13-80
2 -
Connecting rod bearing cap
Mark cylinder number -B-Installation position: Markings -A- face
towards pulley side
3 -
Bearing shells Upper bearing shell with oil bore for piston
bolt lubrication Installation position Fig. 5
, Page
13
-85
Do not interchange used bearing shells
(mark). Axial clearance New: 0.10 to 0.35 mm,
Wear limit: 0.40 mm Check radial clearance with Plastigage :
New: 0.01 to 0.05 mm, Wear limit: 0.12
mm. Do not rotate crankshaft when
checking radial clearance
Pa
ge 2 of 8 Pistons and connectin
g rods, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.4
13-81
4 -
Connecting rod
Only replace as a setMark cylinder number -B-Installation position: Markings -A- face
toward pulley side With oil bore for piston pin lubrication
5 -
Circlip
6 -
Piston pin If difficult to remove, heat piston to approx.
60 C Remove and install with VW 222a
Pa
ge 3 of 8 Pistons and connectin
g rods, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.4
