Page 77 of 372
Shifting Into PARK (P)
1. Hold the brake pedal down with your right foot and
set the parking brake.
2. Move the shift lever into the PARK (P) positions as
follows:
0 Hold in the button on the lever.
Push the lever all the way toward the front of
your vehicle.
3. Move the ignition key to LOCK.
4. Remove the key and take it with you. If you can
walk away from your vehicle with the ignition key in
your hand, your vehicle is in PARK (P).
2-25
ProCarManuals.com
Page 79 of 372
Shifting Out of PARK (P)
Your Aurora has a brake-transaxle shift interlock. You
have to fully
apply your regular brake before you can
shift from PARK (P) when the ignition is in the
ON
position. See “Shifting the Automatic Transaxle” in the
Index.
If you cannot shift out of PARK (P), ease pressure
on
the shift lever--push the shift lever all the way into
PARK (P) as you maintain brake application. Then
move the shift lever into the gear you wish. Press the
shift lever button before moving the shift lever.
If you ever hold the brake pedal down but still can’t
shift out of PARK (P), try this:
1. Turn the key to OFF. Open and close the driver’s
door to turn off the Retained Accessory Power
feature.
2. Apply and hold the brake until the end of step 4.
3. Shift to NEUTRAL (N).
4. Start the vehicle and then shift to the drive gear you
want.
5. Have the vehicle fixed as soon as you can.
Parking Over Things That Burn
2-27
ProCarManuals.com
Page 116 of 372

Safety Belt Reminder Light
FASTEN
BELTS
When the key is turned to RUN or START, a chime will
come on for about eight seconds to remind people to
fasten their safety belts.
The safety belt light will also
come on and stay on for about
70 seconds. If the driver’s
belt is already buckled, neither the chime nor the light
will come on.
Air Bag Readiness Light
There is an air bag readiness light on the instrument
panel, which shows
AIR BAG. The system checks the
air bag’s electrical system for malfunctions.
The light
tells you
if there is an electrical problem. The system
check includes the air bag sensors and modules, the
wiring and
the diagnostic module. For more information
on the air bag system, see “Air
Bag” in the Index.
AIR BAG
You will see this light
flash for
a few seconds
when you turn your
ignition to RUN or
START. Then the light
should go out. This
means the system is
ready.
If the air bag readiness light doesn’t come on when you
start your vehicle, or stays on, or comes on when you
are driving, your air bag system may not work properly.
Have your vehicle serviced right away.
2-64
ProCarManuals.com
Page 130 of 372

Elapsed Time (ET) Date
Press DATE to display the date. To change the date,
press DATE then RESET. The following display will
appear:
When the ignition is on, the Driver Information
Center
can be used
as a stopwatch. The display will show hours
and minutes. The elapsed time indicator
will record up
to
100 hours, then it will reset to zero and continue
counting. Press ET, and the display will show the
amount
of time that has elapsed since the elapsed time
indicator was last reset
(not including time the ignition
is off), such
as:
0 1 :OS ELAPSED TIME
To reset elapsed time to zero, press RESET while the
elapsed time
is displayed.
MONTH? XXIDDIYY
MM, DD and YY represent the month, date and year
you currently have in your system. Check to make sure
your clock is
in the correct AM or PM mode.
Notice that each key has a number. Push the key to enter
the number. The first XX’s
will flash until you enter the
first digit for the
month. You don’t need to enter the
leading zero
if the number is under 10. Press ENTER
after you’ve entered the month. The display will change
to:
DAY? MM/XX/Y
Y
Set the day just as you set the month. After the day entry
is made, press ENTER, and the display
will change to:
2-78
ProCarManuals.com
Page 166 of 372

Drunken Driving
Death and injury associated with drinking and driving is
a national tragedy. It’s the number one contributor to the
highway death toll, claiming thousands of victims every
year.
Alcohol affects four things that anyone needs to drive a
vehicle:
Judgment
Muscular Coordination
0 Vision
0 Attentiveness
Police records show that almost half of all motor
vehicle-related deaths involve alcohol. In most cases,
these deaths are the result of someone who was drinking
and driving.
In recent years, some 18,000 annual motor
vehicle-related deaths have been associated with the use
of alcohol,
with more than 300,000 people injured.
Many adults
-- by some estimates, nearly half the adult
population
-- choose never to drink alcohol, so they
never drive after drinking. For persons under
2 1, it’s
against the law in every U.S. state to drink alcohol.
There are good medical, psychological and
developmental reasons for these laws. The
obvious way to solve this highway safety problem
is for people never to drink alcohol and then drive. But
what if people do? How much is “too much”
if the
driver plans to drive? It’s a lot less than many might
think. Although it depends on each person and situation,
here is some general information
on the problem.
The Blood Alcohol Concentration (BAC)
of someone
who is drinking depends upon four things:
How much alcohol consumed
0 The drinker’s body weight
The amount of food that is consumed before and
during drinking
The length of time it’s taken the drinker to consume
the alcohol
According to the American Medical Association,
a
I 80-pound (82 kg) person who drinks three 12-ounce
(355 ml) bottles of beer in an hour will end up with a
BAC
of about 0.06 percent. The person would reach the
same BAC by drinking three 4-ounce (120 ml) glasses
of wine or three mixed drinks
if each had 1- 1/2 ounces
(45 ml) of a liquor like whiskey, gin or vodka.
4-2
ProCarManuals.com
Page 202 of 372
1
The HAZARD light on the
instrument panel will also
come
on.
HAZARDA
Your hazard flashers work no matter what position your
key is
in, and even if the key isn’t in.
To turn off the flashers, press the button down again.
When the flashers are
on, your turn signals won’t work.
Other Warning Devices
If you carry reflective triangles, you can set one up at
the side of the road about 300 feet (100 m) behind your
vehicle.
Jump Starting
If your battery has run down, you may want to use
another vehicle and some jumper cables to start your
Aurora. But please follow the steps to do it safely.
5-2
ProCarManuals.com
Page 209 of 372
When your vehicle is being towed, have the ignition key
off. The steering wheel should be clamped in a
straight-ahead position, with a clamping device
designed for towing service.
Do not use the vehicle’s
steering column lock for this. The transaxle should be
in
NEUTRAL (N) and the parking brake release.
Don’t
have your vehicle towed on the front wheels.
unless you must.
If the vehicle must be towed on the
front wheels, don’t
go more than 35 mph (56 kdh) or
farther than SO miles (80 km) or your transaxle will be
damaged.
If these limits must be exceeded, then the
front wheels have to be supported
on a dolly.
5-9
ProCarManuals.com
Page 288 of 372
1 I 1 Fuse Usage -
Position Circuitrv
1
2
3
4
5
4
7
8
9
10
11
12
13
14
1s
16
17
18
19
20
Supplemental Inflatable Restraint (Air Bag)
Il?jectors
Anti-Lock Brake System
Left Exterior Lamps
Turn Signal Lamps 1n.jector.s
Climate Controls, Magnetic Speed Right Exterior Lamps
Chime (Ignition
1 ), Memory Set
Powertrain Control
Module Cruise
Control, VATS PASS-Key%
Auxiliary Power
Interior Lamps
Brake-Transaxle Shift Interlock, Heated
Oxygen Sensor: Linear
EGR
Driver Information Center
Radio
Climate Control Relay
Windshield Wipers
Cigar Lighter
Crank,
Air Bag Module
Climate Control Blower
ProCarManuals.com