Page 132 of 340

~ Drunken Driving The
obvious way to solve this highway safety problem
is for people never to drink alcohol and then drive. But
Death and injury associated with drinking and driving what if people do? How much is “too much” if the
I is a national Itragedy. It’s the number one contributor to
driver plans to drive? It’s a lot less than many might
i the highway death toll, claiming thousands of victims , think. Although it depends on each person and situation,
every year. here is some general information on the problem.
Alcohol affects four things that anyone needs to drive
a vehicle:
Judgment
Muscular Coordination
0 Vision
0 Attentiveness.
Police records show that almost half
of all motor
vehicle-related deaths involve alcohol. In most cases, these deaths are the result of someone who was drinking
and driving. In recent years, some 18,000 annual motor
vehicle-related deaths have been associated with the use
of alcohol, with more than
300,000 people injured.
Many adults
-- by some estimates, nearly half the
adult population
-- choose never to drink alcohol, so
they never drive after drinking. For persons under 2 1 ,
it’s against the law in every U.S. state to drink alcohol.
There are good medical, psychological and
developmental reasons for these laws. The
Blood Alcohol Concentration (BAC)
of someone
who is drinking depends upon four things:
The amount of alcohol consumed
The drinker’s body weight
0 The amount of food that is consumed before and
during drinking
0 The length of time it has taken the drinker to
According to the American Medical Association, a
180-lb.
(82 kg) person who drinks three 12-ounce
(355 ml) bottles of beer in an hour will end up with a
BAC
of about 0.06 percent. The person would reach the
same BAC by drinking three 4-ounce (120
ml) glasses
of wine or three mixed drinks if each had
1- 1/2 ounces
(45 ml) of a liquor like whiskey, gin or vodka.
consume the alcohol.
1 4-2
I
ProCarManuals.com
Page 168 of 340
Your hazard warning flashers work no matter what
position your key is in and even if the key isn’t in.
To turn off the flashers, pull out on the collar. When
the hazard warning flashers are on, your
turn signals
won’t work.
Other Warning Devices
~f you carry reflective triangles, you can set one up
at the side of the road about
300 feet (100 m) behind
your vehicle.
Jump Starting
If your battery has run down, you may want to use
another vehicle and
some jumper cables to start your
Buick. But please use the following steps to do
it safely.
A CAUTION:
Batteries can hurt you. They can be dangerous
because:
They contain acid that can burn you.
They contain gas that can explode or ignite.
They contain enough electricity to burn you.
If you don’t follow these steps exactly, some
or all
of these things can hurt you.
1. Check the other vehicle. It must have a 12-volt
battery with a negative ground system.
ProCarManuals.com
Page 174 of 340

To help avoid injury to you or others:
Never let passengers ride in a vehicle that is
0 Never tow faster than safe or posted speeds.
0 Never tow with damaged parts not
fully secured.
Never get under your vehicle after it has
been lifted by the tow truck.
Always secure the vehicle on each side with
separate safety chains when towing it.
0 Never use J-hooks. Use T-hooks instead.
being
towed.
U
A vehicle can fall from a car carrier if it isn’t
adequately secured. This can cause
a collision,
serious personal injury and vehicle damage. The
vehicle should be tightly secured with chains or
steel cables before it is transported.
Don’t use substitutes (ropes, leather straps,
canvas webbing, etc.) that can be cut by sharp
edges underneath the towed vehicle.
Always use
T-hooks inserted in the
T-hook slots. Never use
J-hooks. They will damage drivetrain and
suspension components.
When your vehicle
is being towed, have the ignition
key
in the OFF position. The steering wheel should
be clamped
in a straight-ahead position, with a
clamping device designed for towing service. Do not
use the vehicle’s steering column lock for this. The
transaxle should be in NEUTRAL (N) and the
parking brake released.
5-8
ProCarManuals.com
Page 194 of 340
Standard Wheel Cover Wire Wheel Cover
You
will be using the flat end of the wheel wrench to
remove the wheel cover. Pry along the edge
of the wheel
cover until it comes
off.
Removing the wire wheel cover requires this wire wheel
key wrench.
A. Put the flat end into the notch and carefully pry the
small center cover off.
ProCarManuals.com
Page 195 of 340
B. Remove the theft deterrent wheel nut by placing
the key end of the wire wheel wrench over the
nut and turning it to the left. Pull off the wire
wheel cover.
C. Next, attach the wheel wrench to the bolt on the end
of the jack. Raise the jack a little by rotating the
wheel wrench clockwise
(to the right).
Removing the Flat Tire and Installing the
Spare Tire
1. Using the wheel wrench, loosen all the wheel nuts.
Don't remove them yet.
2. Position the jack under the vehicle nearest the
tire to be changed. The jack location should be
approximately
5 inches (12.7 cm) from the
wheel well.
5-29
ProCarManuals.com
Page 262 of 340

