68
Headlights, aiming using Hella Universal
Beamsetter IV
Service
Align vehicle headlamps using the VAS 5107
(Hella Universal Beamsetter IV) and the following
procedure:
Additional instructions and diagrams
Instruction Manual for the Hella Beamsetter
Series IV
Have a second technician sit in the driver's seat while aligning the
headlights. - Position vehicle on a flat floor surface that meets the following (ISO
10640) specifications:
0.5mm or less slant from front wheel to back wheel of the
Beamsetter -A-.
1mm or less slant per meter for the length of the vehicle -B-.
- Clean headlight lenses.
- Adjust vehicle tire pressure to specifications.
- Bounce front and rear of vehicle up and down several times to settle
vehicle suspension.
Pa
ge 68 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
73
Passenger's side headlight, alignment
- Move Beamsetter to the passenger side of the
vehicle and follow the same procedures to align
the Beamsetter box to the headlamp.
- Align headlight low beam, check high beam and
align fog lamp.
Note:
Make sure to reset the Beamsetter "Scaled
wheel" to the proper setting each time you
change from low beam to high beam or to fog
lamp.
- Ensure that headlights and vehicle body are
clean and free of fingerprints.
Pa
ge 74 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
