1996 CHEVROLET TRACKER automatic transmission

Key in the Ignition
If you leave your vehicle with the keys inside, it’s an
easy target for joy riders or professional thieves -- so
don’t do it.
When you park your Geo and open the driver’s door,
you’ll hear a chime reminding you
to remove your key
from the ignition and take it with
you. Always do this.
Your steering wheel will
be locked, and so will your
ignition. If you have an automatic transmission, taking
your key out also locks your transmission. And
remember
to lock the doors.
Parking at Night
Park in a lighted spat, close all windows and lock your
vehicle. Remember to keep your valuables out of sight.
Put them in a storage area, or take them with you.
New Vehicle 46Break-InS’
I
NOTICE:
Your modern Geo doesn’t need an elaborate
“break-in.” But it will perform better in the long
run if you follow these guidelines:
Keep your speed at 55 mph (88 km/h) or
less for the first 500 miles (804 km).
Don’t drive at any one speed -- fast or
slow
-- for the first 500 miles (804 km).
Don’t make full-throttle starts,
200 miles (322 km) or so. During this time
your new brake linings aren’t
yet broken
in. Hard stops with new linings
can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every
time
you get new brake linings.
See “Towing
a Trailer” in the Index for
more information.
0 Avoid making hard stops for the first
Don’t tow a trailer during break-in.
2-6
ProCarManuals.com

Ignition Positions
4
With the key in the ignition
switch, you can
turn the
switch to four positions.,
LOCK (A): The only position in which you can remove
the key. This locks your steering wheel, ignition and
automatic transmission.
If you have an automatic transmission, the ignition
switch can’t be turned to LOCK unless the shift lever is
in the
PARK (P) position.
ACC (B): The position that you can operate your
electrical power accessories. It unlocks the steering
wheel and ignition. Use this position if your vehicle
must be pushed or towed.
ON (C): The position in which the switch returns to
after you start your engine and release the switch. The
switch stays in the
ON position when the engine is
running. But even when the engine is not running, you
can use ON to operate your electrical power accessories
and to display some instrument panel warning and
indicator lights.
START (D): The position in which the engine starts.
When the engine starts, release the key. The ignition
switch
will return to ON for normal driving.
When the engine is not running, ACC and
ON allow you
to operate your electrical accessories, such as the radio
and ventilation fan.
A warning chime will sound if you open the driver’s
door when the ignition is in ACC or LOCK and the key
is in the ignition.
2-7
ProCarManuals.com

A CAUTION:
On manual transmission vehicles, turning the key to
LOCK will lock the steering column and result in a
loss of ability to steer the vehicle. This could cause a
collision. If you need to turn the engine off while the
vehicle
is moving, turn the key only to ACC. Don’t
push the key in while the vehicle is
moving.
NOTICE:
If your key seems stuck in LOCK and you can’t
turn it, be sure it
is all the way in, If it is, then
turn the steering wheel left and right while
you
turn the key hard. But turn the key only with
your hand.~Using
a tool to force it could break
the key or the ignition switch. If none of this
works, then your vehicle needs service.
Starting Your Engine
Automatic transmission
Move your shift lever to PARK (P) or NEUTRAL (N).
Your engine won’t start in any other position -- that’s a
safety feature. To restart when you’re already moving,
use NEUTRAL (N) only.
NOTICE:
~~
Don’t try to shift to PARK (P) if your Geo is
moving. If you do, you could damage the
transmission. Shift to
PARK (P) only when your
vehicle is stopped.
Manual transmission
The geax selector should be in NEUTRAL (N). Hold the
clutch pedal to
the floor and start the engine. Your
vehicle won’t
start if the clutch pedal is not all the way
down -- that’s a safety feature.
ProCarManuals.com

Automatic Transmission Operation
There are several different positions for your shift lever.
PARK (P): This locks your rear wheels. It’s the best
position
to use when you start your engine because your
vehicle can’t
move easily.
A CAUTION:
~~ ~~~ ~~~~~ ~~
It is dangerous to get out of your vehicle if the
shift lever
is not fully in PARK (P) with the
parking brake firmly set. Your vehicle can roll.
Don’t leave your vehicle when the engine is
running unless
you have to. If you have left the
engine running, the vehicle can move suddenly.
You or others could be injured. To be sure your
vehicle
won’t move, even when you’re on fairly
level ground, always set your parking brake and
move the shift lever to
PARK (P).
If you have four-wheel drive, your vehicle
will be free to roll
-- even if your shift lever
is in
PARK (P) -- if your transfer case is in
NEUTRAL (N). So, be sure the transfer case is in
a drive gear, two-wheel high (2H), four-wheel
high
(4H) or four-wheel low (4L) e- not in
NEUTRAL (N). See ‘(Shifting Into PARK (P)” in
the Index. If you’re pulling
a trailer, see “Towing
a ”railer” in the Index.
2-10
ProCarManuals.com