Electrical System
Add-on Electrical Equipment
I NOTICE:
Don’t add anything electrical to your Buick
unless you check with your dealer first. Some
electrical equipment can damage your vehicle
and the damage wouldn’t be covered by your
warranty. Some add-on electrical equipment
can keep other components from working as
they should.
Your vehicle has an air bag system. Before attempting to
add anything electrical to your Buick, see “Servicing
Your Air Bag-Equipped Buick” in the Index.
Headlamp Wiring
The headlamp wiring is protected by a circuit breaker in
the lamp switch. An electrical overload will cause the
lamps to
go on and off or, in some cases, to remain off.
If this happens, have your headlamp system checked
right away.
Windshield Wipers
The windshield wiper motor is protected by a circuit
breaker and a fuse.
If the motor overheats due to heavy
snow, etc., the wiper will stop until the motor cools. If
the overload is caused by some electrical problem, have
it fixed.
Power Windows and Other Power Options
Circuit breakers in the fuse panel protect the power
windows and other power accessories. When the current
load is too heavy, the circuit breaker opens and closes,
protecting the circuit until the problem is fixed.
Engine A/C, EGR, Relays, SIR Crank and
Safety Belt Fuses
These fuses are located behind the glove box. The fuse
holders are taped together with gray tape.
Other - uses
The Safety Belt/Chime (ICAM) Module fuse and the
Remote Keyless Entry fuse are located behind the fuse
block, above the hush panel.
The Fuel Pump, A/C CONT and the ECM fuses are
located under the hood.
6-56
ProCarManuals.com
Page 264 of 340
Fuse I qe Chart Fuse Circuitry
I----
ECM INJ/COIL UNLOCK FANiALT
GAUGES
STOP HAZ CTSY WDo
FRONT VIEW OF FUSE BLOCK
Fuse
ECM INJ/COIL
Circuitry
Powertrain Control Module Fuel Injectors UNLOCK Auto
Door Locks (Remove
this
fuse to disable the automatic
door unlock.)
FAN/ALT Electric Fan, Starter
and Generator, Seq. Fuel
Inj
(V6), Cruise Control,
Anti-Lock Brakes
TURN B/U Back-up Lamps
AIR BAG Supplemental Inflatable
Restraint (Air Bag System)
TAIL
HTR A/C
GAGES Taillamps,
Parking, Sidemarker,
License Plate, Stopflurn Signal
Heater/Air Conditioner
Blower Controls
IA? Cluster, Warning Indicators,
Torque Converter Clutch,
Audible Warning System, Trunk
Release, Brake Warning
Indicator, Rear Defog Switch,
Remote Keyless
Entry,
Headlamps, Air Bag System
6-58
ProCarManuals.com
Page 265 of 340
Fuse Circuitry
STOP HA2 Stoplamps, Hazard Flashers
CTSY Interior, Underhood, Courtesy,
UP, Trunk Lamps, Door Locks,
Horn Relay, Passive Restraint
System, Deck Lid Release,
Power Antenna Remote Keyless
Entry, Vanity Mirror
WDO* Power Windows
INST LPS Illumination for:
I/P, Radio, Pod
Lamps, Ashtray, Console Lamp,
Heater and A/C Control, Defog
Switch, Headlamp Switch,
Power Antenna
Fuse Circuitry
RADIO Radio
PWR ACC* Seats, Door Locks, Rear Defog,
Power Seat Recliner, Rear
Window Wiper, Trunk Release
WPR
CIG LTR Windshield
Wiperwasher
Cigarette Lighter
*Circuit Breaker
6-59
ProCarManuals.com