ELECTRICAL
11
DESCRIPTION AND OPERATION ANTI-THEFT ALARM BUILT-IN TEST (96 MODELS)
NOTE: The handset should be detached
from the key to allow perimetric testing of
the alarm system. The system will
automatically switch to volumetric testing if the
handset is in close proximity to the starter switch.
The built-in test procedure can be accessed providing
the following conditions exist:
Alarm disarmed.
Ignition off.
Doors unlocked.
Bonnet[hood] closed.
The test mode can be entered by completing the
following instructions within 5 seconds:
1.Open bonnet.
2.Turn starter switch on.
3.Open driver's door (far enough to activate
switch).
4.Turn starter switch off.
5.Turn starter switch on.
If the test mode has been correctly accessed, the
sounder/horn will operate briefly and the anti-theft
alarm indicator and hazard warning lights will flash.
Perimetric tests
The anti-theft alarm indicator light and the hazard
warning lights will flash when:
1.Door switches are activated;
2.The bonnet is opened;
3.Sill switches are activated;
4.Key switches are activated.
NOTE: Operation of key switches can be
verified by turning the key in the relevent
direction so as not to simultaneously
activate the sill switch. If the key switch changes
state, the change should be detected but the sill
switch will not be activated.
Volumetric tests
Press the unlock button or move the handset close to
the starter switch to disable perimetric testing and
enable volumetric testing. If movement is detected
within the vehicle by the ultrasonic sensor it will be
indicated by flashing the anti-theft alarm indicator and
hazard warning lights.
NOTE: Exit anti-theft alarm built-in test by
turning starter switch to the off position.
ELECTRICAL
45
REPAIR SOUNDER (96 MODELS)
Service repair no - 86.55.87
Remove
NOTE: Failure to follow steps 1 and 2 will
result in sounder being activated.
1.Turn starter switch 'ON' then 'OFF'.
2.WITHIN 15 SECONDS, depress release clip on
multiplug and detach from sounder.
3.Remove 2 securing bolts and remove sounder
complete with bracket.
Refit
4.Reverse removal procedure.
NOTE: If sounder is accidentally activated,
it can be silenced, provided it is
reconnected, by turning starter switch to
position II.SWITCH - ELECTRIC SEAT
Service repair no - 86.75.03
Remove
1.Release switch panel from centre console.
2.Disconnect 2 switch multiplugs
3.Remove switch panel.
Refit
4.Reverse removal procedure.
