1995 AUDI A4 engine

13-1


Engine, disassembling and
assembling

Lock carrier, moving into service
position


Special tools and equipment

Special tool 3369
Pa
ge 1 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1

13-20

Installing

- Attach ribbed belt to pulleys from crankshaft and
vane pump and, if necessary, pull up with
auxiliary tool.

- Swivel tensioner for ribbed belt in direction of arrow.
- Install ribbed belt over Generator pulley last. Release tensioner.
- Check that ribbed belt is properly seated.
- Fit ribbed belt for A/C compressor.

Ribbed belt routing Fig. 2
, Page 13
-17

- Attach torque wrench at "7 o'clock position" as illustrated to hex on
tensioner and pretension to 30 Nm.
- While tensioning, tighten bolts -A- to 23 Nm.
- Start engine and check belt running.
Pa
ge 20 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1

13-41

Removing

Engine in vehicle.
Lock carrier must be in service position
Page 13
-1 .

- Remove engine cover -arrows-.
- Remove ribbed belt and tensioner for ribbed belt Page 13
-18
.

- Secure pulley for viscous fan with pin punch -1- and remove using
Allen key -2-.
- Remove viscous fan from mounting.
- Remove upper toothed belt guard.
Pa
ge 42 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1