1995 PONTIAC FIREBIRD service

Brake System Warning Light
Your Pontiac’s hydraulic
B RAKE two parts. If one part isn’t
brake system is divided into
working, the other part can
still work and stop you. For
good braking, though, you
need both parts working
If the warning light comes on, there could be a brake
problem. Have your brake system inspected right away.
This light should come on briefly as you start the
vehicle. If it doesn’t come
on then, have it fixed so it
will be ready to warn you if there’s a problem.
If the light comes on while you are driving, pull off the
road and stop carefully. You may notice that the pedal is
harder to push. Or, the pedal may
go closer to the floor.
It may take longer to stop. If the light is still on, or if the
anti-lock brake system warning light is flashing, have
the vehicle towed for service. (See “Anti-Lock Brake
System Warning Light” and “Towing Your Car” in the
Index.)
The brake system warning light will also come on when
you set your parking brake, and it will stay on if your
parking brake doesn’t release fully. If it stays on after
your parking brake is fully released, it means you have a
brake problem.
2-69
ProCarManuals.com

Anti-Lock Brake System Warning Light
ABS
INOP
With the anti-lock brake system, this light will come on when
you
start your engine and it will stay on for three seconds.
That’s normal.
If the light doesn’t come on, have it fixed so it
will be ready
to warn you if there is a problem.
If the light flashes when you’re driving, you don’t have
anti-lock brakes and there could be a problem with your
regular brakes. Pull
off the road and stop carefully. You
may notice that the pedal is harder to push. Or, the pedal
may go closer to the floor. It may take longer to stop.
Have the vehicle towed for service. (See “Towing Your
Car” in the Index.)
If the anti-lock brake system warning light stays on
longer than normal after you’ve started your engine, turn
the ignition off. Or, if the light comes on and stays on
when you’re driving, stop as soon as possible and
tum
the ignition off. Then start the engine again to reset the
system.
If the light still stays on, or comes on again
while you’re driving, your Pontiac needs service.
If the
light
is on but not flashing and the regular brake system
warning light isn’t
on, you still have brakes, but you
don’t have anti-lock brakes.
2-70
ProCarManuals.com

Malfunction Indicator Lamp (Service Engine Soon Light)
I SERVICE ~
ENGINE
SOON
..
A computer
monitors operation of your fuel, ignition
and emission control systems. This light should come on
when the ignition is on, but the engine
is not running, as
a check to show you it is working. If it does not come on
at
all, have it fixed right away. If it stays on, or it comes
on while
you are driving, the computer is indicating that
you have a problem. You should take your vehicle in for
service soon.
NOTICE:
If you keep driving your vehicle with this light
on, after a while the emission controls won’t
work as well, your fuel economy won’t be as good
and your engine may not run as smoothly. This
could lead to costly repairs not covered by your
warranty.
OBD I1 3.8L Engine (Code K)
Certain vehicles are equipped with a new emission
diagnostic system. You can tell whether your vehicle has
this system by reading our tune-up label located under
the hood.
If the label says OBD 11 on it, the following
instructions apply.
Your Pontiac Firebird is equipped with an onboard
computer which monitors operation of the emission
control system. This system is called OBD
11 (On-
Board Diagnostics-Second Generation) and is intended
to assure that emissions
are at acceptable levels for the
life
of the vehicle, helping to produce a cleaner
environment. The SERVICE
ENGINE SOON light
comes on to indicate when service is required.
Malfunctions often will be indicated by the system
2-74
ProCarManuals.com

before any problem is apparent, which may prevent more serious damage to your vehicle. The system is also
designed to assist your service technician in correctly
diagnosing any malfunction.
The SERVICE ENGINE SOON light should come on,
as
a check to show you it is working, when the ignition
is on and the engine is not running. This light will also
come on during a malfunction in one or two ways:
Light on steady - - indicates a system malfunction
has been detected. Drive the vehicle to the dealer for
service at your first opportunity.
Light Flashing - - indicates a misfire has been
detected which may damage the emission control
system. The damage may be reduced'by lowering the
vehicle speed, reducing the amount of cargo being
hauled or trailered, avoiding hard acceleration, or by
avoiding steep uphill grades.
If these actions are
effective, the light will stop flashing and remain on
steady. Drive the vehicle to a dealer for service.
If
the light continues to flash, stop the vehicle. Wait for
a steady light to come on, then drive the vehicle to
the nearest dealer for service.
These following conditions also may cause the
SERVICE ENGINE
SOON light to come on.
Low Fuel/Out of Fuel - - As the vehicle starts to run out
of fuel the SERVICE ENGINE SOON light may come
on as a result of
an engine misfire. Filling your gasoline
tank should correct this condition. Make sure to install
the gas cap fully. It will require a few driving trips to
turn the light
off.
Poor Quality Fuel - - Be sure to fuel your vehicle with
quality fuel. Your engine may not run efficiently on poor
fuel. Poor fuel may cause stalling, hesitation or misfire.
These conditions may go away when the engine is
warmed-up. However, poor quality fuel may cause the
SERVICE ENGINE SOON light to come
on.
Have a dealer check the vehicle. If no problems are
found, you may want to change to another brand of fuel.
Driving Through Standing Water -- Driving your
vehicle through puddles
of deep standing -w.a&r may
result in a temporary misfire condition. This condition
will usually correct itself- shortly after the electrical
system dries out.
It will require a few driving trips to
turn the light off.
2-75
ProCarManuals.com

