1996 AUDI A4 relay

26-57

- Check for open circuit in wiring from battery +
(terminal 30) to fuse S130 for secondary air
injection pump relay (in 3-position in E-box of
plenum chamber, position 2).

Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder

If specified value is not attained: - Connect multimeter as follows to measure voltage.3-position relay carrier in E-box in plenum chamber,
position 2
contact
Measure to

4 Engine
Groung
- Operate starter briefly.
Specified value: approx. battery voltage
- Carry out following tests:

Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder - Check fuse S234 (in fuse box, position 34).
Pa
ge 18 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-58

- Check for open circuit in wiring from
secondary air injection pump relay (in 3-
position relay carrier in E-box of plenum
chamber) via fuse S234 (in fuse box, position
34) to fuel pump relay.

Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder
Check actuation of secondary air pump relay

- Switch ignition off.

- Remove secondary air injection pump relay.

- Connect voltage tester VAG 1527 B as follows:3-position relay carrier in E-box in plenum chamber,
position 2
contact
Measure to

6 Engine
Ground
- Initiate output Diagnostic Test Mode (DTM) and activate secondary air
injection pump relay.

LED must flash.
Pa
ge 19 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-59
If LED does not flash:

- Switch ignition off.

- Connect VAG 1598/31 test box to wiring
harness leading to engine control module;
engine control module should not be connected:

Repair Manual, 1.8 Liter 4
-Cyl. 5V Turbo Fuel
Injection & Ignition, Engine Code(s): AWM, Repair Group 24


If no malfunction is found: - Check for open circuit and short to positive or Ground in following
wiring connection: 3-position relay carrier in E-box in plenum
chamber, position 2
Contact
Test box VAG
1598/31


6 66
- Repair any open/short circuit as necessary.
- Replace Secondary Air Injection Pump relay -J299-.
Pa
ge 20 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-61


If LED does not flash:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder
Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder
If no malfunction is found: - Connect voltage tester VAG 1527 B between contacts 1 and 2.
- Initiate output Diagnostic Test Mode (DTM) and activate Secondary Air
Injection (AIR) Pump relay -J299-.

LED must flash.
- Carry out following tests:
- Check wiring connection from contact 1 of connector to secondary air
injection pump relay (in 3-pin relay carrier in electronic box (plenum
chamber), for open circuit.
- Check wiring connection of contact 2 of connector to Ground for
open circuit: - Replace Secondary Air Injection (AIR) Pump motor -V101-.
Pa
ge 22 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2