Page 8 of 16
26-36
 
    
 Electrical Wiring Diagrams, Troubleshooting & Component Locations   
 Repair Manual, Fuel Supply System, Repair Group 20
   
Checking activation  
Check wire connection from terminal 1 of connector via fuse S234 (in 
fuse holder, socket 34) to Fuel Pump (FP) relay for open circuit: Check Fuel Pump (FP) relay 
    
-  Connect VAG1527B voltage tester between terminals 1 and 2 using 
test leads from VAG1594A. 
-  Connect VAG1551 scan tool.
-  Initiate output Diagnostic Test Mode (DTM) and activate Secondary Air 
Injection (AIR) solenoid valve -N112-. 
Output Diagnostic Test Mode Secondary Air Inj. Solenoid Valve -N112
    
Indicated on display  
 
LED must blink.
Pa
ge 8 of 16 Secondar
y air s
ystem, checkin
g (en
gine code ATW
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.26.2 
     
        
        Page 11 of 16
26-39
       Installation location:  
     
       Repair Manual, 1.8 Liter 4-Cyl. 5V Turbo Fuel 
Injection & Ignition, Repair Group 24        
-  Initiate output Diagnostic Test Mode (DTM) and 
activate Secondary Air Injection (AIR) pump 
relay -J299-.  
    
A - If relay does not trigger:  
B - If relay triggers, but Secondary Air Injection (AIR) pump does not run:   
The Secondary Air Injection (AIR) pump relay (in 3-socket relay 
carrier in the E-box, at left in plenum chamber, position 2) must 
trigger and the Secondary Air Injection (AIR) pump motor -V101- 
must run in intervals 
-  Check voltage supply of Secondary Air Injection (AIR) relay   Page 
26
-40
 . 
-  Checking activation of Secondary Air Injection (AIR) relay   Page 26
-
42
 . 
-  Check voltage supply for Secondary Air Injection (AIR) pump   Page 
26
-43
 . 
Pa
ge 11 of 16 Secondar
y air s
ystem, checkin
g (en
gine code ATW
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.26.2 
     
        
        Page 13 of 16
26-41
 
    
If specified value is not obtained:  -  Connect multimeter for voltage measurement as follows.3-socket relay carrier in E-box, plenum 
chamber, position 2  
terminal  
Measure to  
  
4   Engine Ground 
(GND)  
-  Operate starter briefly. 
 
Specified value: approx. battery voltage
-  Perform the following tests marked with dots:
    
 Electrical Wiring Diagrams, Troubleshooting & Component Locations   Check fuse S234 (in fuse holder, position 34). Check wire connection from Secondary Air Injection (AIR) pump relay 
-J299- (in 3-socket relay carrier in E-box, plenum chamber) via fuse 
S234 (in fuse holder, position 34) to Fuel Pump (FP) relay for open 
circuit: 
Pa
ge 13 of 16 Secondar
y air s
ystem, checkin
g (en
gine code ATW
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.26.2