Page 88 of 354

Turn Signal and Lane Change Indicator
a
0
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.
A green arrow on the
instrument panel will flash
in the direction
of the turn
or lane change.
To signal a lane change, just raise or lower the lever
until the green arrow
starts to flash. Hold it there until
you complete your lane change. The lever
will return by
itself when you release it.
As you signal a turn or a lane change, if the arrows don’t
flash but just stay on, a signal bulb may be burned out
and other drivers won’t
see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the green arrows don’t go on at all when you
signal a turn, check the fuse (see “Fuses and Circuit
Breakers” in the Index) and for burned-out bulbs.
,: I
1“‘ ..
2-33
ProCarManuals.com
Page 100 of 354

Front Readinmap Lamps (Option)
If your vehicle has a sunroof, it will have a rearview
mirror with lamps built in. The lamps
go on when you
open the doors. When the doors
are closed, turn the
lamps on and
off with the switches located below the
face
of the mirror.
Rear Reading Lamps (Option)
A
I1
These overhead lamps and the interior courtesy lamps
will come on when you open the doors.
To
turn on a reading lamp when the doors are closed,
press the button. Press it again to turn
off the lamp.
Trunk Lamp
This lamp comes on when you open-your trunk.
Dome Lamp Bulb Change
It may not be obvious how to change your dome lamp
bulb. Here’s how: Grasp the center front and center rear
portion of the housing and squeeze firmly but gently.
The housing should pop off.
If this doesn’t work, you may need to use a small,
flat-head screwdriver under the side of the housing to
help pry it
off.
Battery Rundown Protection
Your Pontiac is equipped with a Battery Rundown
Protection feature designed to protect
your vehicle’s
battery.
When any interior lamp (trunk, reading, footwell or
glove box) is left on when the ignition is turned off, the
Battery Rundown Protection system will automatically
shut the lamp
off after 20 minutes. This will avoid
draining the battery.
-f ..
I-$ ’:. . ,.
2-45
ProCarManuals.com
Page 120 of 354

Oil Warning Light
If you have a problem with your oil, this light may
stay on after you start your
engine, or come on when
you
are driving. This
indicates that oil is not
going through your engine
quickly enough to keep it
lubricated.
The engine could be low on oil, or could have some
other oil problem. Have it fixed right away.
The oil light could
also come on in three other
situations:
When the ignition is on but the engine is not running,
the light will come on as a test to show you it is
working, but the light
will go out when you turn the
ignition
to START. If it doesn’t come on with the
ignition on, you may have a problem with the fuse or
bulb. Have it fixed right away.
0 Sometimes when the engine is idling at a stop, the
0 If you make a hard stop, the light may come on for a
light may blink on and off. This is normal.
moment. This is normal.
NOTICE:
Damage to your engine from neglected oil
problems can be costly and is not covered by your
warranty.
2-65
ProCarManuals.com
Page 179 of 354

When towing a trailer, the green arrows on your
instrument panel will flash for turns even
if the bulbs on
the trailer
are burned out. Thus, you may think drivers
behind you are seeing your signal when they
are not. It’s
important to check occasionally to be sure the trailer
bulbs
are still working.
Driving On Grades
Reduce speed and shift to a lower gear before you start
down a long or steep downgrade. If you don’t shift
down, you might have to use your brakes
so much that
they would get hot and no longer work well.
On a long uphill grade, use the highest gear possible. If
you cannot maintain posted speeds, driving at a lower
speed may help avoid overheating your engine and
transaxle.
If you have a manual transaxle with fifth gear, it’s better
not
to use fifth gear. Just drive in fourth gear (or, as you
need to, a lower gear).
Parking on Hills
You really should not park your vehicle, with a trailer
attached, on a
hill. If something goes wrong, your rig
could
start to move. People can be injured, and both
your vehicle and the trailer can be damaged.
But if you ever have to park your rig on a hill, here’s
how to do it:
1. Apply your regular brakes, but don’t shift into
PARK (P) yet, or into gear for a manual transaxle.
2. Have someone place chocks under the trailer wheels.
3. When the wheel chocks are in place, release the
regular brakes until the chocks absorb the load.
4. Reapply the regular brakes. Then apply your parking
brake, and then shift to PARK (P), or REVERSE (R)
for a manual transaxle.
5. Release the regular brakes.
4-36
ProCarManuals.com
Page 242 of 354
Battery
Every new Pontiac has a Delco Freedom@ battery. You
never have to add water to one of these. When it’s time
for a new battery, we recommend a Delco Freedom@
battery. Get one that has the replacement number shown
on the original battery’s label.
Vehicle Storage
If you’re not going to drive your vehicle for 25 days or
more,
take off the black, negative (-) cable from the
battery. This will help keep your battery from running
down.
Contact your dealer to learn how to prepare your vehicle
for longer storage periods.
Jump Starting
For jump starting instructions, see “Jump Starting” in
the Index.
Halogen Bulbs
n burst if you drop or scratch the bulb.
6-31
ProCarManuals.com
Page 243 of 354
Headlamp Bulb Replacement
For the type of bulb, see “Replacement Bulbs” in the
Index.
1. On the driver’s side only, unscrew the butterfly
fastener. Then lift the plate.
Both Sides:
2. Twist the bulb assembly counterclockwise 1/6 turn
and pull out the bulb assembly.
6-32
ProCarManuals.com
Page 244 of 354
3. Unclip the bulb assembly from the wiring harness.
4. Reverse steps 1-3 to replace the bulb assembly and
headlamp housing.
Taillamp Bulb Replacement
For the type of bulb, see “Replacement Bulbs” in the
Index.
1. Pull back the trunk trim.
2. Carefully push one end of the plastic taillamp brace
in while pulling the brace toward the front of the
vehicle.
6-33
ProCarManuals.com
Page 245 of 354
3. Gently wiggle the bulb out of the socket. Windshield Wiper Blade Replacement
Replacement blades come in different types and are
removed in different ways. Here’s how to remove the
type with a release clip:
1. Pull the windshield wiper arm away from the
windshield.
4. Replace the bulb.
5. Reverse the steps to reassemble the taillamp.
Fog Lamp Bulb Replacement
Don’t change your fog lamp bulbs unless you have the
proper aiming equipment. See your Pontiac dealer
if you
have any further questions. 2. Lift the release clip with a screwdriver and pull the
3. Push the new wiper blade securely on the wiper arm.
blade assembly off the wiper arm.
6-34
ProCarManuals.com