1995 PONTIAC FIREBIRD light

NOTICE:
Spinning your wheels can destroy parts of your
vehicle as well
as the tires. If you spin the wheels
too fast while shifting your transmission back
and forth, you can destroy your transmission.
For information about using tire chains on your vehicle,
see “Tire Chains” in the Index.
Rocking your vehicle to get it out:
First, turn your steering wheel left and right. That will
clear the area around your front wheels. If your vehicle
has traction control, you should turn the system
off. (See
“Traction Control System” in the Index.) Then shift
back and forth between REVERSE (R) and
a forward
gear (or with a manual transmission, between FIRST
(1)
or SECOND (2) gear and REVERSE), spinning the
wheels as little as possible. Release the accelerator pedal
while you shift, and press lightly on the accelerator
pedal when the transmission is in gear.
If that doesn’t
get you out after a few tries, you may need to be towed
out. If you do need to be towed out, see “Towing Your
Car” in the Index.
ProCarManuals.com

Before closing the hood, be sure all the filler caps are
on.
Then just pull the hood down and close it firmly.
Engine Oil
LOW
OIL
If the LOW OIL light on the instrument panel comes on,
it means you need to check your engine oil level right away. For more information, see
LOW OIL in the Index.
You should check your engine oil level regularly; this is
an added reminder.
It’s a good idea to check your engine oil every time you
get fuel.
In order to get an accurate reading, the oil must
be warm and the vehicle must be on level ground.
ProCarManuals.com

Engine Coolant
The following explains your cooling system and how to
add coolant when it is low. If you have a problem with
engine overheating or if you need to add coolant to your
radiator, see “Engine Overheating” in the Index.
The proper coolant for your Pontiac will:
Give freezing protection down to -34°F (-37 O C).
Give boiling protection up to 262 “F ( 128 ” C).
Protect against rust and corrosion.
Help keep the proper engine temperature.
Let the warning lights work as they should.
What to Use
Use a mixture of one-half clean water (preferably
distilled) and one-half antifreeze that meets “GM
Specification
1825-M,” which won’t damage aluminum
parts.
You can also use a recycled coolant conforming to
GM Specification 1825-M with a complete coolant flush
and refill. If you use this mixture, you don’t need to add
anything else.
NOTICE:
If you use an improper coolant mix, your engine
could overheat and be badly damaged. The
repair cost wouldn’t be covered by your warranty.
Too much water in the mix can freeze
and crack the engine, radiator, heater core and
other parts.
I 6-30
ProCarManuals.com

Adding Coolant 5.7L LTl Engine Only
r ----
If this light comes on, it means you’re low on engine
coolant.
To Check Coolant
When your engine is cold, check the dipstick on the cap
of the coolant recovery tank. The coolant level should
be at
COLD, or a little higher. When your engine is
warm, the level on the dipstick should be up to the HOT,
or a little higher.
To Add Coolant to the Recovery Tank
If you need more coolant, add the proper mix at the
coolant
recovery tank, but only when your engine is
cool. If the tank is very low or empty, also add coolant
to the radiator, see “Engine Overheating” in the Index
for information.
6-31
ProCarManuals.com

Some driving conditions or climates may cause a brake
squeal when the brakes are first applied or lightly
applied, This does not mean something is wrong with
your brakes.
If you have rear drum brakes, they don’t have wear
indicators, but if you ever hear a rear brake rubbing
noise, have the rear brake linings inspected.
Also, the
rear brake drums should be removed and inspected each
time the tires are removed for rotation or changing.
When you have the front brakes replaced, have the rear
brakes inspected, too.
Brake linings should always be replaced as complete
axle sets.
Brake Pedal Travel
See your dealer if the brake pedal does not return to
normal height, or
if there is a rapidincrease in pedal
travel.
This could be a sign of brake trouble.
Brake Adjustment
Every time you make a moderate brake stop, your disc
brakes adjust for wear. If you rarely make a moderate or
heavier stop, then your brakes might not adjust correctly.
If you drive in that way, then -- very carefully -- make
a few moderate brake stops about every 1,000 miles
(1 600 km), so your brakes will adjust properly.
If your brake pedal goes down farther than norrid, your
rear drum brakes may need adjustment. Adjdsi them by
backing up and firmly applying the brakes a few times.
Replacing Brake System Parts
The braking system on a modern vehicle is complkx. Its
many parts have to be of top quality and wokk well.
together if the vehicle is to have really good briking.
Vehicles
we design and test have top-quality GM brake
parts
in them, as your Pontiac does when it is new.
When you replace parts of your braking system, -- for
example, when your brake linings wear down dnd yob .
have to have new ones put in -- be sure you get new
genuine
GM replacement parts. If you don’t, yuia
brakes
may no longer work properly. For em$le, if
someone puts in brake linings that are wrong
€& ybuf
vehicle, the balance between your front and re& btakes
can change
-- for the worse. The braking perfoi-mhnce ,
you’ve come to expect can change in many other way$ if
someone puts in the wrong replacement brake parts.
,& b .. - i*
t
-
,%
ProCarManuals.com