1
With the audio system on, insert a disc into the slot with
the label side up.
CD will appear on the display and
track
1 will begin to play.
If the disc comes back out and ERR appears on the
display, it could be that:
0
0
0
0
0
The disc is upside down.
It is dirty, scratched or wet.
There’s too much moisture in the air. If
so wait about
an hour and try it again.
You are driving on a very rough road.
The temperature is too hot or too cold.
To Play a Compact Disc
Your CD player will play the smaller 8 cm (3.2 inch)
compact discs.
No adapter is required for the smaller
CD’s.
If you are driving on a very rough road, the disc may not
play and
ERR may appear on the display. The disc
should start playing when the road gets smoother.
If any error occurs repeatedly or if an error cannot be
corrected, write down the error message and provide it
when you have it serviced.
ProCarManuals.com

Care of Your Cassette Tape Player
A tape player that is not cleaned regularly can cause
reduced sound quality, ruined cassettes, or a damaged
mechanism. Cassette tapes should be stored in their
cases away from contaminants, direct sunlight, and
extreme heat.
If they aren’t, they may not operate
properly
or cause failure of the tape player.
Cassettes are subject to wear and the sound quality may
degrade over time. Always verify that the cassette tape
is in good condition and that the tape player is clean
before obtaining service on your tape player.
Your tape player should be cleaned with every 50 hours
of use to provide optimum performance. Your radio may
display “Cln” to indicate that your have used your tape
player for
50 hours without resetting the tape clean
timer.
If you notice a reduction in sound quality,
regardless of when the tape player was last cleaned, try
playing a different cassette to see if the tape or the tape
player is at fault. If the second cassette results in no
improvement in sound quality, try cleaning the tape
player.
Proper tape player cleaning should be done with a
scrubbing action, nonabrasive cleaner cassette. This is a
wet-type cleaning system that uses a cleaning cassette
with pads which scrub the tape head as the hubs of the
cleaner cassette
turn. To properly clean your tape player,
follow the instructions with the cleaning cassette.
If you
use this type of cleaner, the radio may display an error
and eject the cartridge. This is normal and is the result
of an added feature in the tape player that detects broken
tapes. If an error occurs, you will need to insert the
cleaning cassette at least three times to thoroughly clean
the tape player.
You may also choose a non-scrubbing action, wet-type
cleaner which uses a cassette with a fabric belt to clean
the tape head.
This type of cleaning cassette will not
eject. It may not clean as thoroughly as the scrubbing
type cleaner.
A scrubbing action cleaner is available through your
dealer
(GM Part No. 12344600).
Note: Tape adapter kits for portable CD players will not
work in your cassette player. These adapters will cause
the radio to display an error message and the adapter
cassette will be ejected.
3-15
ProCarManuals.com

The exit speed is usually posted.
Reduce your speed according to your speedometer, not
to your sense of motion. After driving for any distance
at higher speeds, you may tend to
think you are going
slower than you actually are.
Before Leaving on a Long Trip
Make sure you’re ready. Try to be well rested. If you
must
start when you’re not fresh -- such as after a day’s
work
-- don’t plan to make too many miles that First part
of the journey. Wear comfortable clothing and shoes you
can easily drive in.
Is your vehicle ready for a long trip? If you keep it
serviced and maintained, it’s ready to go.
If it needs
service, have it done before starting out. Of course,
you’ll find experienced and able service experts in
Pontiac dealerships all across North America. They’ll
be ready and willing to help if you need it.
Here are some things you can check before a trip:
a
e
a
a
a
e
e
Windshield Washer Fluid: Is the reservoir full? Are
all windows clean inside and outside?
Wiper Blades: Are they in good shape?
Fuel, Engine Oil, Other Fluids: Have you checked
all levels?
Lamps: Are they all working? Are the lenses clean?
Tires: They are vitally important to a safe,
trouble-free trip. Is the tread good enough for
long-distance driving? Are the tires all inflated to the
recommended pressure?
Weather Forecasts: What’s the weather outlook
along your route? Should you delay your trip a short
time to avoid a major storm system?
Maps: Do you have up-to-date maps?
4-22
ProCarManuals.com

Highway Hypnosis
Is there actually such a condition as “highway
hypnosis”? Or is it just plain falling asleep at the wheel?
Call it highway hypnosis, lack
of awareness, or
whatever.
There is something about an easy stretch of road with
the same scenery, along with the hum of the tires on the
road, the drone of the engine, and the rush of the wind
against the vehicle that can make you sleepy. Don’t let
it
happen to you! If it does, your vehicle can leave the
road in
less than a second, and you could crash and be
injured.
What can you do about highway hypnosis? First, be
aware that it can happen.
Then here are some tips:
Make sure your vehicle is well ventilated, with a
comfortably cool interior.
0 Keep your eyes moving. Scan the road ahead and to
the sides. Check your rearview mirrors and your
instruments frequently.
0 If you get sleepy, pull off the road into a rest, service,
or parking area and take a nap, get some exercise, or
both. For safety, treat drowsiness on the highway as an emergency.
Hill and Mountain Roads
, . C? . ‘j . .i .
Driving on steep hills or mountains is different from
driving in flat or rolling terrain.
4-23
ProCarManuals.com