1995 LAND ROVER DISCOVERY wheel bolts

WIPERS AND WASHERS
1
REPAIR WASHER RESERVOIR
Service repair no - 84.10.03.
Remove
1.Remove two bolts securing top of reservoir.
2.From underneath the wheelarch remove two
bolts securing base of reservoir.
3.Withdraw reservoir and disconnect tubing from
washer pumps and power wash.
4.Disconnect electrical leads from pumps.
Refit
5.Reverse removal procedure. 1 to 4.WASHER PUMP - WINDSCREEN, REAR WINDOW
OR POWER WASH
Service repair no - 84.20.21.
Remove
1.Remove washer reservoir.See Washer
reservoir
2.Disconnect washer tubing from pump.
3.Disconnect electrical leads from pump.
4.Pull top of pump away from its location in
reservoir and remove pump.
Note position of sealing gasket in reservoir.
Refit
5.Reverse removal procedure. 1 to 4.

84WIPERS AND WASHERS
6
REPAIR Refit
16.Reverse removal procedure.
17.Fit wiper motor to support plate using new
sealing bushes at the motor spindle as
necessary.
18.When positioning assembled motor and support
plate use a new seal and bushes, if necessary.
REAR DOOR WIPER MOTOR
Service repair no - 84.35.12.
Remove
1.Disconnect battery negative lead.
2.Remove rear door trim panel.
3.Remove spare wheel.
4.Remove wiper arm and grommet.
5.Remove nut, plain washer and seal from drive
spindle.
6.From inside the door, disconnect wiper motor
leads from door harness at multi-plug.
7.Remove bolts securing wiper motor mounting
bracket and negative lead to inner door panel.
8.Withdraw motor spindle from outer door panel
and manoeuvre wiper motor from door casing
complete with the spindle spacer.
9.Remove two rubber mounted nuts securing
mounting bracket to motor and detach bracket.
Refit
10.Reverse removal procedure. 1 to 9.
NOTE: If a new wiper motor assembly has
been fitted, before fitting the wiper arm.
Reconnect battery negative lead. Operate
wiper motor to ensure that motor spindle is in
park position.

86ELECTRICAL
46
REPAIR STARTER MOTOR - 4.0 V8
Service repair no - 86.60.01
Remove
1.Disconnect battery negative lead.
2.Raise vehicle on ramp.
3.Remove heated oxygen sensor from RH front
exhaust pipe.
See EMISSION CONTROL,
Repair, Heated Oxygen Sensor (HO2S) - 4.0
V8
4.Mark front propeller shaft and drive flanges for
assembly reference.
5.Remove 4 nuts and bolts securing propeller
shaft flange.
NOTE: Raise 1 front road wheel and rotate
propeller shaft to gain access to all
fixings.
6.Tie propeller shaft aside.
7.Position starter motor heat shield above motor.
See Starter Motor Heat Shield - 4.0 V8
8.Disconnect Lucar from solenoid.
9.Remove nut securing feed wires to starter
solenoid and disconnect from terminal.