1996 AUDI A4 ECO

01-75


Engine Control Module
(ECM) -J192- faulty

- Replace and code engine control module page 01
-265
erase DTC
memory and test drive check DTC memory
Note:
The malfunction "P0337 / 16721" is set at an engine speed between 25 RPM and 400 RPM as soon as no crankshaft sensor
signal is recognized for longer than 3 sec.
Pa
ge 102 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-77


EGR vacuum regulator solenoid valve -N18- sticks
in closed position

- Check EGR vacuum regulator solenoid valve -N18-
page 24
-67


Malfunction cause found: Yes
No

- Erase DTC memory, test drive and after test drive, check
DTC memory again

EGR valve sticks in closed position

- Check mechanical EGR valve page 24
-70

Malfunction cause found: Yes


- Erase DTC memory, test drive and after test drive, check
DTC memory again
Notes:

Recognition condition for the malfunction "P0401 / 16785" (mech. valve continuously closed) is a coolant temperature over
72 C (162 F), an open idle switch, a throttle angle less than 42.5 , a vehicle speed between 70 km/h and 105 km/h (44
and 66 mph), an EGR duty cycle greater than 50%, an engine speed between 1500 RPM and 3300 RPM and an engine
load between 23% and 60%. If all these conditions are fulfilled and the EGR temperature signal is less than 50 C (122
F) for longer than 34 sec, the malfunction "P0401 / 16785" is set.
Pa
ge 104 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-83

Output on GST and/or on
VAG 1551 scan tool Possible malfunction cause

Malfunction repair
P0452 / 16836
Evaporative Emission
Control System Pressure
Sensor Low Input Harness connector on sensor for EVAP
canister -G172- (differential pressure sensor)
loose or corroded due to moisture in the
harness connector

- Check harness connector for tight fit
and contact corrosion, if necessary
reconnect and/or clean

Malfunction cause found: Yes
No

- Erase DTC memory, test drive and
after test drive, check DTC memory
again
MIL Status:
MIL lights up immediately Wiring connection to sensor for EVAP
canister -G172- (differential pressure sensor)
faulty, or sensor -G172- faulty

- Check sensor for EVAP canister -
G172- (differential pressure sensor)
page 24
-61


Malfunction cause found: Yes
No

- Erase DTC memory, test drive and
after test drive, check DTC memory
again
For troubleshooting
Display group 030
Engine Control Module (ECM) -J192- faulty

- Replace and code engine control
module page 01
-265
erase DTC
memory and test drive check DTC
memory
Note:
The malfunction "P0542 / 16836" is set as soon after engine start as the differential pressure sensor signal is less than 0.1 V
Pa
ge 111 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-84

Output on GST and/or on
VAG 1551 scan tool Possible malfunction cause

Malfunction repair
P0453 / 16837
Evaporative Emission
Control System Pressure
Sensor High Input Harness connector on sensor for EVAP
canister -G172- (differential pressure sensor)
loose or corroded due to moisture in the
harness connector

- Check harness connector for tight fit
and contact corrosion, if necessary
reconnect and/or clean

Malfunction cause found: Yes
No

- Erase DTC memory, test drive and
after test drive, check DTC memory
again
MIL Status:
MIL lights up immediately Wiring connection to sensor for EVAP
canister -G172- (differential pressure sensor)
faulty, or sensor -G172- faulty

- Check sensor for EVAP canister -
G172- (differential pressure sensor)
page 24
-61


Malfunction cause found: Yes
No

- Erase DTC memory, test drive and
after test drive, check DTC memory
again
For troubleshooting
Display group 030
Engine Control Module (ECM) -J192- faulty

- Replace and code engine control
module page 01
-265
erase DTC
memory and test drive check DTC
memory
Note:
The malfunction "P0453 / 16837" is set as soon after engine start as the differential pressure sensor signal is greater than 5.0
Pa
ge 113 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-85

Output on GST and/or on
VAG 1551 scan tool Possible malfunction cause

Malfunction repair
P0461 / 16845
Fuel Lever Sensor Circuit
Range/Performance Wiring connection between Engine Control
Module (ECM) -J192- and instrument panel
insert faulty

- Check fuel level signal page 24
-
107


Malfunction cause found: Yes
No

- Erase DTC memory, test drive and
after test drive, check DTC memory
again
MIL Status:
Malfunction not displayed by
MIL Malfunction on instrument cluster or fuel
level sensor

Repair Manual, Electrical
Equipment - Check instrument cluster
For troubleshooting Display
group 027
Malfunction cause found: Yes


- Erase DTC memory, test drive and
after test drive, check DTC memory
again
Note:
The malfunction "P0461 / 16845" is set with ignition on as soon as a voltage signal over 10.8 V is recognized for longer than
15 sec.
Pa
ge 115 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-87

Output on GST and/or on
VAG 1551 scan tool Possible malfunction
cause
Malfunction repair
P0605 / 16989
Internal Control Module Read
Only Memory (ROM) Error
(Module Identification Defined
by SAE J1979) Engine Control Module
(ECM) -J192- faulty

- Replace engine control module code vehicle
erase DTC memory and test drive check DTC
memory
MIL Status:
MIL lights up immediately Note:
The malfunction type "control module faulty" is set in the ROM/RAM or EEPROM when malfunctions are recognized.
Pa
ge 117 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-88

Output on GST and/or on
VAG 1551 scan tool Possible malfunction cause

Malfunction repair
P0706 / 17090
Transmission Range Sensor
Circuit Range/Performance Engine control module incorrectly coded

- Cause: the vehicle is equipped with
manual transmission, but was coded
for vehicle with automatic
transmission.
- Remedy: code vehicle correctly
according to Coding Table

Malfunction cause found: Yes
No

- Erase DTC memory, test drive and
after test drive, check DTC memory
again
MIL Status:
Malfunction not displayed by
MIL Automatic transmission: faulty wiring
connection between Engine Control Module
(ECM) -J192- and multi-function Transmission
Range (TR) switch -F125-

- Check gear recognition signal
page 24
-99

For troubleshooting
Display group 004
Malfunction cause found: Yes
No

- Erase DTC memory, test drive and
after test drive, check DTC memory
again

Automatic transmission: malfunction of
multi-function Transmission Range (TR) switch
-F125-

Repair Manual, 5 Spd. Automatic
Transmission 01V On Board Diagnostic (OBD), Repair Group 01
- Check multi-function Transmission
Range (TR) switch -F125-

Malfunction cause found: Yes

Pa
ge 118 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-89

Output on GST and/or
on VAG 1551 scan
tool Possible malfunction cause

Malfunction repair
P0707 / 17091
Transmission Range
Sensor Circuit Low
Input Wiring connection between Engine Control
Module (ECM) -J192- and multi-function
Transmission Range (TR) switch -F125- on
automatic transmission faulty

- Check gear recognition signal page 24
-99


Malfunction cause found: Yes
No

- Erase DTC memory, test drive and
after test drive, check DTC memory
again
MIL Status:
Malfunction not
displayed by MIL Malfunction on multi-function Transmission
Range (TR) switch -F125- of automatic
transmission

Repair Manual, 5 Spd. Automatic
Transmission 01V On Board Diagnostic (OBD), Repair Group 01, Electrical testing

- Check multi-function Transmission
Range (TR) switch -F125-
For troubleshooting
Display group 004
Malfunction cause found: Yes


- Erase DTC memory, test drive and
after test drive, check DTC memory
again
Pa
ge 120 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1