1994 TOYOTA CAMRY diagram

1
FOREWORD
This wiring diagram manual has been prepared to provide
information on the electrical system of the 1994 TOYOTA
CAMRY.
Applicable models: SXV10 Series
MCV10 Series
For service specifications and repair procedures of the above
models other than those listed in this manual, refer to the
following manuals;
Manual Name
Pub. No.
1994 CAMRY Repair Manual
Volume 1
Volume 2
1994 Model New Car Features
RM361U1
RM361U2
NCF099U
All information in this manual is based on the latest product
information at the time of publication. However, specifications
and procedures are subject to change without notice.
TOYOTA MOTOR CORPORATION
When handling supplemental restraint system components (removal,
installation or inspection, etc.), always follow the direction given in the repair
manuals listed above to prevent accidents and supplemental restraint
system malfunction.
NOTICE

2
INTRODUCTION
This manual consists of the following 11 sections:
No.
SectionDescription
A
INDEXIndex of the contents of this manual.
A
INTRODUCTIONBrief explanation of each section.
BHOW TO USE
THIS MANUALInstructions on how to use this manual.
CTROUBLE±
SHOOTINGDescribes the basic inspection procedures for electrical circuits.
DABBREVIATIONSDefines the abbreviations used in this manual.
E
GLOSSARY OF
TERMS AND
SYMBOLS
Defines the symbols and functions of major parts.
FRELAY LOCATIONSShows position of the Electronic Control Unit, Relays, Relay Block, etc.
This section is closely related to the system circuit.
GELECTRICAL
WIRING ROUTINGDescribes position of Parts Connectors, Splice points, Ground points, etc.
This section is closely related to the system circuit.
HPOWER SOURCE
(Current Flow Chart)Describes power distribution from the power supply to various electrical
loads.
INDEXIndex of the system circuits.
I
SYSTEM CIRCUITS
Electrical circuits of each system are shown from the power supply through
ground points. Wiring connections and their positions are shown and
classified by code according to the connection method. (Refer to the
section, ªHow to use this manualº).
The ªSystem Outlineº and ªService Hintsº useful for troubleshooting are
also contained in this section.
JGROUND POINTSShows ground positions of all parts described in this manual.
KOVERALL
WIRING DIAGRAMProvides circuit diagrams showing the circuit connections.

3
HOW TO USE THIS MANUAL
This manual provides information on the electrical circuits installed on vehicles by
dividing them into a circuit for each system.
The actual wiring of each system circuit is shown from the point where the power source
is received from the battery as far as each ground point. (All circuit diagrams are shown
with the switches in the OFF position.)
When troubleshooting any problem, first understand the operation of the circuit where
the problem was detected (see System Circuit section), the power source supplying
power to that circuit (see Power Source section), and the ground points (see Ground
Points section). See the System Outline to understand the circuit operation.
When the circuit operation is understood, begin troubleshooting of the problem circuit
to isolate the cause. Use Relay Location and Electrical Wire Routing sections to find
each part, junction block and wiring harness connectors, wiring harness and wiring
harness connectors, splice points, and ground points of each system circuit. Internal
wiring for each junction block is also provided for better understanding of connection
within a junction block.
Wiring related to each system is indicated in each system circuit by arrows (from

, to ). When overall connections are required, see the Overall Wiring Diagram
at the end of this manual.

* The system shown here is an EXAMPLE ONLY. It is different to the actual circuit shown in the SYSTEM CIRCUITS SECTION.
POWER SOURCE (Current Flow Chart)
The chart below shows the route by which current flows from the battery to each electrical source (Fusible Link, Circuit
Breaker, Fuse, etc.) and other parts.
The next page and following pages show the parts to which each electrical source outputs current.
POWER SOURCE
8
HOW TO USE THIS MANUAL
The ªCurrent Flow Chartº section, describes which parts each power source (fuses, fusible links, and circuit breakers)
transmits current to. In the Power Source circuit diagram, the conditions when battery power is supplied to each system are
explained. Since all System Circuit diagrams start from the power source, the power source system must be fully understood.

* The system shown here is an EXAMPLE ONLY. It is different to the actual circuit shown in the SYSTEM CIRCUITS SECTION.
GROUND POINT
9
The ground points circuit diagram shows the connections from all major parts to the respective ground points. When
troubleshooting a faulty ground point, checking the system circuits which use a common ground may help you identify the
problem ground quickly. The relationship between ground points ( , , and shown below) can also be
checked this way.

