1996 CHEVROLET EXPRESS spare tire

Downloaded from www.Manualslib.com manuals search engine Removing the Spare Tire and Tools
The following steps will tell you how to use the jack and
change a tire.
Your spare tire is stored underneath the rear of your
vehicle. You will use the ratchet
and extension to lower
the spare tire.
5-21

Downloaded from www.Manualslib.com manuals search engine NOTICE:
Never remove or restore a tire frondto a stowage
position under the vehicle while the vehicle
is
supported by a jack. Always tighten the tire
fully against the underside of the vehicle when restowing
A flat rear tire reduces clearance to remove the spare
tire. If there is less than
12 inches (30.48 cm) between
the ground and the rear bumper or any trailer hitch, jack
up the vehicle
until the flat tire is off the ground.
(See “Removing
the Flat Tire” and “Installing the
Spare Tire,’’ Steps
4 through 8, in this section.)
Unless your vehicle has a flat rear tire, do not remove
or
restore a tire from/to a stowage position under the
vehicle while the vehicle is supported by a jack. Always
tighten the tire
fully against the underside of the vehicle
when restowing.
If you have a vehicle which was completed from a cab
and chassis, refer to the information from the body
suppliedinstaller.
The spare tire
is a full size tire, like the other tires on
your vehicle.
For cargo vans, the jack
is secured
in the rear
Remove the retaining wing bolt and lift
it off the
mounting bracket. Set the jack and jacking equipment
near the
flat tire.
5-22

Downloaded from www.Manualslib.com manuals search engine Attach the ratchet, with the DOWN side facing you, to
the extension. The extension has a socket end and a flat
chisel end.
Put the flat end
of the extension on an angle through the
hole
in the rear door frame, above the bumper. Be sure
the flat end connects into the hoist shaft.
Turn the ratchet counterclockwise to lower the spare tire
to the ground.
If you are changing a flat rear tire and the
vehicle is already jacked up, use the jack handle and
extension
to hook the cable. Then pull the spare from
beneath the vehicle.
If the retainer pulls out, hook the inside
of the wheel and
pull the spare tire out from under
the vehicle.
When the tire has been lowered, tilt the retainer at the
end
of the cable and pull it through the wheel opening.
I NOTICE:
To help avoid vehicle damage, do not drive
vehicle before the cable
is restored.
5-24

Downloaded from www.Manualslib.com manuals search engine Removing the Flat Tire and Installing the
Spare Tire
3. Remove the center cap.
I. With the DOWN side Facing you, use the ratchet and
socket
to loosen all the wheel nuts. Don't remove
them yet.
5-27

Downloaded from www.Manualslib.com manuals search engine 4. Position jack under the
vehicle as shown.
Rear Position
A C A UTION:
Getting under a vehicle when it is jacked up is
dangerous.
If the vehicle slips off the jack, you
could be badly injured or killed. Never get under
a vehicle when it is supported only by a jack.
5. Raise the vehicle by rotating the ratchet clockwise.
Make sure
the UP mark faces you. Raise the vehicle
hr enough off the ground so there is enough room
for the spare tire to fit.
5-29

Downloaded from www.Manualslib.com manuals search engine 6. Remove all the wheel
nuts,
and take off the
flat tire.
7. Remove any rust or dirt
from the
wheel bolts,
mounting surfaces and
spare wheel.
A CAUTION:
Rust or dirt on the wheel, or on the parts to
which
it is fastened, can make the wheel nuts
become loose after a time. The wheel could come
off and cause an accident. When you change a
wheel, remove any rust or dirt from the places
where the wheel attaches to the vehicle. In an
emergency, you can use a cloth
or a paper towel
to do this; but be
sure to use a scraper or wire
brush later,
if you need to, to get all the rust or
dirt off.
I A CAUTION:
Never use oil or grease on studs or nuts. If you
do, the nuts might come loose. Your wheel could
fall off, causing
a serious accident.
I I
5-30

Downloaded from www.Manualslib.com manuals search engine Storing a Flat or Spare Tire and Tools
Storing a jack, a tire or other equipment in the
passenger compartment
of the vehicle could
cause injury. In a sudden stop
or collision, loose
equipment could strike someone. Store
all these
in the proper place.
I. Put the tire on the ground at the rear of the vehicle,
with the valve stem pointed down.
2. Pull the retaining bar through the center of the
wheel, making sure it
is properly attached.
5-33

Downloaded from www.Manualslib.com manuals search engine Inflation -- Tire Pressure
The Certificationflire label, which is on the rear edge of
the driver’s door, shows the correct inflation pressures
for your tires when they’re cold. “Cold” means your
vehicle has been sitting for at least three hours or driven
no more than 1 mile (1.6 km).
I NOTICE:
Don’t let anyone tell you that .underinflation or
overinflation is
all right. It’s not. If your tires
don’t have enough air junderinflation), you can
get the following:
Too much flexing
Too much heat
0 Tire overloading
Bad wear
Bad handling
Bad fuel economy.
NOTICE: (Continued)
I NOTICE: (Continued) I
If your tires have too much air (overinflation),
you can get the following:
Unusual wear
Bad handling
Rough ride
Needless damage from road hazards.
When to Check
Check your tires once a month or more. Also, check the
tire pressure of the spare tire.
How to Check
Use a good quality pocket-type gage to check tire
pressure. You can’t tell
if your tires are properly inflated
simply by looking at them. Radial tires may look
properly inflated even when they’re underinflated.
Be sure
to put the valve caps back on the valve stems.
They help prevent leaks by keeping out dirt and moisture.
6-42