1995 PONTIAC FIREBIRD lock

Voltmeter If you idle your engine for a while, the voltmeter
reading might move into the yellow zone.
If the reading
stays
in the yellow zone while you are driving, you may
have a problem with the electrical charging system.
Have it checked.
While the voltmeter reads in the yellow
zone, your battery may not be able to power certain
electrical accessories, like
ABS. (If this happens, your
ABS INOP light will come on. See “Anti-Lock Brake
System Warning Light” in this part.)
If you must drive a short distance with the voltmeter
reading in a warning zone,
turn off all your accessories,
including your comfort control and audio systems.
You can read battery voltage on your voltmeter. If it
reads less than
11 volts or more than 16 volts while your
engine
is running, and it stays there, you may have a
problem with the electrical charging system. Have it
checked right away. Driving with the voltmeter reading
in a warning zone could drain your battery.
2-78
ProCarManuals.com

NOTICE:
Don’t lower the top if it is damp or wet. When
the top is down, trapped water can cause stains,
mildew and damage to the inside of your car. Be
sure to dry off the top before you lower
it.
NOTICE:
It is not recommended to lower the top if your
car is out in cold weather,
0°F (-18OC) or lower.
NOTICE:
Before lowering the convertible top into the
storage area, be sure there are no objects in the
way of the folded, stored top. The weight of
a
stored top on items in. the storage area will cause
the convertible top back glass to break.
2. Unlock the fiont of the convertible top by pushing on
the smaller part
of the latch, then pulling down on the
larger part
of the latch. Be sure the hook on the iatch
that attaches into the hole at the windshield releases.
2-81
ProCarManuals.com

5. Push and hold
the top of the
convertible top switch. ~~~
6. Pull down on the latches and align hooks with
holes.
hsh forward on the larger part of the latch until it
clicks.
Do not force the latch. If it is hard to lock, the
top is not properly aligned.
If your vehicle suffers a power loss, such as a dead
battery, you
can still raise or lower the top manually by
rotating the valve in the left side of the
trunk.
Open the trunk and find the tab along the left side trim
panel. Lift up the tab and turn the valve clockwise to
release the hydraulic pressure.
Turn the ignition key to
the
LOCK position. You can now raise or lower your top
manually. Be
sure to close the valve after installing your
top
so you can raise or lower it electronically later.
2-85
ProCarManuals.com

Audio Systems
Your Delco@ audio system has been designed to operate
easily and give years of listening pleasure. But you will
get the most enjoyment out of it if you acquaint yourself
with it first. Find out what
your Delco@systerh can do
and how to operate
all its controls, to be sure you’re
getting the most out of the advanced engineering that
went into it.
If you have power door locks, your vehicle has a feature
called Retained Accessory Power (RAP). With RAP you
can play your audio system even after the ignition is
off.
See the Index under “Retained Accessory Power.”
Setting the Clock
The clock may be set with the ignition on or off.
1. Press and hold HR until the correct hour appears.
2. Press and hold MIN until the correct minute appears.
NOTE: There will be a two second delay before the
clock goes into the time-set mode, and the colon in the
display will blink while in this mode’.
AmM Stereo Radios with Cassette Tape
Player or Compact
Disc Player
If your Pontiac has a radio with either a cassette tape
player, a compact disc player or a graphic equalizer, the
instructions below will explain how
to use the radio. For
other features,
see the instructions for the feature your
radi.0 has.
To Play the Radio
Push POWER to turn the system on or off.
VOLUME: Turn the VOLUME knob to adju.st the
sound.
RECALL: Press RECALL to recall the station being
played or the clock display. You can also press
RECALL
to display the time when the ignition is off.
Finding a Station
AM-FM: Press A” to get AM, FMI or FM~. The
lighted display shows yout selection.
TUNE: Press TUNE to release the knob. Tuk the knob
to choose radio stations. Push TUNE back in to store it
when not tuning.
ProCarManuals.com

If E and a number appears in the radio display, an error
has occurred and the cassette
or compact disc will not
play temporarily.
If the error occurred while trying to play a cassette tape,
the following conditions may have caused the error:
1. The cassette tape is tight and the cassette player
cannot turn the hubs of the cassette tape.
2. E10 may be displayed.
Hold the cassette with the open end down and try
turning right hub counter clockwise with a pencil.
0 Flip the tape over and repeat same procedure.
If the hubs do not turn easily, your cassette tape may be
damaged and should not be used in the cassette player.
Try a new tape to make sure that your cassette player
is working properly.
If the cassette tape is broken, Ell may be displayed.
Check to see if your tape is broken.
Try a new cassette tape.
This feature may not work well with certain types of
adaptors for add-on CD players. If there is not tension
on the reels of the cassette player, it will sense that the
adaptor is a broken tape and eject it.
CLN (Clean): If this message appears on the display
when you insert your cassette tape, your cassette player
needs to be cleaned. It will still play cassette tapes, but it
should be cleaned to prevent damage to your cassette
tapes and the cassette tape player. See “Care,of Your
Cassette Tape Player” in the Index. After you: have
cleaned the cassette tape player, press and hold the
EJECT button for
5 seconds to reset the CLN indicator.
The radio will display
“---” to show that the clean
feature has been reset.
‘It
3-9
ProCarManuals.com

