1995 PONTIAC FIREBIRD radio

THEFTLOCK
THEF’iZOCK is a security feature for the cassette tape
and compact disc player. It can be used or ignored.
If
igriored, the system functions normally. If it is used,
your system won’t be usable if it’s ever stolen. When the
system is active, the indicator light will flash while the
ignition
is off.
Setting Your Security Code
The instructions below tell you how to enter a security
code into the system. If your vehicle loses battery power
for any reason, you must enter the security code again
before the system will turn
on.
1. Write down any number from 000 to 1999 and keep
2. Turn the ignition switch to the ACC or RUN
3. Turn the radio off.
4. Press and hold pushbuttons 1 and 4 together until
it in a safe place.
position.
“- - -” shows on the display. ,’
You are now ready to enter your security code. Don’t
wait more than 15 seconds between steps.
5. Press MIN and “000” will appear on the display.
6. Press MIN again and hold until the last two digits of
7. Press HR until the fist one or two digits of your
your code appear. Release the button.
code appears.
8. Press A” “rEP” will appear on the display.
9. Repeat steps 5 through
7 for verification.
10. Press A” SEC.will appear on the display. This
means that your audio system is secured.
Shutting Off the Theft-Deterrent Feature
If your audio system is secured (SEC shows on the
display) and you wish to disable it, enter
yoiu security
code as .follows, pausing no more than 15 seconds
between steps:
1. Turn the ignition on. Make sure the audio system is
off. The time will show on the display.
2. Press pushbuttons 1 and 4 together until SEC shows
on the display.
3. Press MIN “000” will appear on the display.
4. Press MIN again and hold until the last two digits of
your code appear. Release the button.
‘, \.
3-12 I
ProCarManuals.com

5.
6.
Press HR until the first one or two digits of your How to Change Your Security Code
code appear.
Press
A” If “- - -” shows, you have shut off steps:
You can change your security code by following these
the theft-deterrent feature. If SEC shbws, your audio
system is still secured.
Note: If you lose or forget your security code, see your
dealer for assistance.
Unlocking the Audio System “after a Power Failure
If power is disrupted io the audio system whiie in the
SEC mode, the unit will not work &nd LOC will show
on the display whenever the ignition is on. To unlock the
unit:
1. Press MIN “OW’ will appear on the display.
2. Press MIN again and hold until the iast two digits of
your code appear. Release the button.
3. Press HR until the first one or two digits of your
code appear.
4. Press AM/FM. SEC will appear on the display and
the unit will work.
If LOC shows, the numbers did
not hatch and the unit is still locked.
-
1. Using your old code, follow the directions given
under “Shutting Off the Theft-Deterrent Feature.’’
2. Repeat directions of .“Setting Your Security Code”
with your new security code.
Understanding Radio Reception
FM Stereo
.i‘
FM stereo will give you the best sound. But FM signals
will reach only about
10 to 40 miles (1 6 to 65 km). And,
tall buildings or hills can interfere with
FM signals,
causing the sound to come and go.
AM
The range for most AM .stations is greater than for FM,
especially at night. The longer range, however, can
cause stations to interfere with each other. AM can pick
up noise
from things like storms and power lines. Try
reducing the treble to reduce this noise if you ever get it.
&&
3-13
ProCarManuals.com

AM Stereo
This means the Delco@ system can receive C-QUAM@
stereo broadcasts. Many
AM stations around the country
use C-QUAM’ to produce stereo, though some do not.
(C-QUAM@ is a registered trademark of Motorola, Inc.)
If your Delco@ system can get C-QUAM@, your
STEREO light will come on when you’re receiving it.
Tips about your Audio System
Hearing damage from loud noise is almost undetectable
until it
is too late. Your hearing can adapt to higher
volumes
of sound. Sound that seems normal can be loud
and haul
to your hearing. Take precautions by
adjusting the volume control on your radio to a safe
sound level before your hearing adapts to it.
To help avoid hearing loss or damage:
0 Adjust tbe volume control to the lowest setting.
9 Increase volume slowly until you hear comfortably
and clearly.
NOTICE:
Before you add any sound equipment to your
vehicle
-- like a tape player, CB radio, mobile
telephone or two-way radio
-- be sure you can
add what you want.
If you can, it’s very
important to do
it properly. Added sound
equipment may interfere with the operation of
your vehicle’s engine, Delco@ radio or other
systems, and even damage them. And, your
vehicle’s systems may interfere with the
operation of sound equipment that has been
added improperly.
So, before adding sound equipment, check with
your dealer and be sure to check Federal rules
covering mobile radio and telephone units.
3-14
ProCarManuals.com

