Downloaded from www.Manualslib.com manuals search engine These symbols are used on warning and indicator lights:
I
I-
I
ENGINE COOLANT
TEMPERATURE BATTERY CHARGING
SYSTEM
RADIATOR
COOLANT
BRAKE
ANTILOCK BRAKE
ENGINE
OIL
PRESSURE ENGINE
OIL
TEMPERATURE I FUEL
Here are some other symbols you may see:
1)
FUSE
-1
AIR 1 RADIO
SELECTOR
I
RADIO VOLUME
CONDITIONING I
LIGHTER
I
SPEAKER
L
TRUNK RELEASE
vi i
Downloaded from www.Manualslib.com manuals search engine Driver Information Center Messages
These messages will appear if there is a problem sensed in one of your
vehicle's svstems. Vehicles that arc first sold in Canada will have awnumber
after eachmessage. This number helps
to identify the message, which is
only displayed in English. c
APPLY BRAKE TO SHIFT - 46
This message will appear if your vehicle is in PARK (P) for about 15 seconds
and
the brake is not depressed. If VOLI do not want this message to appear,
you can cancel it by holding the OkF and the blue (cooler) button on the
Electronic Climate Control panel for about five seconds.
Hold the same two
buttons again to have this message displayed.
A/C OVERHEATED - A/C COMPRESSOR OFF - 15
If the refrigerant system ever reaches an over-yrcssure condition, this
message will appear to tell you that the air conditioning compressor has
been turned off. Air conditioned air will not be delivered to cool your
vehicle.
If the pressure returns to a normal operating range, vou must
message co11tinues
to appear, have the system repaired as soon as possible
to avoid compressor damage.
select
AUTO, DEFOG, 01- DEFROST to start the
compress& If this
BATTERY NO CHARGE - 07
This message will appear if your battery is not being charged. Have your
electrical system checlwJ by y~lr Cadi1l;lc dealership at your earliest
conxnience.
BATTERY VOLI'S HIGH - OS
This message shows that the electrical charging system is overcharging,
(more
than I6 volts). To avoid being stranded have the electrical system
checked
by your Cadillac dealership. You can reduce the charging
0verlo;d
by using the accessories. Turn on the lamps and radio, set the
climate cohtrol
on AUTO and the fan spced 011 HI, and turn the rear
window defogger on. You can monitor battery
voltage on the Driver
Information Center
by toggling the INFORMATION button. The normal
range is
11.5 to 15.5 volts when the engine is running.
2-87
Downloaded from www.Manualslib.com manuals search engine ENGINE HOT - A/C COMPRESSOR OFF - 16
This message will appear when thc Climatc Control is in AUTO or
DEFROST and the engine coolant is hotter than the normal operating
temperature.
To avoid added strain on a hot engine the air conditioning
compressor
is automatically turned off. When that happens, air
conditioned air
is not delivered. If the coolant temperature returns to
normal,
you must select AUTO, DEFOG or DEFROST to return to a
normal A/C compressor operation.
FUEL LEVEL VERY LOW - 11
This message serves as a warning that the fuel level in your tank is
critically low. It means you should stop for fuel immediately.
SERVICE A/C SYSTEM A/C COMPRESSOR OFF - 14
This message appears when the electronic sensors that control the A/C
and heating system are no ionger working. Have your Climate Control
system serviced
if you notice a drop in heating and A/C efficiency.
STARTING DISABLED DUE TO THEFT SYSTEM REMOVE
IGNITION KEY - 33
This message will apex when the Personalized Automotive Security
System (PASS-Key”-
11) senses tht ;In improper ignition key is being used
to try
to start the vehicle. Check the ignition key for damage. It’ it is
damaged,
it map need to be replaced. If you see no damage, clean the
pellet contacts
with a soft cloth or napkin. Remove the ignition key and ..I
wait for the Driver Information Center to display WAIT 3 MINUTES.
The instrumcnt panel cluster will then run a timer and change the
messages to WAIT 2 MINUTES, WAIT 1 MINUTE, and then START
CAR. When the START CAR message is displayed, try again to start the
engine.
u
c
c c
SERVICE NOW - REFER TO OWNERS MANUAL - 02
This message appears ifvou have a problem with thc Powertriliu Control
M0d~1le (PCM). To corrict this problem have your vehicle serviced at
your Cadillac dealership.
SERVICE RIDE CONTROL - 84
This message is displayed to indicate that the Suspension System is not
operating properlv. To correct this problem haw your vehicle serviced at
your Cadillac deaiership.
CI
Downloaded from www.Manualslib.com manuals search engine TRANS FLUID RESET - 48
With the engine not running and the ignition ON, press and hold the OFF
and REAR DEFOG buttons until the TRANS FLUID RESET message
appears
in the Information Ce.nter (bctween five and 20 seconds).
TURN SIGNAL ON - 20
This message is a reminder, after driving about a mile, that you have your
turn signal on.
TRUNK OPEN - 24
This message indicates that your trunk is open when the ignition is ON.
VERY LOW REFRIGERANT A/C COMPRESSOR OFF - 12
This message means that the Air Conditioning system detects a
refrigerant level that is low enough to cause damage to the A/C
compressor.