THEFTLOCK
THEF’iZOCK is a security feature for the cassette tape
and compact disc player. It can be used or ignored.
If
igriored, the system functions normally. If it is used,
your system won’t be usable if it’s ever stolen. When the
system is active, the indicator light will flash while the
ignition
is off.
Setting Your Security Code
The instructions below tell you how to enter a security
code into the system. If your vehicle loses battery power
for any reason, you must enter the security code again
before the system will turn
on.
1. Write down any number from 000 to 1999 and keep
2. Turn the ignition switch to the ACC or RUN
3. Turn the radio off.
4. Press and hold pushbuttons 1 and 4 together until
it in a safe place.
position.
“- - -” shows on the display. ,’
You are now ready to enter your security code. Don’t
wait more than 15 seconds between steps.
5. Press MIN and “000” will appear on the display.
6. Press MIN again and hold until the last two digits of
7. Press HR until the fist one or two digits of your
your code appear. Release the button.
code appears.
8. Press A” “rEP” will appear on the display.
9. Repeat steps 5 through
7 for verification.
10. Press A” SEC.will appear on the display. This
means that your audio system is secured.
Shutting Off the Theft-Deterrent Feature
If your audio system is secured (SEC shows on the
display) and you wish to disable it, enter
yoiu security
code as .follows, pausing no more than 15 seconds
between steps:
1. Turn the ignition on. Make sure the audio system is
off. The time will show on the display.
2. Press pushbuttons 1 and 4 together until SEC shows
on the display.
3. Press MIN “000” will appear on the display.
4. Press MIN again and hold until the last two digits of
your code appear. Release the button.
‘, \.
3-12 I
ProCarManuals.com

5.
6.
Press HR until the first one or two digits of your How to Change Your Security Code
code appear.
Press
A” If “- - -” shows, you have shut off steps:
You can change your security code by following these
the theft-deterrent feature. If SEC shbws, your audio
system is still secured.
Note: If you lose or forget your security code, see your
dealer for assistance.
Unlocking the Audio System “after a Power Failure
If power is disrupted io the audio system whiie in the
SEC mode, the unit will not work &nd LOC will show
on the display whenever the ignition is on. To unlock the
unit:
1. Press MIN “OW’ will appear on the display.
2. Press MIN again and hold until the iast two digits of
your code appear. Release the button.
3. Press HR until the first one or two digits of your
code appear.
4. Press AM/FM. SEC will appear on the display and
the unit will work.
If LOC shows, the numbers did
not hatch and the unit is still locked.
-
1. Using your old code, follow the directions given
under “Shutting Off the Theft-Deterrent Feature.’’
2. Repeat directions of .“Setting Your Security Code”
with your new security code.
Understanding Radio Reception
FM Stereo
.i‘
FM stereo will give you the best sound. But FM signals
will reach only about
10 to 40 miles (1 6 to 65 km). And,
tall buildings or hills can interfere with
FM signals,
causing the sound to come and go.
AM
The range for most AM .stations is greater than for FM,
especially at night. The longer range, however, can
cause stations to interfere with each other. AM can pick
up noise
from things like storms and power lines. Try
reducing the treble to reduce this noise if you ever get it.
&&
3-13
ProCarManuals.com

Avoid needless heavy braking. Some people drive in
spurts
-- heavy acceleration followed by heavy braking
-- rather than keeping pace with traffic. This is a
mistake. Your brakes may not have time to cool between
hard stops. Your brakes will wear out much faster
if you
do a lot
of heavy braking. If you keep pace with the
traffic and allow realistic following distances, you will
eliminate a lot of unnecessary braking. That means
better braking and longer brake
life.
If your engine ever stops while you’re driving, brake
normally but don’t pump your brakes.
If you do, the
pedal may get harder to push down.
If your engine
stops, you will still have some power brake assist. But
you will use it when you brake. Once the power assist is
used up, it may take longer to stop and the brake pedal
will be harder to push.
Anti-Lock Brakes (ABS)
Your Pontiac has an advanced electronic braking system
that will help prevent a braking skid.
INOP
This light on the
instrument panel will
come on briefly when
you start your vehicle.
When you start your vehicle, or when you begin to drive
away, you may hear a momentary motor or clicking
noise. And you may even notice that your brake pedal
moves a little while this is going on. This is the ABS
system testing itself. If there’s a problem with the
anti-lock brake system, the anti-lock brake system
warning light will stay on or flash.
See “Anti-Lock Brake System Warning Light’’ in the
Index.
4-6
ProCarManuals.com