Page 7 of 372
Vehicle Symbols 
These are some of the symbols you may find on your vehicle. 
For example, 
these symbols 
are  used  on an 
original battery: 
POSSIBLE A 
CAUTION 
INJURY 
PROTECT  EYES  BY 
SHIELDING 
CAUSTIC 
ACID  COULD  BATTERY 
CAUSE 
BURNS 
SPARK 
OR ,111, 
COULD  FLAME 
EXPLODE  BATTERY 
These symbols are important 
for  you  and 
your passengers 
whenever  your 
vehicle 
is 
driven: 
DOOR  LOCK 
FASTEN  SEAT 
BELTS 
These symbols  have 
to do with 
your lights: 
SIGNALS e 
TURN 
WARNING 
A 
HAZARD 
FLASHER 
FOG  LAMPS 
$0 
These symbols  are on 
some of 
your  controls: 
WIPER w 
WINDSHIELD 
DEFROSTER 
VENTILATING  FAN 
( 
-b 
-J 
These symbols are  used  on 
warning  and 
indicator lights: 
COOLANT - 
TEMP - 
CHARGING I-1 
BATTERY 
SYSTEM 
BRAKE 
(0) 
COOLANT a 
ENGINE  OIL w, 
PRESSURE 
ANTI-LOCK 
(@) 
BRAKES 
Here  are some 
other symbols 
you  may  see: 
FUSE 
I 
LIGHTER n 
HORN )a( 
SPEAKER 
b 
FUEL p3 
V  
         
        
        
     
        
        Page 76 of 372

2. If it  doesn’t  start  right  away,  hold  your  key in 
START. If  it doesn’t  start  in 10 seconds,  push  the 
accelerator  pedal 
all the  way  down  for five more 
seconds,  or until  it starts. 
3. If your  engine  still  won’t  start  (or starts but  then 
stops),  wait 
15 seconds  and  start  over. 
When  the  engine starts,  let go 
of the key and  the 
accelerator  pedal. 
I NOTICE: 
Your  engine  is designed  to  work  with  the 
electronics  in  your  vehicle. 
If you add  electrical 
parts  or  accessories,  you could  change  the 
way 
the  engine  operates.  Before  adding  electrical 
equipment,  check  with your  dealer.  If you  don’t, 
your  engine  might  not  perform  properly. 
If  you  ever  have  to  have  your  vehicle towed, see 
the  part  of this  manual  that  tells how  to  do  it 
without  damaging  your  vehicle. See “Towing 
Your  Vehicle”  in  the  Index. 
Fuel  Regulator 
You have  a fuel  regulator that shuts  the fuel off when  the 
engine  reaches 
5,600 rpm. 
Engine  Coolant  Heater (Option) 
In very cold weather, 
0°F (- 18°C) or colder, 
the engine  coolant  heater 
can  help. 
You’ll  get  easier starting  and  better  fuel  economy  during 
engine  warm-up.  Usually,  the  coolant heater  should  be 
plugged 
in a  minimum of four  hours  prior to starting 
your  vehicle. 
3 IL  
         
        
        
     
        
        Page 77 of 372

To use the  coolant  heater: 
1. Turn  off  the  engine. 
2. Open the hood  and  unwrap  the  electrical  cord. 
3. Plug it into a normal,  grounded  110-volt AC outlet. 
I 
Plugging  the  cord  into  an  ungrounded  outlet 
could  cause  an electrical  shock.  Also, the  wrong 
kind  of extension  cord  could  overheat  and  cause 
a fire.  You could  be  seriously  injured.  Plug  the 
cord  into 
a properly  grounded  three-prong 
110-volt  AC outlet.  If the  cord  won’t reach,  use 
a 
heavy-duty  three-prong  extension  cord  rated for 
at least 15 amps. 
4. After  you’ve  used  the  coolant  heater,  be  sure  to  store 
the  cord 
as it was  before  to  keep it away  from  moving 
engine  parts. 
If you don’t, it could  be  damaged. 
How  long  should  you  keep the coolant  heater  plugged 
in? The answer depends  on  the outside temperature,  the 
kind 
of oil  you  have,  and  some other things.  Instead  of 
trying 
to list  everything  here,  we ask that you contact 
your 
GM dealer in the  area  where you’ll be  parking  your 
vehicle.  The dealer  can give 
you the  best  advice for  that 
particular  area. 
2-17  
         
        
        
     
        
        Page 122 of 372
Engine  Coolant  Temperature  Gage 
If the gage pointer moves to 
the  red area,  your engine  is 
too hot! 
Daytime  Running.  Lamps,  Indicator  Light 
:::O ..e 
If your vehicle’was  first 
sold,  when  new,  in Canada, 
you  will have this light on 
the instrument  panel. 
It  means that  your engine coolant has overheated. 
If you 
have been operating  your vehicle under normal driving 
conditions,  you should pull 
off the road, stop  your 
vehicle and turn 
off the  engine as soon as possible.  It  goes 
on whenever  the  Daytime  Running  Lamps (DRL) 
are on. I 
When it begins 
to get  dark, the DRL indicator light  is a 
reminder to 
turn on  your headlamps. 
In  “Problems  on the Road,” 
this manual shows  you  what 
to do. See “Engine’Overheating” in the  Index. 
 
