30-20
Fig. 1 Installing clutch slave cylinder
- Before installing, coat contact surface of clutch release lever plunger
with thin layer of copper grease, e.g. Z 381 351 TE.
- Before installing clutch slave cylinder in transmission, coat boot area -
a- with G 052 150 A2 lithium grease.
- Guide clutch slave cylinder into bore of transmission housing without
large sideways deviation from direction of motion of plunger.
Notes: - Attach bracket -3- for pressure line -1-.
If clutch slave cylinder -4- is inserted crooked, there is a possibility that
the plunger will be inserted past the clutch release lever. Pre-load the clutch slave cylinder enough so that the mounting bolt
can be easily installed.
- Install mounting bolt -2-.
- Install hex bolt with D 185 400 A2 locking fluid and tighten to 25 Nm
(18 ft lb).
If socket-head bolt is used, it is self-locking: always replace and tighten
to 20 Nm (15 ft lb).
Pa
ge 5 of 13 Clutch release mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.30.2
