the hood can start up and
injure
you even when the engine is not running.
Keep hands, clothing and tools away from any
underhood electric fan. Don’t reach through the
grille to release the underhood lever.
To open the hood, first pull the release handle inside the
glove box.
Things that burn can get on hot engine parts and
start
a fire. These include liquids like gasoline,
oil, coolant, brake fluid, windshield washer and
other fluids, and plastic or rubber.
You or others
could
be burned, Be careful not to drop or spill
things that will
burn onto a hot engine.
6-6 ProCarManuals.com
Page 245 of 387
When you open the hood, you’ll see the following:
c
A. Windshield Washer Reservoir
B. Engine Coolant Reservoir
C. Main Fuse Box
D. Battery
E. Engine Oil Dipstick
E Automatic Transmission Dipstick (if equipped)
G. Oil Fill Cap
H. Power Steering Fluid Reservoir
I. Brake Fluid Reservoir
J. Air Cleaner
6-8
ProCarManuals.com
Page 271 of 387
Bulb Replacement
See “Replacement Bulbs” in the Index to check the size
and type of bulb you need to use.
Halogen Bulbs
Halogen bulbs have pressurized gas inside and
can burst,if you drop or scratch the bulb. You or
others could
be injured. Be sure to read and
follow the instructions on the bulb package.
Headlamps
To replace the headlamp bulb:
1. Open the hood.
2. Push in on both sides of the electrical connector.
Then
pull up and rearward, to disconnect it from the
bulb. The plastic clip on the electrical connector may
need to be lifted gently with a screwdriver.
I
I
6-34
ProCarManuals.com
Page 273 of 387
Front Parking and Turn Signal Lamps
To replace the parking and turn signal bulb:
1. Open the hood.
2. Turn the bulb socket counterclockwise and pull it out
of the lamp housing.
3. Push the bulb in, turn it to counterclockwise and pull
it out.
4. Reverse the steps with a new bulb.
6-36
ProCarManuals.com