2-62  
         
        
        
     
        
        Page 129 of 372

Air  Conditioning 
Before using your vehicle’s  air conditioning,  open the 
windows to clear  the vehicle  of  hot  air.  This reduces  the 
time  it takes for  your vehicle  to cool down. Then keep 
your windows  closed for the  air conditioner  to  work at 
its best. 
You can  use  MAX  A/C with the temperature  knob in the 
blue  area,  when  it’s  really hot outside  and  you  need  to 
cool the inside air quickly.  MAX  A/C  lets 
in only a little 
air from the outside. 
If  you  first use  MAX  A/C,  you  can then  use  A/C 
with 
the  temperature  knob  in the  blue  area,  as soon as the 
vehicle  has cooled  down, 
so outside  air will be going 
through your vehicle. 
If  your  vehicle has rear air  conditioning, setting 
it on  LO 
may  enhance  the  front A/C performance  by allowing 
trapped  refrigerant  in the  rear lines  to circulate.  The 
rear  air conditioning  system will only  send cooled 
air  if the  front system is on.  It  can still be  used  to 
circulate  air, even  if the front system is off. 
When  the air  conditioning,  DEFROST or BLEND  is on, 
you  may  notice a slight  increase  or  decrease 
in engine 
speed,  due  to compressor  operation. This is normal 
because 
the system  is designed to cycle  the compressor 
on  and  off  to keep the  desired  temperature. 
Heating 
On cold days,  use HEATER with the temperature knob 
in  the  red  area. Outside  air  will  be brought in through 
the floor outlets.  The heater works best 
if you keep  your 
windows closed while  using it. 
If you  use  the optional  engine  coolant heater before 
starting  your engine,  your heating system  will produce 
warmer  air faster  to  heat the passenger compartment in 
cold  weather.  See  “Engine  Coolant Heater” 
in the Index. 
3-5  
         
        
        
     
        
        Page 189 of 372

Making  Turns 
NOTICE: 
Making  very  sharp turns while  trailering  could 
cause  the  trailer  to  come  in  contact with  the 
vehicle.  Your vehicle  could 
be damaged.  Avoid 
making  very  sharp turns  while  trailering. 
When  you’re  turning  with  a trailer,  make  wider  turns  than 
normal. 
Do this so your  trailer  won’t  strike  soft  shoulders, 
curbs,  road  signs,  trees  or other  objects.  Avoid jerky or 
sudden  maneuvers.  Signal  well  in  advance. 
Tbrn  Signals  When  Towing a Trailer 
When you tow a trailer,  your  vehicle has to have extra 
wiring  and a heavy-duty  turn  signal  flasher (included 
in 
the optional  trailering  package). 
The green arrows  on  your  instrument  panel  will  flash 
whenever  you signal a  turn or lane  change.  Properly 
hooked  up,  the  trailer lamps will also flash,  telling other 
drivers  you’re  about  to  turn,  change lanes or stop.  When 
towing 
a trailer, the green arrows on your 
instrument  panel  will  flash for turns  even if the  bulbs 
on 
the  trailer  are burned out. Thus, you may  think drivers 
behind  you  are seeing your signal  when  they  are not.  It’s 
important 
to check  occasionally  to  be  sure the  trailer 
bulbs  are  still  working. 
Driving On Grades 
Reduce  speed  and  shift to a lower  gear before you start 
down  a long  or  steep  downgrade.  If 
you don’t  shift 
down,  you  might  have  to use  your  brakes 
so much  that 
they  would  get  hot  and 
no longer  work  well. 
On  a long  uphill grade, shift down and  reduce your 
speed  to  around 
45 mph (70 km/h)  to reduce  the 
possibility 
of engine  and  transmission  overheating. 
When  towing  at  high  altitude  on  steep  uphill  grades, 
consider  the  following:  Engine  coolant  will  boil  at  a 
lower  temperature  than  at  normal  altitudes.  If  you  turn 
your  engine  off  immediately  after  towing  at  high  altitude 
on steep  uphill  grades,  your  vehicle  may  show  signs 
similar  to  engine  overheating. 
To avoid  this,  let  the 
engine  run  while  parked  (preferably  on level  ground) 
with  the  automatic  transmission  in 
PARK (P)  for  a few 
minutes  before  turning 
the engine  off.  If  you do get  the 
overheat  warning,  see “Engine  Overheating”  in 
the Index. 
4-35  
         
        
        
     
        
        Page 205 of 372
Engine Overheating 
You will find a temperature gage on your  vehicle’s 
instrument  panel. 
If Steam Is Coming From Your Engine 
Steam  from  an  overheated  engine  can  burn  you 
badly,  even  if you  just  open  the  hood. 
Stay away 
from  the  engine  if you  see  or  hear  steam  coming 
from  it. Just  turn  it off  and  get  everyone  away 
from  the  vehicle until  it cools down.  Wait  until 
there  is  no  sign  of steam  or  coolant  before 
opening  the  hood. 
If you keep  driving  when your  engine  is 
overheated,  the  liquids  in  it  can  catch  fire.  You or 
others  could  be badly  burned.  Stop  your  engine  if 
it  overheats,  and get  out  of the  vehicle  until  the 
engine  is  cool. 
I NOTICE: 
If your  engine  catches  fire  because  you keep 
driving  with  no  coolant,  your  vehicle can  be 
badly  damaged.  The  costly repairs  would  not  be 
covered  by  your  warranty. 
5-13  
         
        
        
     
        
        Page 207 of 372
When you decide  it’s safe  to lift the  hood,  here’s  what 
you’ll  see: If the coolant  inside  the  coolant recovery  tank is boiling, 
don’t  do anything else 
until it cools down. 
A. Coolant  Recovery  Tank 
B. Radiator  Pressure Cap 
C. Engine Fan  The 
coolant  level  should  be  at 
the ADD mark. If it 
isn’t, you may  have a leak in the radiator  hoses,  heater 
hoses,  radiator,  water  pump or somewhere else 
in the 
cooling system. 
5-15