1995 CHEVROLET TRACKER buttons

NOTICE: (Continued)
Opening and Closing Your Sunroof
e
e
e
Don’t lower the top if it is damp or wet.
After the top is down, the trapped water
can cause stains, mildew and damage to
the inside
of your car. Be sure to dry off
the top before you lower it.
Don’t lower the convertible top if the rear
flap or side windows are dirty. Dirt could
scratch the side windows.
The convertible top isn’t designed to carry
weight. Never let anyone
sit on the top,
and don’t put anything on top of it when it
is up, or it could be damaged.
1. Lower your antenna and swing your sun visors
down.
2. Squeeze the front top bow latch buttons and pull the
latch back.
ProCarManuals.com

-1 push both sides of the
5. Lower the sunvisors and
-
lock buttons on the front
latches.
6. Unhook the latches.
7. Pull back the swing arm, unfasten the five snaps that
secure the canvas to the swing arm and remove the
canvas from the swing
arm.
8. Return the swing arm forward and hook it securely
with the latches.
2-57
ProCarManuals.com

AM/FM Stereo
To Play the Radio
Turn the ONNOL knob to turn the system on or off.
VOL: Turn this knob to adjust the volume.
Finding a Station
AM-FM:
Press this button to get AM or FM. The
lighted display shows your selection.
TUNE: Press TUNE or TUNE 4 to go to a higher or
lower station. Press and hold
to continue tuning and
release when
you find your station. The display will
show the frequency
of each station tuned.
SEEK: Press SEEK or SEEK 4 and the radio will
tune
to the next higher or lower station and stay there.
PUSHBUTTONS: The six pushbuttons let you return to
your favorite stations. To
set the pushbuttons for up to
12 stations (6 AM and 6 FM), tune in the station. Then,
press and hold one
of the pushbuttons for at least two
seconds. The sound
will go away for a second and will
return when the station
is stored.
Repeat these steps for each pushbutton.
ProCarManuals.com

Finding a Station
AM-FM: Press this button to get AM, FM1 or FM2.
The lighted display shows your selection.
TUNE: Press TUNE or TUNE 4 to go to a higher or
lower station. Press and hold to continue tuning and
release when you find your station. The display will
show the frequency of each station tuned.
SEEK: Press SEEK or SEEK 4 and the radio will
tune to the next higher or lower station and stay there.
PUSHBUTTONS: The six pushbuttons let you return to
your favorite stations. To set the pushbuttons for up to
18 stations (6 AM, 6 FMl and 6 FM2), tune in the
station. Then press and hold one
of the pushbuttons for
at least two seconds. The sound will go away for a
second and will return when the station is stored.
Repeat these steps for each pushbutton.
PSCAN: Press this button to hear each of your preset
stations for a few seconds. When you want to stop at a
chosen station, press PSCAN again.
Setting the Tone
TREB: Turn this knob to the right to hear more treble.
BASS: Turn this control behind the TREB knob to the
right to hear more
bass.
Treble and bass cannot be adjusted manually when
TONE SELECT is on.
TONE SELECT Press this button to choose preset
treble and bass equalization settings designed for
ROCK, NEWS, POP, JAZZ and CLASSICAL.
ROCK will appear when you first press TONE SELECT.
Each time you press it, another setting will appear on the
display. If
you press it one more time after CLASSICAL
appears on the display, tone control will be back to the
treble and bass knob.
Adjusting the Speakers
FADE:
Turn this knob to move the sound between the
front and rear speakers.
BAL: Turn this control behind the FADE knob to move
the sound between the right and left speakers.
Recall
RCL: Press this button to see the station being played
for a moment. Or, press
it if vou want to see 2 time
when the ignition is off.
ProCarManuals.com

To Play a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on each side. Tapes longer than
that are
so thin they may not work well in this player.
The longer
side with the tape visible should face to the
right. If you hear nothing or hear just a garbled sound,
it
may not be in squarely. Press HA to remove the tape and
start over.
Once the tape is playing, use the knobs for volume, fade
and balance, just as you do
for the radio. The lighted
arrows show which side
of the tape is playing.
MTL: Your bias is set automatically. MTL will appear
on your display when a metal or chrome tape
is inserted.
FF: Press this button to advance rapidly to another part
of the tape. Press FF, RCLPROG or mA to return to
playing speed.
REW: Press this button to reverse the tape rapidly. Press
REW or RCL/PROG to return to playing speed. If you
press RCL/PROG, the tape
will also change sides.
NEXT Press this button to go forward to the beginning
of the next selection. Press the button again or press
RCLRROG or
mA to cancel this function. For
NEXT to
work properly, your tape must have at
least three
or four seconds of silence between each
selection. If you press RCL/PROG, the tape will also
change sides.
PREV: Press this button to go back to the beginning
of the last selection. Press PREV again or press
RCLPROG or WA to cancel this function.
RCLRROG: Press this button to switch from one side
of the tape to the other. Your cassette tape player can
play continuously because the player has an
auto-reverse feature.
NOISE REDUCTION: Press On@ to remove noise
from Dolby@
B NR-encoded tapes.
Dolby@
B Noise Reduction is manufactured under
license from Dolby Laboratories Licensing Corporation.
Dolby@ and the
c]o@ symbol are trademarks of Dolby
Laboratories Licensing Corporation.
WA: Press the button with this symbol to remove the
tape and switch to radio.
RADIO MNTR: Press this button to hear the radio
when you are fast forwarding or reversing a cassette
tape.
You can use the TUNE, SEEK and PSCAN buttons
while in the radio monitor mode.
ProCarManuals.com