Care of Your Cassette Tape Player
A tape player that is not cleaned regularly can cause
reduced sound quality, ruined cassettes, or a damaged
mechanism. Cassette tapes should be stored in their
cases away from contaminants, direct sunlight, and
extreme heat.
If they aren’t, they may not operate
properly
or cause failure of the tape player.
Cassettes are subject to wear and the sound quality may
degrade over time. Always verify that the cassette tape
is in good condition and that the tape player is clean
before obtaining service on your tape player.
Your tape player should be cleaned with every 50 hours
of use to provide optimum performance. Your radio may
display “Cln” to indicate that your have used your tape
player for
50 hours without resetting the tape clean
timer.
If you notice a reduction in sound quality,
regardless of when the tape player was last cleaned, try
playing a different cassette to see if the tape or the tape
player is at fault. If the second cassette results in no
improvement in sound quality, try cleaning the tape
player.
Proper tape player cleaning should be done with a
scrubbing action, nonabrasive cleaner cassette. This is a
wet-type cleaning system that uses a cleaning cassette
with pads which scrub the tape head as the hubs of the
cleaner cassette
turn. To properly clean your tape player,
follow the instructions with the cleaning cassette.
If you
use this type of cleaner, the radio may display an error
and eject the cartridge. This is normal and is the result
of an added feature in the tape player that detects broken
tapes. If an error occurs, you will need to insert the
cleaning cassette at least three times to thoroughly clean
the tape player.
You may also choose a non-scrubbing action, wet-type
cleaner which uses a cassette with a fabric belt to clean
the tape head.
This type of cleaning cassette will not
eject. It may not clean as thoroughly as the scrubbing
type cleaner.
A scrubbing action cleaner is available through your
dealer
(GM Part No. 12344600).
Note: Tape adapter kits for portable CD players will not
work in your cassette player. These adapters will cause
the radio to display an error message and the adapter
cassette will be ejected.
3-15
ProCarManuals.com

Power Antenna Mast Care
Your optional power antenna will look its best and work
well
if it’s cleaned from time to time. To clean the
antenna mast:
1. Turn on the ignition and radio to raise the antenna.
2. Dampen a clean cloth with mineral spirits or
3. Wipe the cloth over the mast sections, removing any
equivalent solvent.
dlrt.
4. Wipe dry with a clean cloth.
5. Make the antenna go up and down by turning the
6. Then repeat if necessary.
radio off and on.
NOTICE:
Don’t lubricate the power antenna. Lubrication
could damage it.
NOTICE:
Before entering an automatic car wash, turn off
your radio to make the power antenna go down.
This will prevent the mast from possibly getting
damaged.
If the antenna does not go down when
you turn the radio off, it may be damaged or
need to be cleaned. In either case, lower the
antenna by hand by carefully pressing the
antenna down.
If the mast portion of your antenna is damaged, you can
easily replace it. See your Dealer for a replacement kit
and follow the instructions in the kit.
3-17
ProCarManuals.com

Steering Wheel Touch Controls
(Option)
VOL (Volume): Press the up or down arrows to
increase or decrease volume.
PLAY: Press to play the CD or cassette instead of the
MUTE: Press to silence the system. Press again to turn
on the sound.
SEEK: Press the up or down arrows to tune to the next
or previous radio station.
If a tape or compact disc is
playing, the player will advance or rewind.
PRESET Press to play a station you have programmed
on the radio preset buttons.
AMIFM: Press to choose AM, FM1 or FM2. If a tape or
- radio.
compact disc is playing, it will stop and the radio will
You can control certain audio system functions using the play.
buttons on your steering wheel.
ProCarManuals.com

To Jump Start Your Pontiac;
1. Check the other vehicle. It must have a 12-volt
battery with a negative ground system.
I NOTICE:
I If you leave your radio on, it could be badly I
damaged. The repairs wouldn’t be covered by
your warranty.
NOTICE:
I
If the other system isn’t a 12-volt system with a
negative ground, both vehicles can be damaged.
I
2.
3.
I
4. Open the hoods and locate the batteries.
Get the vehicles close enough so the jumper cables
can reach, but be sure the vehicles aren’t touching
each other.
If they are, it could cause a ground
connection you don’t want. You wouldn’t be able to
start your Pontiac, and the bad grounding could
damage the electrical systems.
Turn off the ignition on both vehicles. Turn off all
lights that aren’t needed, and radios. This will avoid
sparks and help save both batteries. And it could
save your radio!
5. Find the positive (+) and negative (-) terminals on
each battery.
5-3
ProCarManuals.com

Fuses tu~d Circuit Breakers
The other is in the engine CoIfipartment. Open the cover
on either of the boxes to expose the fuses.
me wiring circuits in your vehicle are protected from
shci'rl
circ&b by a combination of fuses, circuit breakers,
and fusible thermal
links in the wiring itself. This
greatly redtices the chance of fires caused by electrical
problems.
Thkre are two hse centers on your vehicle. One is in the
left side ok your instrument panel.
Look at the silver-colored band inside the fuse. If the
band
is broken or melted, replace the fuse. Be sure you
replace a bad
fuse with a new one of the correct size.
If you ever have a problem on the road and don't have a
spare
fuse, you can bortow one. Just pick some feature
of your car that you can get along without-like the
radio or cigarette lighter-ind use ite fuse,
if it is the
size
you need. ReplaGe it as soon as you can.
ProCarManuals.com