Page 6 of 23
01-16
 
  
 Repair Manual, Fuel Injection & Ignition, Repair 
Group 01    11 - 
Throttle Position (TP) sensor -G69- 
Location  page 01
-30
 ,   Fig. 13
The TP sensor signal will be checked via 
On Board Diagnostic (OBD) The TP sensor signal is transmitted to the 
transmission control module via the engine 
control module. The signal can only be 
checked in measured value block   Page 01
-186
 . If OBD indicates a malfunction in 
the TP sensor, perform OBD for the Engine 
Control Module. 
Pa
ge 6 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2 
     
        
        Page 13 of 23
01-23
 
    
Location: in electronics box (E-box) in plenum chamber (left side).  
ECM, removing and installing   
 Repair Manual, Fuel Injection & Ignition, Engine, Groups 01, 23 or 24    Fig. 4  Engine Control Module (ECM)
Pa
ge 13 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2 
     
        
        Page 22 of 23

01-32
 
    
Engines without E-Gas: 
The kick-down switch is integrated in the accelerator cable in the plenum 
chamber, behind bulkhead -arrow-.  
Engines with E-gas: 
The kick-down switch is integrated in the throttle position sensor and 
Sensor 2 for Accelerator Position (-G79-, -G185-).  
A learning procedure must be performed for the shift point of the kick 
down switch for engines with E-gas. If the throttle position sensor (-G79-, -
G185-) is removed, exchange the engine control module or disconnect 
the battery. Learning procedure can be found in   Repair Manual, Fuel 
Injection & Ignition, Repair Group 24; Kick down shift point, checking.  
Kick-down switch, removing and installing  
 Repair Manual, Fuel Supply System, Repair Group 20, accelerator pedal mechanism, repairing Front and All Wheel Drive
    Fig. 16  Kick-down switch -F8-
-  To remove and install the kick down switch, the accelerator cable must 
be removed and installed and then adjusted or the throttle position 
sensor (38-G79-, -G185-) must be replaced. 
Pa
ge 22 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2