1995 OLDSMOBILE SILHOUETTE door lock

Disengage the Automatic Door Locks System: To
disengage the automatic door locks system, press the
lock symbol on your remote transmitter
once (all doors
will lock). Press the lock symbol again. All doors will
lock again, indicating that this mode has been
successfully programmed.
You can reprogram
the automatic door locks system at
any time. If you do not program the automatic door
locks system, all doors will remain locked when the shift
lever is returned
to PARK (P).
If you have more than one remote transmitter for your
vehicle, your automatic door locks system will operate
as programmed with any of them. There is no need to
program each one individually.
Leaving Your Vehicle
If you are leaving the vehicle, open your door and set
the locks from inside. Then get out and close the door.
Remote Lock Control (Option)
If your Oldsmobile has this option, you can lock and
unlock your doors and liftgate from up to
30 feet (9 m)
away using the key chain transmitter supplied with your
vehicle.
Your Remote Lock Control operates on a radio
frequency subject
to Federal Communications
Commission
(FCC) Rules.
2-7
ProCarManuals.com

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
Should interference
to this system occur, try this:
0
0
0
0
Check to determine if battery replacement is
necessary. See the instructions
on battery
replacement.
Check the distance. You may be too far from your
vehicle. This product has a maximum range.
Check the location. Other vehicles or objects may be
blocking the signal.
See your Oldsmobile retailer or a qualified
technician for service.
Operation
The driver’s door will unlock and the interior lamps
will go on when the unlock symbol is pressed (see
“Illuminated Entry System” later in this section). If
pressed again within five seconds, all doors and the
liftgate will unlock. All doors and the liftgate will lock
when the lock symbol is pressed.
If the driver’s door is open and your key is in the
ignition in the
OFF position, you won’t be able to set the
door lock with the power door lock switch or the remote
transmitter. This security feature is designed to help
keep you from locking your keys in your vehicle.
Lock Delay
The lock delay feature can be operated using either the
remote key chain transmitter or the power door locks
switch (see “Power Door Locks” earlier in this section).
Changes or modifications to this system by other than an
authorized service facility could void authorization
to
use this equipment.
2-8
ProCarManuals.com

For the lock delay feature to work, the ignition and
the interior lamps control (located to the left of the
instrument panel cluster) must
be off. If you wish to
lock the doors with the interior lamps on, press the
lock symbol or the rear of either power door lock
switch twice.
If any door
is open when you press the lock symbol or
the rear
of either power door lock switch, a chime will
sound three times. This indicates that all doors and the
liftgate will lock about five seconds after the last door
has been closed.
To override the lock delay feature, press the lock symbol
or the rear of either power door lock switch again, and
the doors and liftgate will lock immediately. If the
sliding door
is open, it will lock automatically within
five seconds after
it is closed, and the doors and liftgate
will lock again.
To cancel the lock delay feature, press the unlock
symbol
or the front of either power door lock switch.
Remote Operation of the Power Sliding Door
If you have the optional power sliding door (see “Power
Sliding Door” later in this section), your remote
transmitter will have a third button that has
a van
symbol on it. Press it to open or close the sliding door.
If the sliding door is locked, first press
the unlock
symbol twice to unlock all doors, then press the van
symbol to open the sliding door.
You can operate the power sliding door with the remote
transmitter only when the power sliding door enable
switch on the overhead console is in the
ON position.
2-9
ProCarManuals.com

1.
2.
3.
4.
5.
Insert a coin into the slot in the back of the
transmitter, and turn it counterclockwise to open the
cover.
Remove the cover.
Remove and replace the 3-volt battery (CR2032).
Reassemble the transmitter. Check the transmitter operation.
Illuminated Entry System (Option)
This option comes with the optional Remote Lock
Control system.
When you open the driver’s door, by itself or in
combination with any passenger door or the liftgate, the
interior lamps will come on and then gradually dim to
off 10 seconds after the last door is closed. (If the
driver’s door has not been opened, the interior lamps
will immediately dim to
off.)
When you press the unlock symbol on your remote
transmitter, the lamps inside your vehicle will
go on,
then gradually dim to
off after about 40 seconds, unless
a door or the liftgate is opened.
When you turn on the ignition, the interior lamps will
immediately dim
to off.
Sliding Door
To open the sliding door from outside the vehicle, pull
the front
of the latch release out and then toward the
rear.
If you slide the door all the way back, it will latch
in the open position.
2-11
ProCarManuals.com

r Sliding Door Lock
Ii
To move the door forward, you must first pull the inside
or outside latch release out and then forward, or the
door
will remain latched in the open position. Lock the sliding door from the inside
by sliding the
manual locking lever down. Unlock it
by sliding the
lever
up.
If you have the optional power door locks, the sliding
door lock has
a delay feature. See “Power Door Locks”
or “Automatic Door Locks”
in the Index.
2-12
ProCarManuals.com

With this option, you can open and close the sliding
door with switches inside your vehicle.
If you have the
optional Remote Lock Control system,
you can also
operate the sliding door with your remote transmitter.
See “Remote Lock Control” in the Index. When
your vehicle
goes through an automatic car wash,
be sure the power sliding door enable switch
is in the
OFF position.
2-13
ProCarManuals.com

To open or close the sliding door, press and release one
of two PWR DOOR switches. There is one mounted
on
the wall, just in front of the sliding door; the other is the
rear-most switch on
the side of the overhead console.
(If you have the compact overhead console, this switch
is located between the reading lamps.) The sliding door must be unlocked
for the power sliding
door to operate. The ignition does not have to be on and
the key does
not have to be in the ignition. To prevent
accidental operation
of the sliding door, disable the
power sliding door by placing
the power sliding door
enable switch in the
OFF position.
When the key is
in the ignition in the RUN position, the
power sliding door will only open if the transaxle is in
PARK
(P). The transaxle does not have to be in PARK
(P) to close the door. If the enable switch is ON and the
power sliding door
is open or in the process of closing
when you shift out of PARK
(P), a tone will sound and
the power sliding door warning light on your instrument
panel will flash (see “Power Sliding Door Warning
Light” in the Index). This is a warning light that the
sliding door is not completely closed.
2-14
ProCarManuals.com

Sliding Door Security Lock
Your Oldsmobile is equipped with a sliding door
security lock that helps prevent passengers from opening
the sliding door from the inside.
If you have the optional power sliding door, you can
override the security lock by pressing the
PWR DOOR
switch when the power sliding door enable switch is in
the
ON position. See “Power Sliding Door” earlier in
this section.
The security lock lever is located on the inside of the
sliding door, near the rear edge of the door.
To access
the lever, open the sliding door. Use the security lock
label on the rear edge of the door as a guide. Reach your
hand around the inside rear corner of the sliding door to
access the lever.
I ,;I m
CHILD
I SECURITY
LOCK
To use the security lock, move the security lock lever all
the way up and close the door.
If you have the optional power sliding door, slide the
power sliding door enable switch on the overhead
console to the
OFF position. The sliding door cannot be
opened from the inside when this feature is in use.
2-17
ProCarManuals.com