Page 57 of 90

24-48
      
Checking for leaks  
     
-  Bridge sockets 1 and 65 on the test box using 
test leads from VAG1594 A connector test kit. 
(This creates an Ground (GND) connection to 
one side of the fuel pump relay coil.) 
     
Note:  
     Once the socket are bridged the fuel pump runs 
continuously, even if the engine is not running. 
This is because the fuel pump relay receives its 
positive voltage supply via the central electrics. 
The negative voltage supply for the fuel pump 
relay comes via the cable bridge on the test box. 
     
WARNING! 
     
Fire hazard. DO NOT smoke or work near 
heaters or have anything in the area that can 
ignite fuel! 
     
-  Check injectors fuel for leaks (visual check). 
When fuel pump is running, only 1 or 2 drops 
should escape per minute from each injector. 
     
-  If fuel loss is greater, switch off fuel pump 
(remove bridge) and replace faulty injector   
Page 24
-53
 , also observe notes on   Page 24
-
53
 . 
Pa
ge 57 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
         
        
        
     
        
        Page 59 of 90
24-49
 
    
WARNING! 
Make sure test box is inside of passenger compartment. 
The fuel pump should run.  -  Connect one fuel injector terminal to engine Ground (GND) using test 
cable and crocodile clamp from VAG1594 connector test kit. 
-  Connect second fuel injector terminal to B+ using remote control 
VAG1348/3 A, adapter cable VAG1348/3-2 and auxiliary cable. 
-  Bridge sockets 1 and 65 on the test box using test leads from 
VAG1594 A connector test kit. (This creates an Ground (GND) 
connection to one side of the fuel pump relay coil.) 
Pa
ge 59 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
         
        
        
     
        
        Page 60 of 90
24-50
      
-  Activate remote control VAG1348/3 A for 30 
seconds. 
     
-  When all three fuel injectors from the first bank 
of cylinders have been activated, place the three 
measuring glasses on a level surface. 
     
   Specified value for each fuel injector: 135 ... 165 
ml 
     
-  If measured value for one or more of fuel 
injectors is outside tolerance range, switch off 
fuel pump (switch ignition off) and replace faulty 
fuel injector   Page 24
-53
 , also observe notes 
on  Page 24
-53
 . 
Pa
ge 60 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
         
        
        
     
        
        Page 64 of 90
24-54
      
Fuel Pump (FP) relay -J17 and relay 
activation, checking
 
     
Note:  
    
The fuel pump relay is located in the central electrics in the left-hand 
footwell, relay position 4. 
A - Checking Fuel Pump (FP) relay -J17  
-  Remove storage bin in front left-hand footwell.
    
 Electrical Wiring Diagrams, Troubleshooting & Component Locations   
The fuel pump relay should pick up (can be felt and heard) and the diode 
test lamp should light up.  -  Remove fuel pump fuse from fuse holder and connect diode test lamp 
VAG1527 between Ground and one of the two contacts for the fuel 
pump fuse. -  Operate starter briefly. 
-  If fuel pump relay does not pick up, check activation   Page 24
-56
 .
Pa
ge 64 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
         
        
        
     
        
        Page 65 of 90
24-55
      
-  If fuel pump relay picks up but diode test lamp 
does not light up, repeat test on other terminal. 
    
 Electrical Wiring Diagrams, Troubleshooting & Component Locations    -  If diode test lamp still does not light up, test for open circuit in wiring 
between fuel pump fuse and terminal 23 in relay position 4. If 
necessary, rectify open circuit. -  If voltage supply, activation and wiring for fuel pump relay are OK, 
install new fuel pump relay. 
Pa
ge 65 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
         
        
        
     
        
        Page 66 of 90
24-56
      
B - Checking voltage supply and activation of 
fuel pump relay  
     
Note:  
     Activation of the fuel pump relay can also be 
tested using the final control diagnosis   Page 
01
-75
 . 
     
-  Remove fuel pump relay -J17 from central 
electrics, relay position 4. 
     
Checking voltage supply  
     
-  Switch ignition on.
    
Specification: approx. battery voltage in each case  
 Electrical Wiring Diagrams, Troubleshooting & Component Locations    -  Connect hand-held multimeter VAG1526 between Ground (GND) and 
relay panel contact 19 (B+; terminal 15 from ignition switch). 
Disconnect, then re-connect between Ground (GND) and relay panel 
contact 17 (permanent B+; terminal 30 from battery). 
-  If values are not as specified, rectify open circuit.
Pa
ge 66 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
         
        
        
     
        
        Page 67 of 90
24-57
      
Checking activation  
    
Note:  
Diode test lamps with a low current draw do not go out completely but 
continue to glow faintly until the starter is operated. 
If the diode test lamp does not light up, test the wiring as follows:  -  Connect diode test lamp VAG1527 between B+ and contact 16 on 
relay panel (Ground connection via engine control module). 
-  Operate starter briefly. 
-  The diode test lamp should light up and remain lit when the starter is 
operated. 
-  If activation, wiring and power supply for fuel pump relay are OK but 
fuel pump relay still does not pick up, replace fuel pump relay. 
-  Connect VAG1598/31 test box to wiring harness for engine control 
module. Do not connect to the engine control module itself   Page 24
-
20
 . 
Pa
ge 67 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
         
        
        
     
        
        Page 68 of 90
24-58
      
-  Connect hand-held multimeter between contact 
16 on relay panel and socket 65 on the test box, 
then test wiring for open circuits. 
     
-  Rectify open circuit if necessary.
     
       Electrical Wiring Diagrams, Troubleshooting & 
Component Locations        
-  If there is no open circuit and the diode test lamp 
still does not light up: 
     
-  Replace Engine Control Module (ECM)   Page 
24
-24
 . 
     
-  Reinstall fuel pump fuse.
Pa
ge 68 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1