13-46
Crankshaft, removing and
installing Note:
For engine disassembly and assembly, mount
engine to an assembly stand using VW540 holding
fixture.
1 -
Main bearing shells 1, 2, 4 and 5
Install shell without lubrication groove in
main bearing cap Install shell with lubrication groove in
cylinder block Do not interchange used main bearing
shells (mark accordingly)
2 -
Main bearing cap bolts Always replace65 Nm (48 ft lb) + additional 1/4 turn (90 )To measure radial play in crankshaft,
tighten to 65 Nm (48 ft lb) but not any
further
3 -
Main bearing caps Bearing cap 1: belt pulley sideRetaining tabs for cylinder block/bearing
cap must overlap
Pa
ge 1 of 8 Crankshaft, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.13.3
