39-5
Installing
- Fill space between sealing lip and dust lip with
gear oil.
- Lightly oil outer circumference of seal.
Note:
If reinstalling an old drive flange, the new seal must be pressed in about
6.5 mm (0.256 in.), so that the new seal does not sit on the running
surface of the old seal. - Drive in right-hand drive flange seal 5.5 mm (0.216 in.) below outer
transmission housing surface using VW195 arbor, without canting.
Note:
If reinstalling an old drive flange, the new seal must be pressed in about
6.5 mm (0.256 in.), so that the new seal does not sit on the running
surface of the old seal. - Drive in left drive flange seal 5.5 mm (0.216 in.) below outer
transmission housing surface using VW195, without canting.
- Install drive flange using VW295 needle bearing drift.
- Bolt drive axle on drive flange.
Pa
ge 6 of 7 Drive flan
ge seal, re
placin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.1
39-6
- Install drive axle heat shield.
- Check transmission oil level Page 34
-38
.
Tightening torques
Component
Nm (ft lb)
Drive axle to drive
flange M8 40 Nm (30 ft
lb)
M10 80 Nm (59 ft
lb)
Heat shields for drive axles 23 Nm (17 ft
lb)
Pa
ge 7 of 7 Drive flan
ge seal, re
placin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.1