To avoid damage, the A/C compressor automatically turns off
and the Electronic Climate Control will automatically switch from AUTO
to ECON and remain there. Have your A/C system serviced if this
message appears.
k
Downloaded from www.Manualslib.com manuals search engine 1 SECTION 3
I
COMFORT CONTROLS AND AUDIO SYSTEMS
In this section you'll find out how to operate the comfort control systems
and audio systenx offered
with your Cadillac. Be sure to read about the
particular system supplied
with your vehicle.
YOUR CADILLACAIR SYSTEM
Outside Air
Outside air flows through your vehicle when it is moving. It enters your
vehicle through an inlet at
the base of the windshield. Keep this area clear
of dcbris. Under most operating conditions this system uses outside air
when heating or cooling your vehicle. If you select the 60" F (16' C)
AUTO setting, a door will close to stop the flow of most outside air
allowing recirculated interior air to cool your vehicle. Your vehicle can
also use this recirculate mode during normal auto air conditioning if
maximum cooling is needed to maintain the selected temperature.
Air Outlets
.. , . .. .
Air outlets are located
in the center and at
each side of the
instrument panel.
You
can adjust the direction
of airflow by moving
the center cbntrol
levers
or stop the
airflow bv moving the
lever locked
on each
side of the outlets
downward.
3- 1
Downloaded from www.Manualslib.com manuals search engine Electronic Climate Control Features
A/C Purge
If your vehicle is sitting out on a hot day and you have it set on AUTO,
the air will first flow out the floor air ducts for a few seconds. That is
normal. This is to
expel hot air in the air ducts. As the air is cooled. the
flow will move through the A/C outlets. If you start your vehicle with the
fan setting on HI it will skip the A/C Purge.
Cold Weather Purge
On cold days when your system is first turned on, in either the AUTO or
ECON setting? and the fan setting is not on HI, a small amount of air will
flow through thc defroster duct whilc the system is waiting for the engine
coolant
to warm up enough to provide hcat. This prevents your breath
from fogging your windshield. As the coolant warm up, the blower fan
specd
will gradually increase and air will flow from the heater outlets,
with some airflow to the windshield to prevent fogging under most normal
conditions.
Manually Recirculate Inside Air
u
There may be times whcn vou want less air from the outside. To
recirculate the air from thi inside, in the AUTO setting, just set the
temperature to 60” F (16* C) and adjust your fan speed:
DEFOG
Press this button to divide the air between the windshield and the heater
ducts.
This is useful when fog appears on the windshield or side glass due
to sudden rain or snowy conditions.
Fan Speeds
/+
Press the fan symbol
button until AUTO is
displayed on the
screen.
At this setting, the fan speed is controlled automatically.
If it is cold outside, the blower may not run in the maximum high fan
speed right away. The system checks the temperature of the coolant to
assure it is warm enough to provide heat. When thc coolant is warnl, the
Downloaded from www.Manualslib.com manuals search engine c
L
controller allows the Can to gradually incrcase to a higher speed. This
prevcnts cold air from blowing into the passenger compartment.
If \/ou want the blowcr fan to run only at a ked high speed, press the
(upper) button
until you sce HI on the display.
If you want the fan speed to be automatic, but vou like the fan speed to be
higher than the AUTO setting. just press the fan button until HI/AUTO is
shown on thc display.
If you want the blowcr to ~LIII only at a fixed low speed, press the (lower)
huttot1 until LO is shown on the display.
Press this button to
removc fog or frost
from the windshield.
This setting sends most of the airflow to the windshield with only a small
amount to the floor outlets.
The fan speed will work automatically to maintain vour rsqussted interior
temperature.
If you need more air directed to yourbindshield, you should
select a higher fan speed.
in some cold start conditions, the AUTO blower fan speed may be limited
until the
engine cooling system warms up. This is normal to prevent
windshield fogging.
It will help if you first clear any ice and snow from the hood and the air
inlet
(it’s between the hood and the windshield).
Downloaded from www.Manualslib.com manuals search engine To Play a Compact Disc
NOTICE:
Before you begin, please note: don’t use the mini-discs that are
called “singles” (even with an adapter). They won’t eject. Use
full-size compact discs only.
1. Turn the radio on.
2. Insert the CD (label side up) partway into the slot. The player will pull
it in. Wait a few seconds and the CD will play. Then only the time of
day and CD will display.
If the CD comes back out. chcck to see if
The disc is upside down.
The disc is dirty, scratched or wet.
0 There is too much moisture in the air. If there is, wait about an hour
and try
it again.
ERR: This error message is displayed if you have a condition of either
extreme temperature, moisture
or an incorrect CD. The CD will
automatically be ejected. When conditions are back to normal the CD
should play again.
RCLIPROG: Press the recall/program button once to see what track is
being plaved. Within five seconds press it a second time to see how long
the track-has been playing. Press
it a third time to see thc time of day.
REV: Press and hold the reverse button to return rapidly within a track.
Release
it to play the passage. The elapsed time will be displayed to show
the reverse progress of the CD.
FWD: Press and hold this forward button to advance rapidly within a
track. Release it to resume playing. Elapsed time will be displayed to show
the forward progress
of the CD.
3-20
H
U
I
L-
c- .
c