NOTICE:
If your rear wheels can’t rotate, don’t try to
drive. This might happen if you were stuck in
very deep sand or mud or were
up against a solid
object.
You could damage your transmission.
Also, if
you stop when going uphill, don’t hold
your vehicle there with only the accelerator
pedal. This could overheat and damage the
transmission. Use your brakes to hold your
vehicle in position on
a hill.
Power Mode Selector Switch
A power mode selector
switch is included. When
you need more power for
climbing hills or quicker
acceleration, press the
P (POWER) switch. The
POWER indicator
light on the instrument panel
comes on. For normal driving, press the
N (NORMAL)
switch. The POWER indicator light goes off.
Overdrive Off Switch (Option)
The overdrive off switch is located on the left side of the
shifter. By operating the overdrive
off switch, the
four-speed automatic transmission (three-speed plus
overdrive) can be converted to a three-speed automatic
transmission. While in the three-speed mode, the
transmission will not shift into the overdrive position.
To convert the transmission to the three-speed mode,
push in the overdrive off switch and release
it. The
switch comes out and the
OD OFF indicator light on
the instrument panel comes on.
To return the transmission to the four-speed mode, push
in
the overdrive off switch again. The switch will remain
in and the
O/D OFF indicator light goes off.
Please note that if the transfer lever is in the 4L position,
the four-speed automatic transmission will remain in the
three-speed mode.
2-13
ProCarManuals.com

Automatic Transfer Case
With automatic freewheeling hubs, you don’t have to get
out &the vehicle to lock or unlock the hubs.
Locking the Hubs
1. Stop your vehicle.
2. Shift the transfer case to FOUR-WHEEL
HIGH (4H) or FOUR-WHEEL LOW (4L).
3, Drive slowly forward and the hubs will lock.
Unlocking the Hubs
1. Stop your vehicle.
2. Drive 7 feet (2 m) in the direction opposite to the
direction
you were driving before you stopped.
3. Then, press the clutch if you have a manual
transmission, and shift the transfer case to
TWO-WHEEL HIGH (2H). The hubs will unlock. The transfer case shift lever is on the floor to the right
of the driver. Use this lever to shift into and out of
four-wheel drive.
An indicator light comes on when the
transfer
case is in FOUR-WHEEL HIGH (4H) or
FOUR-WHEEL LOW (4L).
2-18
ProCarManuals.com

I NOTICE:
Driving with the parking brake on can cause
your rear brakes to overheat. You may have to
replace them, and
you could also damage other
parts of your vehicle.
If you are towing a trailer, see “Towing a Trailer” in
the Index.
Shifting Into PARK (P) (Automatic
Transmission Models Only)
A CAUTION:
- -
It can be dangerous to get out of your vehicle if
the shift lever is not
fully in PARK (P) with the
parking brake firmly set. Your vehicle can roll.
If you have left the engine running, the vehicle can
move suddenly.
You or others could be injured. To
be sure your vehicle won’t move, even when you’re
on fairly level ground, use the steps that follow. If
you have four-wheel drive and your transfer case is
in NEUTRAL (N), your vehicle will be free to roll,
even if your shift lever is in PARK (P). So, be sure
the transfer case is in
a drive gear -- not in
NEUTRAL (N). If you’re pulling a trailer, see
“Towing a Trailer” in the Index.
- 2-21
t ProCarManuals.com

1. Hold the brake pedal down with your right foot and
set the parking brake.
2. Move the shift lever into PARK (P) by holding in the
button on
the lever and pushing the lever all the way
toward the front of your vehicle.
3. If you have four-wheel drive, be sure the transfer
case is in a drive gear -- not in NEUTRAL (N).
4. Move the key to LOCK.
5. Remove the key and take it with you. If you can
leave your vehicle with the key in your hand, your
vehicle is in PARK (P).
Leaving Your Vehicle With the
Engine Running
(Automatic Transmission Models Only)
A CAUTION:
It can be dangerous to leave your vehicle with
the engine running. Your vehicle
could move
suddenly if the shift lever is not fully in PARK (P)
with the parking brake firmly set. If you have
four-wheel drive
and your transfer case is in
NEUTRAL (N), your vehicle will be free to roll,
even
if your shift lever is in PARK (P). So be sure
the transfer
case is in a drive gear -- not in
NEUTRAL (N). And, if you leave the vehicle with
the engine running, it
could overheat and even
catch
fire. You or others could be injured. Don’t
leave your vehicle with the engine running
unless
you have to.
2-22
ProCarManuals.com