If a ring forms after spot cleaning, clean the entire
Using Foam-Type Cleaner on Fabric
area immediately or it will set.
0
0
0
0
0
0
0
0
0
0
Vacuum and brush the area to remove any loose dirt.
Always clean a whole trim panel or section. Mask
surrounding trim along stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner following the
directions on the container label.
Use suds only and apply with a clean sponge.
Don’t saturate the material.
Don’t rub it roughly.
As soon as you’ve cleaned the section, use a sponge
to remove the suds.
Rinse the section with a clean, wet sponge.
Wipe
off what’s left with a slightly damp paper towel
or cloth.
Then dry
it immediately with a blow dryer or a heat
lamp.
-
+
NOTICE:
Be careful. A blow dryer may scorch the fabric.
0 Wipe with a clean cloth.
Using Solvent-Type Cleaner on Fabric
First, see if you have to use solvent-type cleaner at all.
Some spots and stains will clean
off better with just
water and mild soap.
If you need to use a solvent:
0
0
Gently scrape excess soil from the trim material with
a clean, dull knife
or scraper. Use very little cleaner,
light pressure and clean cloths (preferably
cheesecloth). Cleaning should start at the outside of
the stain, “feathering” toward the center. Keep
changing to a clean section of the cloth.
When you clean a stain from fabric, immediately dry
the area with a blow dryer to help prevent a cleaning
ring. (See the previous NOTICE.)
6-57
ProCarManuals.com

!
Special Cleaning Problems
Greasy or Oily Stains
Stains caused by: grease, oil, butter, margarine, shoe
polish, coffee with cream, chewing gum, cosmetic
creams, vegetable oils, wax crayon, tar and asphalt can
be removed as follows:
@ Carefully scrape off excess stain.
9 Fallow the solvent-type instnxctions described
?, Sboe palish, wax crayon, tar and asphalt will stain if
left on a vehicle seat fabric. They should be removed
as &on as possible. Be careful, because the cleaner
will dissolve them and may cause them to spread.
earlier.
t
Non-Greasy .. Stains
Stains caused by: catsup, coffee (black), egg, fruit, fruit
juice,
nrlilk, soft drinks, wine, vomit, urine and blood can
he removsd as follows:
Carefully scrape off excess stain, then sponge the
If a stain remains, follow the foam-type instructions
sailed &pa with cool water.
desciibed evlier.. ..
If an odor lingers after cleaning vomit or urine,
treat the area with a waterhaking soda solution:
1 teaspoon (5 ml) of baking Soda to 1 cup (250 ml)
of lukewarm water.
0 If needed, clean lightly with solvent-type cleaner.
Combination Stains
Stains caused by: candy, ice cream, mayonnaise, chili
sauce and unknown stains can be removed as follows:
0 Carefully scrape off excess stain, then clean with
cool water and allow to dry.
If a stain remains, clean it with solvent-type cleaner.
Cleaning Vinyl
Use warm water and a clean cloth.
0 Rub with a clean, damp cloth to remove dirt. You
Things like tar, asphalt and shoe polish will stain if
may have to do it more than once.
you don’t get them
of€ quickly. Use a clean cloth and
a solvent-type vinyl cleaner.
ProCarManuals.com

Fuses tu~d Circuit Breakers
The other is in the engine CoIfipartment. Open the cover
on either of the boxes to expose the fuses.
me wiring circuits in your vehicle are protected from
shci'rl
circ&b by a combination of fuses, circuit breakers,
and fusible thermal
links in the wiring itself. This
greatly redtices the chance of fires caused by electrical
problems.
Thkre are two hse centers on your vehicle. One is in the
left side ok your instrument panel.
Look at the silver-colored band inside the fuse. If the
band
is broken or melted, replace the fuse. Be sure you
replace a bad
fuse with a new one of the correct size.
If you ever have a problem on the road and don't have a
spare
fuse, you can bortow one. Just pick some feature
of your car that you can get along without-like the
radio or cigarette lighter-ind use ite fuse,
if it is the
size
you need. ReplaGe it as soon as you can.
ProCarManuals.com