Page 198 of 340
Never use oil or grease on studs or nuts. If you
do, the nuts might come loose. Your wheel could
fall off, causing a serious accident.
Place the spare on the wheel mounting surface.
6. Replace the wheel nuts with the rounded end of the
nuts toward the wheel. Tighten each nut by hand
until the wheel
is held against the hub.
7. Lower the vehicle by rotating the wheel wrench
counterclockwise. Lower the jack completely.
5-32
ProCarManuals.com
Page 201 of 340
3OAD
TIRE .--
BAG
Sedan
1.
2.
3.
4.
Place the tire, air valve up, in the tire storage area.
Remove the extension bolt from the jacking tools
bag. Secure the tire by inserting and tightening the
extension bolt through the center
of the tire into the
storage area floor.
Place the spare tire cover on the storage area, with the
jack face down over
the hole in the center of the board.
Insert the center retainer bolt through the jack and
secure it
by turning the bolt clockwise.
NOTE: The cover will not
fit flush when a flat tire is
stored
in this location.
5-35
ProCarManuals.com
Page 211 of 340
- -
Gasoline vapor is highly flammable. It burns
violently, and that can cause very bad injuries.
Don’t smoke
if you’re near gasoline or refueling
your vehicle. Keep sparks, flames, and smoking
materials away from gasoline.
I ne cap is behind a hinged door on the left side of
your vehicle.
To take off the cap, turn it slowly to the left
(counterclockwise). I
If you get gasoline on yourself and then
something ignites it, you could
be badly burned.
Gasoline can spray out on you
if you open, the
fuel filler cap too quickly.
This spray can happen
if your tank is nearly full, and is more likely in
hot weather. Open the fuel filler cap slowly and
wait for any “hiss” noise to stop. Then unscrew
the cap all the way.
I Be careful not to spill gasoline. Clean gasoline from
painted surfaces as soon as possible. See “Cleaning the
Outside
of Your Buick” in the Index.
6-5
ProCarManuals.com
Page 239 of 340
Bulb Replacement
Halpqen BIJhc
Headlamp Bulb Replacement
For the type of bulb, see “Replacement Bulbs” in
the Index.
1 A CAUTION:
Halogen bulb: ave pressu zed gas inside and
can burst if you drop or scratch the bulb.
You or
others could be injured. Take special care when
handling and disposing
of halogen bulbs.
1. Turn the bulb assembly counterclockwise one-sixth
of a turn, pressing in firmly, until the flanges align
with the slots in the retainer ring.
2. Pull out the bulb assembly.
3. Disconnect the bulb base from the wiring harness by
lifting the plastic locking tab.
6-33
ProCarManuals.com
Page 240 of 340
To replace the bulb
assembly:
1. Snap a new bulb into the wiring harness (A). Make
sure the locking tab
(B) is over the lock (C).
2. Install the bulb assembly by putting the small tab (D)
in the small notch in the retainer ring (E).
in place.
3. Turn the bulb assembly 1/6 turn clockwise to lock it
Front lhrn and Parking Bulb and/or
Sidemarker
Bulb Replacement
1. Raise the hood.
2. Insert a screwdriver into the loop of the spring,
which can be seen just behind the bulb assembly.
3. Pull the spring to the rear and slightly toward the
outside
of the vehicle until the detent releases from
the notch in the headlamp mounting frame.
6-34
ProCarManuals.com
Page 241 of 340
4. The bulb assembly is now loose. Pull it forward until
the bulb assembly can be reached.
To replace the turdparking bulb:
1. Rotate the bulb socket housing 1/4 turn
counterclockwise.
2. Push in and turn the bulb counterclockwise to
remove it.
3. Put in the new bulb and turn it clockwise.
4. Snap the wire connector onto the bulb assembly.
To replace the sidemarker bulb:
1. Remove the socket by turning it counterclockwise
and pulling it straight out.
2. Remove the bulb by pulling it straight out of
the socket.
3. Insert the new bulb by pressing it straight into
the socket.
4. Insert the socket by pressing it straight into the bulb
hole and turning
it clockwise.
6-35
ProCarManuals.com
Page 243 of 340
4. Press the bulb housing release lever and turn the
housing
1/6 turn counterclockwise to remove it.
5. To remove the bulb, push in and rotate it
counterclockwise.
6. Reverse all steps to reassemble the taillamp.
Windshield Wiper Blade Replacement
Replacement blades come in different types and are
removed
in different ways. Here’s how to remove the
type with a spring release:
1. Pull the windshield wiper arm away from the windshield.
2. Press down on the spring with SI screwdriver and pull
the blade assembly off the wiper arm.
3. Push the new wiper blade securely onto the wiper arm.
For the replacement blade type and length, see
“Capacities and Specifications” in the Index.
6-37
ProCarManuals.com
Page 330 of 340

Trailer ...................................... 4-33
Transaxle Shift Interlock
....................... 2-23
Transaxle Shift Interlock Check
.................. 7-39
Wear
....................................... 6-31
Brakes. Anti-Lock
............................... 4-6
Braking
........................................ 4-5
Braking in Emergencies
........................... 4-8
Break.In. New Vehicle
.......................... 2- 10
BTSI
......................................... 2-23
BTSICheck
................................... 7-39
Bulb Replacement
.............................. 6-33
Canadian Roadside Assistance
.................... 8-4
Capacities and Specifications
...................... 6-6 1
Carbon Monoxide .................... 2.24.4.27. 4.33
Cargo Security Cover
............................ 2-40
Cassette Deck Service
........................... 7-37
Cassette Tape Player
............................. 3-6
Cassette Tape Player Care
......................... 3-9
Center Passenger Position
........................ 1-27
Certification Label
.............................. 4-28
Chains. Safety
................................. 4-33
Chains. Tire
................................... 6-45
Checking Your Restraint Systems
.................. 1-46
Chemical Paint Spotting
.......................... 6-53
Child Restraints
................................ 1-33
Securing in the Center Seat Position
.............. 1-36
Changing a
Flat Tire
.. t. .......................... 5-24
Securing
in a Rear Outside Seat Position ........... 1-34
Securing in
the Right Front Seat Position .......... 1-38
TopStrap
................................... 1-33
WheretoPut
................................ 1-33 Cigarette
Lighter
............................... 2-42
Circuit Breakers and Fuses
....................... 6-57
Cleaner. Air
................................... 6-14
Cleaning
...................................... 6-46
Aluminum Wheels
............................ 6-51
Fabric
...................................... 6-47
Glass
....................................... 6-49
Inside
of Your Buick .......................... 6-46
Instrument Panel
............................. 6-49
Leather
..................................... 6-49
Outside
of Your Buick ......................... 6-50
Special Problems
............................. 6-48
Stains
...................................... 6-48
Tires
....................................... 6-52
Vinyl ....................................... 6-48
Wheels
..................................... 6-51
Windshield and Wiper Blades
................... 6-50
Climate Control System ........................... 3-1
Clock. Setting the
................................ 3-4
Coinholder
.................................... 2-39
Comfort Controls
................................ 3-1
Compact Spare Tire
............................. 5-37
Control of a Vehicle .............................. 4-5
Convenience Net
............................... 2-40
Convex Outside Mirror
.......................... 2-38
Coolant
....................................... 6-22
Bleedvalves
................................. 5-21
Heater. Engine
............................... 2-14
RecoveryTank
............................... 5-16
Courtesy Lamps
................................ 2-35
Courtesy Transportation
........................... 8-5
Cover. Cargo Security ........................... 2-40
Cooling System
................................ 5-15
9-2
ProCarManuals.com