Page 6 of 52

01-18
 Diagnostic Trouble Code (DTC) table
 
Notes:  
 
When malfunctions occur in monitored sensors or components, Diagnostic Trouble Codes (DTCs) are stored in DTC 
memory with a description of the malfunction type. 
 "E-Gas"-relevant malfunctions are also indicated in the instrument cluster by the warning lamp for Electronic Power 
Control ("EPC warning lamp"); Notes for E-gas system   Page 24
-134
 . 
 Malfunctions that worsen emissions are also indicated by an exhaust warning lamp (MIL for output DTM) that is also 
located in the instrument cluster. There are malfunctions that cause the exhaust warning lamp to light up immediately after 
recognition. Malfunctions can also occur that do not cause the exhaust MIL to light up immediately, but only if malfunction 
is recognized again after repeated engine starts. 
 The DTC table is organized by the 5 digit code at left.
 If a stored DTC does not recur within the next 40 warm-up cycles, the DTC will be erased automatically.
 Malfunctions that occur only sporadically (temporary malfunctions) are are identified by the letters "SP" (sporadic 
malfunction) on the VAG1551 scan tool display. The word sporadic means "appearing or occurring at irregular intervals, 
occasional". 
 Do not immediately replace components that the VAG1551/VAS5051 suggests are faulty, instead: Check wire 
connections and harness connectors to these components according to wiring diagram. Also check Ground (GND) 
connections according to wiring diagram. This is particularly valid when malfunctions are displayed as "sporadically 
occurring" (SP). 
Pa
ge 6 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2 
     
        
        Page 31 of 52

01-40
 
DTC  
DTC text  
Corrective action  
SAE  
VAG  
  
  
P1250   17658  
Fuel level too low
4)  
 Repair Manual, Electrical Equipment, Repair Group 01, On Board Diagnostic 
(OBD) of instrument cluster; Read Measuring Value Block
    - Fill fuel tank with fuel
- Check wire connection between Engine Control Module (ECM) and instrument 
cluster according to wiring diagram 
- Check signal from sender for fuel gauge and fuel gauge
P1296   17704   Malfunction in cooling 
system 
1)  
 Repair Manual, Engine Mechanical, Repair Group 19; Cooling system 
components, removing and installing  - Check coolant temperature sensor   Page 28
-23
- Check coolant regulator
1) For these malfunctions, ECM does not switch on the Malfunction Indicator Lamp (MIL) unless malfunction is recognized 
again after another engine start. Meaning of Malfunction Indicator Lamp (MIL)   Page 01
-3 .  
4) The DTC "Fuel Level Too Low" is stored when there is/was too little fuel in fuel tank. The DTC is stored as a static 
malfunction and is not switched to sporadic even if fuel tank has been filled with fuel (e.g. by the customer) in the meantime. 
In this way, it can be determined that subsequent malfunctions were caused by lack of fuel, e.g. combustion misfires or 
oxygen control related malfunctions.  
Pa
ge 31 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2 
     
        
        Page 41 of 52

01-47
 
DTC  
DTC text  
Corrective action  
SAE  
VAG  
  
  
P1471   17879   Leak Detection Pump (LDP) 
tank ventilation system  
Short circuit to B+
1)  - Leak Detection Pump (LDP) Checking
P1472   17880   Leak Detection Pump (LDP) 
tank ventilation system  
Short circuit to Ground (GND)
1)   Repair Manual, Engine Mechanical, Repair Group 20; EVAP canister 
system components, servicing; Leak Detection Pump (LDP) -V144-, 
checking.  
P1473   17881   Leak Detection Pump (LDP) 
tank ventilation system  
Open circuit
1)    
P1475   17883   Leak Detection Pump (LDP) 
tank ventilation system  
Malfunction / no signal
1)  
 Repair Manual, Engine Mechanical, Repair Group 20; EVAP canister 
system components, servicing; wiring diagram, EVAP canister system.  - Check pressurized/vacuum lines to Leak Detection Pump (LDP)
P1476   17884   Leak Detection Pump (LDP) 
tank ventilation system  
Malfunction/vacuum pressure 
too low 
1)  - Check electrical wire connections to Leak Detection Pump according 
to wiring diagram 
1) For these malfunctions, ECM does not switch on the Malfunction Indicator Lamp (MIL) unless malfunction is recognized 
again after another engine start. Meaning of Malfunction Indicator Lamp (MIL)   Page 01
-3 .  
Pa
ge 41 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2 
     
        
        Page 48 of 52

01-52
 
DTC  
DTC text  
Corrective action  
SAE  
VAG  
  
  
P1603   18011  
Control module faulty
1)  
- Replace Engine Control Module (ECM)   Page 24
-21
P1604   18012  
Control module faulty
2) 3)
  
  
P1606   18014   Rough terrain info/engine torque 
from ABS control module  
Electrical malfunction in circuit  
 Electrical Wiring Diagrams, Troubleshooting & Component Locations 
binder    - Check wire connection between Engine Control Module (ECM) and 
ABS control module (powertrain databus)   Page 24
-192
 
P1609   18017   Crash shut-off was triggered  
(Crash triggered) 
5)   Repair Manual, Body
-On Board Diagnostic (OBD), Repair Group 01; 
On Board Diagnostic (OBD) of airbag system
   
- Erase DTC memory of the Engine Control Module (ECM) after output 
Diagnostic Test Mode (DTM) of the airbag system   Page 01
-15
 
1) For these malfunctions, ECM does not switch on the Malfunction Indicator Lamp (MIL) unless malfunction is recognized 
again after another engine start. Meaning of Malfunction Indicator Lamp (MIL)   Page 01
-3 .  
2) For these malfunctions, ECM switches on the EPC warning lamp in instrument cluster. Significance of EPC warning lamp   
Page 24
-136
 .  
3) For these malfunctions, the Engine Control Module (ECM) switches on the Malfunction Indicator Lamp (MIL) in the 
instrument cluster immediately after recognizing the malfunction. Meaning of Malfunction Indicator Lamp (MIL)   Page 01
-3 .  
5) DTC is stored upon appropriate signal from airbag control module, also during output Diagnostic Test Mode (DTM) of the 
airbag system.  
Pa
ge 48 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2