1995 MITSUBISHI 3000GT switch

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Radio and Tape Player54-I 89
Antenna going downAntenna going up
16FO203
16F019800002406
REMOVAL SERVICE POINT
+A,REAR SEAT CUSHION REMOVAL
Raise and remove the seat cushion with the lever pulled.
INSTALLATION SERVICE POINT
.AqREAR SEAT CUSHION INSTALLATION
(1) Securely fit the attachment wire of the seat cushion
under the seatback.
(2) Pass the inner seat belt buckles through the cushion.
(3) Securely fit the lock plates of the seat cushion into
the holes in the floor.
INSPECTION
ANTENNA MOTOR INSPECTION
Disconnect the motor antenna control unit connector, connect
the positive terminal of the power supply to terminal (1) and
connect the negative terminal to terminal (4) to check that
the antenna goes up, and that when the connections are re-
versed, the antenna goes down.
MOTOR ANTENNA CONTROL UNIT INSPECTION
(1) Connect the harness connector to the motor antenna.
(Body harness)
(2) Disconnect the antenna motor connector.
(3) With the ignition switch in the ACC or ON position, operate
the radio switch and check the voltage between the termi-
nals during the period when the antenna is going up or
going down.
I
I
Antenna operating
directionTerminals to checkVoltage (V)
I
Down
UPl-310-13
3-410-13
TSB Revision

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Radio and Tape Player
Ring nut
Tbothsideofrack cable
Rack cable
16LO42700002407,8Loa1
7
Tooth side of rack cable
ANTENNA POLE REPLACEMENT(1) Remove the ring nut.
(2) Set the radio switch to ON. After the antenna pole has
extended, remove the antenna pole and rack cable as
an assembly._.(3) Extend the antenna pole up to its farthest point.
NOTEIf the motor end of the rack cable is bent, straighten it.
(4) Force the rack cable into the motor assembly with the
tooth side of the rack cable toward the luggage compart-
ment.(5) Turn the tooth side of the rack cable toward the rear of
the vehicle
(90” clockwise) to bring the rack cable into
mesh with the motor gear.
(6)Lightly pull the rack cable. If it comes out without resistance,
it means that the rack cable is not in mesh with the motor
gear. Recheck that the rack cable end is not bent before
repeating the above-mentioned steps (2) and (3).(7) With the antenna pole upright and the radio switch at
OFF, take up the rack cable. As the rack cable is takenup, insert the antenna pole toward the motor antenna.
(8) After the ring nut has been tightened, set the radio switchto ON and OFF to check the operation of the antenna
pole.
I
I
I
vi ~
I~
d
TSB Revisidn

Downloaded from www.Manualslib.com manuals search engine 54-194CHASSIS ELECTRICAL - Rear Window Defogger
CIRCUIT DIAGRAM
FUSIBLE LINK@IGNITIONSWITCH(IG2)IGNIlSWIT(
I1 1OAb15A
3R-BI
,,5,,3/\,\
imGER------_____---______--~~~~~
OFF-,=ON
'4
3B-R
B-RG-Y
J(1,
pa-u7?a-D'3u-0
.y "I u" "I =" :‘I MFI &STEM (c-65) I,"::(c-66)
vI
t
%!E, i Cl?L-7r
IbUI” I KUl2~C”MIRRORI4 I7i7-
IN(IGl)GENERATOR(L TERMINAL)
B-W
(F>L
7m CHARGING7(D-45)JO
3m
L
L
16s)
CHARGINGL
(c-15) :$
LI
52(c-65)2%4
GNO
EWc&+;;;
B
3B-R0
2B
NOTEal:VEHICLES WITHOUTTHEFT-ALARM SYSTEM.X2:VEHICLES WITHnTHEFT-ALARM SYSTEM.6
:3:1994 :4:FROMMODELS 1995 MODELS
HR13MOlAA
TSB Revision

Downloaded from www.Manualslib.com manuals search engine 54-196CHASSIS ELECTRICAL - Rear Window Defogger
CIRCUIT DIAGRAM
F'JSIBLELINK@
3R-I3
(c-01)22B-h,-----------___.
3R-E
3B-F
38-F
IGNITIONIGNIlSWITCH(IG2)SWITC
- -
2L-BI
28-h
J’Bp
L-RIB-k
DEFOGGER
RELAY
(c-06x)
MFI SYSTEM3;:(c-66)-
REMOTE#JJ&LLED
GNIn
B
!B
INGENE(IGl)(L TE
B-W(F>I
7mCHARGINGI(D-45)
30
I
e-CHARGINGT
(c-15)
52
TORINAL)
10
'57 :1I
59 $2
NOTE:l:VEHICLES WITHOUTTHEFT-ALARM SYSTEM.22:VEHICLES WITHTHEFT-ALARM SYSTEM.
HR13M02AA
1 TSB Revision

