1995 CHEVROLET TRACKER ECU

Opening and Closing Your Rear Window.
5. Unfasten the holding strap near the dome lamp and
6. Fasten the holding strap to itself.
pull
it through the slot
in the front top bow.
7. Push the front top bow latches down until they
“click.”
8. Swing your sun visors up and raise your antenna.
Reverse the steps to close your sunroof. Be sure your
front top bow
is latched securely. Make sure your rear
window is clean before you try
to
remove it. See “Special Care of Canvas Top and Plastic
Windows” in the Index.
1. Unfasten the canvas flaps at the lower corners of the
rear window to uncover the zipper pull.
2. Unzip the rear window. If the zipper is hard to move,
you can lubricate
it with beeswax, bar soap or
silicone spray. Remove the window.
ProCarManuals.com

I
Be sure to:
Fit the side and rear part of the window into the
frame before completely zipping the window.
Push the inner lip of the canvas top all the way in
7 ile zipping. After
completing installation, make sure that the front
and bottom ends are securely hooked and the rear top
end of the window is under the canvas top.
ProCarManuals.com

Lowering and Raising the Canvas Top
1. Remove the side windows of the canvas top as
shown previously.
2. Open the rear window and hang it down inside the
luggage compartment.
3. Unfasten the snaps on the driver’s and passenger’s
sides of the roof side tension belts.
4. Unfasten the snaps that secure the canvas top to the
roof piece. The snaps are located on either side of the
dome lamp.
ProCarManuals.com

-1 push both sides of the
5. Lower the sunvisors and
-
lock buttons on the front
latches.
6. Unhook the latches.
7. Pull back the swing arm, unfasten the five snaps that
secure the canvas to the swing arm and remove the
canvas from the swing
arm.
8. Return the swing arm forward and hook it securely
with the latches.
2-57
ProCarManuals.com

Cln: This message may appear on the display. If it does,
your cassette tape player needs to
be cleaned. It will still
play tapes, but you should clean it as soon as possible to
prevent damage to your tapes and player. See “Care of
Your Cassette Tape Player” in the Index. After you clean
the player, press and hold EJECT for
five seconds to
reset the Cln indicator. “---” will appear in the display to
show the indicator was reset.
Theft-Deterrent Feature
The theft-deterrent feature for the A” stereo with
cassette tape player can be used
or ignored. If ignored, the
system plays normally. If it is used, your system won’t be \
usable
if it’s ever stolen because it will go into LOC mode
anytime your vehicle loses battery power. The unlock code must be entered or the radio will not
turn on.
Setting Your Security Code
The following instructions will tell you how to enter a
security code
into the system. If your vehicle loses
battery power for any reason, you must enter the
security code again before the system will turn
on.
You are now ready to enter your security code. Don’t
wait more
than 15 seconds between steps.
Press
4 SEEK b or 4 TUNE and “0000” will appear
on the display.
Press SEEK
4 and hold it until the first digit of your
code appears. Release the button.
Press
SEEK b and hold it until the second digit of your
code appears. Release
the button.
Press
TUNE 4 and hold it until the third digit of your
code appears. Release the button.
Press
TUNE b and hold it until the fourth digit of your
code appears. Release the button.
Press
AM-FM after you have checked that the code you
entered
is the one you wrote down. “rEP’ will appear on
the display, which means you need to repeat steps 5
through 9.
Press AM-FM again and the display will now show
SEC.
Write down any four-digit number and keep it in a safe place.
Then turn the ignition switch to the ACC or ON position
and the audio system
off. Press the 1 and 4 buttons together.
Hold them down until
“----” shows on the display.
3-10
ProCarManuals.com