Cln: This message may appear on the display. If it does,
your cassette tape player needs to
be cleaned. It will still
play tapes, but you should clean it as soon as possible to
prevent damage to your tapes and player. See “Care of
Your Cassette Tape Player” in the Index. After you clean
the player, press and hold EJECT for
five seconds to
reset the Cln indicator. “---” will appear in the display to
show the indicator was reset.
Theft-Deterrent Feature
The theft-deterrent feature for the A” stereo with
cassette tape player can be used
or ignored. If ignored, the
system plays normally. If it is used, your system won’t be \
usable
if it’s ever stolen because it will go into LOC mode
anytime your vehicle loses battery power. The unlock code must be entered or the radio will not
turn on.
Setting Your Security Code
The following instructions will tell you how to enter a
security code
into the system. If your vehicle loses
battery power for any reason, you must enter the
security code again before the system will turn
on.
You are now ready to enter your security code. Don’t
wait more
than 15 seconds between steps.
Press
4 SEEK b or 4 TUNE and “0000” will appear
on the display.
Press SEEK
4 and hold it until the first digit of your
code appears. Release the button.
Press
SEEK b and hold it until the second digit of your
code appears. Release
the button.
Press
TUNE 4 and hold it until the third digit of your
code appears. Release the button.
Press
TUNE b and hold it until the fourth digit of your
code appears. Release the button.
Press
AM-FM after you have checked that the code you
entered
is the one you wrote down. “rEP’ will appear on
the display, which means you need to repeat steps 5
through 9.
Press AM-FM again and the display will now show
SEC.
Write down any four-digit number and keep it in a safe place.
Then turn the ignition switch to the ACC or ON position
and the audio system
off. Press the 1 and 4 buttons together.
Hold them down until
“----” shows on the display.
3-10
ProCarManuals.com

How to Shut Off the Theft-Deterrent Feature
If your radio is secured (SEC shows on the display) and
you wish to disable it, enter your security code as
follows, pausing no more than
15 seconds between
steps.
Press the 1 and
4 buttons together. Hold them down until
SEC shows
on the display. You are now ready to enter
your security code.
Press
the SEEK 4 button and hold it until the first digit
of your code appears.
Press the SEEK button and hold it
until the second
digit
of your code appears.
Press the TUNE
4 button and hold it until the third digit
of your code appears.
Press the
TUNE button and hold it until the fourth
di.git
of your code appears.
Press
AM-FM after you have checked that the code you
entered matches the one you wrote down. “0000” should
now appear
on the display and you will need to repeat
the above procedure.
If
the code is correct, the radio will now operate. If the
code
is wrong, Err will appear in the display.
To Unlock the System After a Power Loss
If power is disrupted to the radio while in the SEC
mode, the unit will not work and LOC will show on the
display whenever the ignition is
on. To unlock the unit,
press
4 SEEK b or 4 TUNE b and “0000” will appear
on the display.
Press the SEEK
4 button and hold it until the first digit
of your code appears.
Press the SEEK
b button and hold it until the second
digit of your code appears.
Press
the TUNE 4 button and hold it until the third digit
of your code appears.
Press the TUNE
b button and hold it until the fourth
digit
of your code appears.
Press
AM-FM after you have checked that the coae
matches the one you wrote down. Now the time of day
will appear
on the display. (Please note that if an
incorrect code is entered,
Err will appear on the display
and the above steps need to be repeated.)
ProCarManuals.com

AM/FM Stereo with Cassette Tape and
Compact
Disc Players
To Play the Radio
Turn the ONNOL knob to turn the system on or off.
VOL: Turn the ONNOL knob to adjust the volume.
Finding a Station
AM-FM: Press AM-FM to get AM, FM 1 or FM2. The
lighted display shows your selection.
TUNE: Press TUNE b or TUNE 4 to go to a higher or
lower station. Release when
you find your station. The
display will show the frequency of each station tuned.
SEEK: Press SEEK b or SEEK 4 and the radio will
tune to the next higher or lower station and stay there.
PUSHBUTTONS: The six pushbuttons let you return to
your favorite stations. To set the pushbuttons for up to
18 stations (6 AM, 6 FM 1 and 6 FM2), tune in the
station. Then, press and hold one
of the pushbuttons for
at least two seconds.
The sound will go away for a
second and will return when the station is stored.
Repeat these steps for each pushbutton.
PSCAN: Press this button to hear each of your preset
stations for a few seconds. When you want to stop at a
chosen station, press PSCAN again.
ProCarManuals.com