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Rear Window Defogger
ii
2W-B
5W-BHORN
‘J/B,.1 (c-68)
(F>R-B(F>R-I
DOOR LIGHT AND LUGGAGE
COMPARTMENT LIGHT
:I,
,HEADLIGHT.FOG LIGHT.TAILLIGHT.PARKING/SIDE
MARKER LIGHT
AND LICENSE
PLATE LIGHT
69
10A\/
11------ A/1R-Y
r R
(c-70)
/L-R
cc-65)
f
i
I
,E
2B
FUSIBLE LINKa
I
1,,2 ,,l/\,--(A-11X) (
2B-F
IOD OR STRAGE
CONNECTOR
DEFOGGER
SWITCH
iD-os)
i
my54
B-L
R-B
9I16"AA\(
45 DATA LINK CONNECTOR
B(c-79)
i
L-R
V
1'4
:;fE-$;T (B-Y).$;;EESAND
2B
,(D-41)B-Y
27
RHEOSTAT
2B
h
n
NOTE:l:VEHICLES WITHOUTTHEFT-ALARM SYSTEM.:2:VEHICLES WITHTHEFT-ALARM SYSTEM.
2B-k
\6
IND(UN
TAILLIGHT RELAY
q-
:;&"A'""
J/B
7L IIG-W
I
8cc-71)
p@
G-W4
Ed.ELC-4A/T
'i;$$SAND (G-W)
2,,3
HR13M02AB
TSB Revision

Downloaded from www.Manualslib.com manuals search engine 54-I 98CHASSIS ELECTRICAL - Rear Window Defogger
CIRCUIT DIAGRAM
2B-RFUSIBL
3R-I
(c-01)
3R-i
3B-R
1
3B-R
IGNITIONSWITCH(IG2)IGNIIISWITC
J’Bn
?
B-R
MFI SYSTEM
REMOTECONTROLLED
MIRROR
OFF-:,ON
-l (F)*
7BCHARGING7(D-45)
e-CHARGINGI
G-Y
,I I
(6-15)
(c-65)5(c-66) 52(c-65)
VV
fl
IGNDV
I
L
,I
4-4
TORINAL)
10
HR13M03AA
1 TSB Revision

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Rear Window Defogger54-199
LJ
FUSIBLE LINKa
I
(c-83)L
(F>R-B(F>R-i
DOOR LIGHT AND LUGGAGECOMPARTMENF
.HEADLIGHT,FOG LIGHT.TAILLIGHT.PARKING/SIDE
MARKER LIGHT
AND LICENSE
PLATE LIGHTr
IL-R
(C-65)112P
$
4
B
E
F
2B=
/ - 12B-
IOD OR STRAGE
CONNECTOR
DEFOGGER
SWITCH
(D-06)i
Al
5 DATA LINK CONNECTOR
)FF ‘T[
2B
2B
2B-
6
IN
I
TAILLIGHT RELAY
I1.25R-W
l&&CATED
0%
15A
G-W,,6 (c-69)
J/B\
,\,G-W8 (c-71)
W8(D-44)
1
(D-41).ELC-4A/T
'&;&AND (G-W)),,31
:aFRONT SIDE (c-83)
B-Y
RHEOSTAT
HR13M03AB
TSB Revision

Downloaded from www.Manualslib.com manuals search engine 54-200CHASSIS ELECTRICAL - Rear Window Defogger
OPERATIONl
If the defogger switch is turned to “ON” when the generator is generating electricity (L terminal exceeds
10 V.) with the ignition switch at the “ON” position, the timer circuit in the ETACS unit will be operated
to keep the transistor “on” for 11 minutes to close the contact point of the defogger relay. When the
defogger relay is “on”,the defogger and mirror heater will be activated. Moreover, the indicator lightof the defogger switch is lit to inform that the defogger and mirror heater are activated.
lWhen 11 minutes have passed, the defogger and mirror heater will stop activating even if the defoggerswitch is at “ON”. When the defogger and mirror heater are activated (the timer is activated), they
will also stop activating even if the defogger switch is set at “ON” again or if the generator stops
generating electricity (the terminal is 3.5 V or less.)
NOTE
The light automatic shut-off system is valid for the illumination light of the defogger switch. (Refer to
P.54-37.)
TROUBLESHOOTING HINTS
NOTE
For the troubleshooting hints of the automatic light shut-OFF system, refer to P.54-38.
COMPONENT LOCATION
Datalink. connector
216FO125
Data link connector

\V16FO496 1
es.-‘) blocky,6Fww
1 TSB Revision