How to Shut Off the Theft-Deterrent Feature
If your radio is secured (SEC shows on the display) and
you wish to disable it, enter your security code as
follows, pausing no more than
15 seconds between
steps.
Press the 1 and
4 buttons together. Hold them down until
SEC shows
on the display. You are now ready to enter
your security code.
Press
the SEEK 4 button and hold it until the first digit
of your code appears.
Press the SEEK button and hold it
until the second
digit
of your code appears.
Press the TUNE
4 button and hold it until the third digit
of your code appears.
Press the
TUNE button and hold it until the fourth
di.git
of your code appears.
Press
AM-FM after you have checked that the code you
entered matches the one you wrote down. “0000” should
now appear
on the display and you will need to repeat
the above procedure.
If
the code is correct, the radio will now operate. If the
code
is wrong, Err will appear in the display.
To Unlock the System After a Power Loss
If power is disrupted to the radio while in the SEC
mode, the unit will not work and LOC will show on the
display whenever the ignition is
on. To unlock the unit,
press
4 SEEK b or 4 TUNE b and “0000” will appear
on the display.
Press the SEEK
4 button and hold it until the first digit
of your code appears.
Press the SEEK
b button and hold it until the second
digit of your code appears.
Press
the TUNE 4 button and hold it until the third digit
of your code appears.
Press the TUNE
b button and hold it until the fourth
digit
of your code appears.
Press
AM-FM after you have checked that the coae
matches the one you wrote down. Now the time of day
will appear
on the display. (Please note that if an
incorrect code is entered,
Err will appear on the display
and the above steps need to be repeated.)
ProCarManuals.com

Track Number and Playing Time: Press RCL A to
see which track is playing. Press
it again within five
seconds to see how long
it has been playing.
The track number
also appears when the disc is inserted
or you change the volume.
PRV: Press this button to hear a track again. If you hold
this button or press
it more than once, the disc will
return to previous tracks.
NXT Press this button to hear the next track now
(instead of waiting
until the present track is finished).
If you hold this button, or press
it more than once, the
disc will advance further.
REW Press and hold this button to return rapidly to a
favorite passage. Release it to play the passage.
FF: Press and hold this button to fast forward or
advance quickly within a track. Release
it to resume
playing.
COMP: Press this button to make soft and loud
passages more nearly equal in volume.
RPT Press this button once to hear a selection over
again.
RDM: Pressing this button will cause the CD player to
play the tracks back
in random order. To cancel the
random feature, press RDM or RPT.
STOP: Press this button or AM-FM to stop playing the
disc and switch to radio. Press STOP again to restart the
disc
at the point where it stopped.
CD-TP: Press this button to switch between playing a
tape and a CD when both are inserted.
EJECT: Press this button to eject the disc and the radio
will play. The disc will start playing at track 1 when you
reinsert
it.
Theft-Deterrent Feature
The theft-deterrent feature for the AM/FM stereo with
cassette tape and compact disc player can be used or
ignored.
If ignored, the system plays normally. If it is
used, your system won't be usable
if it's ever stolen
because
LOC will appear on the display when battery
power
is lost.
Setting Your Security Code
The following instructions will tell you how to enter a
security code into the system. If your vehicle loses
battery power for any reason, you must enter the
security code again before the system will
turn on.
ProCarManuals.com

Write down any four-digit number and keep it in a safe
place.
Turn the ignition switch to the
ACC or ON position.
Turn the audio system off.
Press the 1 and
4 buttons together. Hold them down until
(‘---- ” shows on the display.
You are now ready to enter your security code.
Don’t
wait more than 15 seconds between steps.
Press
SEEK 4 b and/or TUNE 4 b and “0000” will
appear
on the display.
Press
SEEK 4 and hold it until the first digit of your
code appears. Release the button.
Press SEEK and hold
it until the second digit of your
code appears. Release the button.
Press TUNE
4 and hold it until the third digit of your
code appears. Release the button.
Press
TUNE and hold it until the fourth digit of your
code appears. Release the button.
Press
AM-FM after you have checked that the code you
entered is the one you wrote down. “rEP” will appear
on
the display, which means you need to repeat steps 5
through 9.
Press AM-FM again and the display will now show SEC.
How to Shut Off the Theft-Deterrent Feature
If your radio is secured (SEC shows on the display) and
you wish to disable it, enter your security code as follows,
pausing
no more than 15 seconds between steps.
Press the
1 and 4 buttons together. Hold them down until
SEC shows on the display. You are now ready to enter
your security code.
Press
the SEEK 4 button and hold it until the first digit
of your code appears.
Press
the SEEK b button and‘hold it until the second
digit of your code appears.
Press the TUNE
4 button and hold it until the third digit
of your code appears.
Press
the TUNE b button and hold it until the fourth
digit
of your code appears.
Press
AM-FM after you have checked that the code you
entered matches
the one you wrote down. “---- ” should
now appear
on the display. The theft-deterrent feature is
now shut off.
If an incorrect code is entered, Err will appear on the
display. Repeat
the above procedure.
ProCarManuals.com