86ELECTRICAL
38
REPAIR REVERSE LIGHT SWITCH
Service repair no - 37.27.01
Manual Gearbox
Remove
Reverse light switch is located at rear of selector
housing, accessible from beneath vehicle.
1.Place vehicle on suitable ramp.
2.Disconnect the battery negative lead.
3.Disconnect electrical leads.
4.Release lock-nut.
5.Remove switch.
NOTE: Reverse light switch requires
re-setting on reassembly.
6.Select reverse gear.
7.Connect 12 volt supply and test lamp across
switch terminals.
8.Screw switch into housing until test lamp is
illuminated. Screw switch in a further half turn,
tighten locknut.
9.Connect electrical leads.
10.Reconnect the battery negative lead.HEATER/VENTILATION AND AIR CONDITIONING
CONTROL PANEL BULB
Service repair no - 86.45.73
Remove
1.Carefully pull 3 rotary knobs off switches.
2.Prise blower speed control knob off lever.
3.Remove 2 screws securing panel, ease panel
away from fascia.
4.Pull bulb from holder.
5.Insert new bulb in holder.
Refit
6.Reverse removal procedure.
ENGINE
DESCRIPTION AND OPERATION9
CYLINDER HEAD
1.Valve cap
2.Collets
3.Valve spring cup
4.Valve spring
5.Valve spring seat
6.Valve stem seal
7.Valve guide
8.Exhaust valve seat
9.Exhaust valve
10.Inlet valve seat
11.Inlet valve
12.Cylinder head bolt - M12 - long
13.Cylinder head bolt - M12 - short
14.Cylinder head bolt - M1015.Heater hose adaptor
16.Engine lifting brackets
17.Core plugs
18.Cylinder head gasket
19.Thermostat housing gasket
20.Coolant filler plug
21.Thermostat housing
22.Thermostat
23.Coolant outlet elbow
24.Coolant temperature sensor
25.Sealing washer