17
1. NORMALLY
OPENOpens and
closes circuits,
thereby
stopping (1) or
allowing (2)
current flow.
RESISTOR
An electrical component with a
fixed resistance, placed in a circuit
to reduce voltage to a specific
value.
RESISTOR, TAPPED
A resistor which supplies two or
more different non adjustable
resistance values.
SENSOR (Thermistor)
A resistor which varies its
resistance with temperature.
SHORT PIN
Used to provide an unbroken
connection within a junction block.
SOLENOID
An electromagnetic coil which
forms a magnetic field when
current flows, to move a plunger,
etc.SWITCH, DOUBLE THROW
A switch which continuously
passes current through one set
of contacts or the other.
SWITCH,
IGNITION
A key operated switch with
several positions which allows
various circuits, particularly the
primary ignition circuit, to
become operational.
Wires are always
drawn as straight lines
on wiring diagrams.
Crossed wires (1)
without a black dot at
the junction are not
joined; crossed wires
(2) with a black dot or
octagonal (
) mark at
the junction are spliced
(joined) connections. RELAY, DOUBLE THROW
A relay which passes current
through one set of contacts or the
other.
SENSOR, ANALOG SPEED
Uses magnetic impulses to open
and close a switch to create a
signal for activation of other
components.TRANSISTOR
A solidstate device typically used
as an electronic relay; stops or
passes current depending on the
voltage applied at ªbase.º SWITCH, WIPER PARK
Automatically returns wipers to
the stop position when the wiper
switch is turned off. SWITCH, MANUAL SPEAKER
An electromechanical device
which creates sound waves from
current flow.
2. NORMALLY
CLOSED
RESISTOR, VARIABLE or
RHEOSTAT
A controllable resistor with a
variable rate of resistance.
Also called a potentiometer or
rheostat. 2. NORMALLY
OPEN RELAY
1. NORMALLY
CLOSEDBasically, an electrically
operated switch which may
be normally closed (1) or
open (2).
Current flow through a
small coil creates a
magnetic field which either
opens or closes an
attached switch.
(2) SPLICED WIRES
(1) NOT
CONNECTED

36
ELECTRICAL WIRING DIAGRAM
Position of Parts in Body
[Wagon]
A 19 ABS Speed Sensor Rear LH F 13 Front Tweeter (Speaker) LH P 11 Power Window Control SW Rear
A 20 ABS Speed Sensor Rear RH F 14 Front Tweeter (Speaker) RH RH
A 21 Auto Antenna Motor and Relay F 15 Fuel Pump and Sender P 12 Power Window Master SW and
Door Lock Control SW LH
D 10 Door Courtesy Light Front LH H 10 High Mount Stop Light P 13 Power Window Motor Front LH
D 11 Door Courtesy Light Front RH P 14 Power Window Motor Front RH
D 12 Door Courtesy SW Front LH I 14 Interior Light P 15 Power Window Motor Rear LH
D 13 Door Courtesy SW Front RH P 16 Power Window Motor Rear RH
D 14 Door Courtesy SW Rear LH L 1 License Plate Light
D 15 Door Courtesy SW Rear RH L 2 Light Failure Sensor R 8 Rear Combination Light LH
D 16 Door Key Cylinder Light and SW L 3 Luggage Compartment Light R 9 Rear Combination Light LH
D 17 Door Key Lock and Unlock SW LH L 4 Luggage Compartment Light SW R 10 Rear Combination Light RH
D 18 Door Key Lock and Unlock SW RH R 11 Rear Combination Light RH
D 19 Door Lock Control SW RH M 2 Moon Roof Control Relay R 12 Rear Speaker LH
D 20 Door Lock Motor and Door Unlock M 3 Moon Roof Control SW and R 13 Rear Speaker RH
Detection SW Front LH Personal Light (w/ Moon Roof) R 16 Rear Window Defogger (+)
D 21 Door Lock Motor and Door Unlock M 4 Moon Roof Limit SW R 17 Rear Window Defogger (±)
Detection SW Front RH M 5 Moon Roof Motor R 20 Remote Control Mirror LH
D 22 Door Lock Motor Rear LH R 21 Remote Control Mirror RH
D 23 Door Lock Motor Rear RH P 9 Power Window Control SW Front
RH V 8 Vanity Light LH
F 11 Front Door Speaker LH P 10 Power Window Control SW Rear V 9 Vanity Light RH
F 12 Front Door Speaker RH LH

ELECTRICAL WIRING DIAGRAM
-Memo