STEERING COLUMN INSPECTION AND
REPLACEMENT
1. INSPECT KEY CYLINDER
Check that the steering lock mechanism operates properly.
2. IF NECESSARY, REPLACE KEY CYLINDER
(a) Place the ignition key at the ACC position.
(b) Push down the stop pin with a screwdriver and pull out the
key cylinder.
(c) Install a new cylinder.
HINT: Make sure the ignition key is at the ACC position.
3. IF NECESSARY, REPLACE UNLOCK WARNING SWITCH
AND IGNITION SWITCH
(a) Remove the 2 screws and warning switch.
(b) Remove the 2 screws and ignition switch.
(c) Install a new ignition switch with the 2 screws.
(d) Install a new warning switch with the 2 screws.
4. A/T:
INSPECT KEY INTER LOCK SOLENOID
(See page AT1±30)
5. A/T:
IF NECESSARY, REPLACE KEY INTERLOCK SOLENOID
(a) Remove the 2 screws and solenoid.
(b) Install a new solenoid with the 2 screws.
6. IF NECESSARY, REPLACE MAIN SHAFT BUSHING
(a) Using a screwdriver, depress the 3 projections on the busing
to release the bushing, then remove the bushing.
NOTICE: If the bushing interior is worn, install a new
bushing.
(b) Align the projections on a new bushing with the holes in the
lower tube. Install the bushing until the projections are firmly
engaged in the holes in the lower tube.
STEERING COLUMN ASSEMBLY
NOTICE: When using a vise, do not overtighten it.
1. APPLY MOLYBDENUM DISULPHIDE LITHIUM BASE
GREASE (See page SR±13)
2. INSTALL MAIN SHAFT BUSHING STOPPER AND MAIN
SHAFT COLLAR
± STEERINGTILT STEERING COLUMNSR±17
