1994 PONTIAC FIREBIRD towing

NOTICE: NOTICE:
Holding your key in “Start” for
longer than
15 seconds at a time will
cause your battery to be drained
much sooner. And the excessive heat
can damage your starter motor.
2. If your engine won’t start (or starts but
then stops), it could be flooded with
too much gasoline. Try pushing your
accelerator pedal all
the way to the
floor and holding it there as you hold
the key in “Start” for about three
seconds. If the vehicle starts briefly
but then stops again, do
the same
thing, but this time keep the pedal
down for five or six seconds. This
clears the extra gasoline from
the
engine Your
engine is designed to work with
the electronics in your vehicle. If you
add electrical parts or accessories,
you could change the way the fuel
injection system operates. Before
adding electrical equipment, check
with your dealer. If you don’t, your
engine might not perform properly.
If you ever have to have your vehicle
towed, see the part of this manual
that tells how to do
it without
damaging your vehicle. See “Towing
Your Vehicle” in
the Index.
To start your VS engine:
1. Without pushing the accelerator
pedal, turn the ignition key to “Start.”
When the engine starts, let go of the
key. The idle speed will go down as
your engine gets warm.
Holding your key in “Start” for
longer than
15 seconds at a time will
cause your battery
to be drained
much sooner.. And the excessive heat
2. If it doesn’t start within 10 seconds,
push the accelerator pedal all the
way to the floor, while
you hold the
ignition key in “Start.” When the
engine starts, let go of the key and
let up on the accelerator pedal. Wait
about
15 seconds between each try to
help avoid draining your battery.
1
53. .
ProCarManuals.com

Features and Controls
When starting your engine in very cold
weather (below 0°F or
- 18”C), do this:
1.
2.
With your foot off the accelerator
pedal, turn the ignition key to “Start”
and hold it there. When the engine
starts, let go of the key. Use the
accelerator pedal to maintain engine
speed, if you have to, until your
engine has
run for a while.
If your engine still won’t start (or
starts but then stops), it could be
flooded with too much gasoline.
Try
pushing your accelerator pedal all the
way to the floor and holding it there
as you hold the key
in “Start” for
about three seconds. If the vehicle
starts briefly but then stops again, do
the same thing, but this time keep the
pedal down for five or six seconds.
This clears
the extra gasoline from
the engine.
NOTICE:
Your engine is designed to work with
the electronics in your vehicle. If you
add electrical parts or accessories,
you could change the way
the fuel
injection system operates. Before
adding electrical equipment, check
with your dealer. If you don’t, your
engine might not perform properly.
If you
ever have to have your vehicle
towed, see the part of this manual
that tells how to do it without
damaging your vehicle. See “Towing
Your Vehicle” in the Index.
Driving through Deep
Standing Water
NOTICE:
If you drive too quickly through deep
puddles or standing water, water can
come in through your engine’s air
intake and badly damage your
engine. If you can’t avoid deep
puddles or standing water, drive
through them very slowly.
Performance Mode Switch
(Option)
This switch lets you change from a
normal driving mode to a performance
mode. When you start the engine, the switch will be in normal mode. For
general driving conditions, use the
normal mode. It will remain
in normal
unless you select the “PERFORM”
feature.
For a firmer shift and increased
performance, you may choose the
“PERFORM, mode. The light in the
center
of the switch will light up when
selected. The switch will then remain in
“PERFORMANCE’ mode until the
engine is shut off, when it will go back to
normal mode.
... 54
ProCarManuals.com

Features and Controls
@ Automatic Overdrive
This position is for normal driving. If you
need more power far passing, and you’re:
- Going less than about 35 mph
(56 kdh), push your accelerator
pedal about halfway down.
- Going about 35 mph (56 km/h) or
more, push the accelerator all
the way
down.
You’ll shift down to the
next gear and
have more power.
D (Third Gear)
This is like @ , but you never go into
Overdrive.
Here are some times you might choose
“D’ instead of @ :
- When driving on hilly, winding roads
- When towing a trailer, so there is less
shifting between gears
- When going down a steep hill
2 (Second Gear)
This position gives you more power but
lower fuel economy.
You can use “2” on
hills. It can help control your speed as
you go down steep mountain roads, but
then you would also want to use your
brakes off and on.
NOTICE:
Don’t drive in “2” (Second Gear)
for more than
5 miles (8 km), or at
speeds over
55 mph (88 kmh), or
you can damage your transmission.
Use
(EJ or “D” as much as possible.
Don’t shift into
“2” unless you
are going slower than
65 mph
( 105 km/h), or you can damage
your engine.
1 (First Gear)
This position gives you even more power
(but lower fuel economy) than
“2.” You
can use it on very steep hills, or in deep
snow or mud. If the selector lever is put
in
“I,” the transmission won’t shift into
first gear until fhe vehicle is going slowly
enough.
NOTICE:
If your rear wheels can’t rotate, don’t
try to drive. This might happen if you
were stuck in very deep sand or mud
or were up against a solid object.
You
could damage your transmission.
Also, if you stop when going uphill,
don’t hold your vehicle there with
only the accelerator pedal. This could overheat and damage the transmission. Use your brakes or
shift into
“P” (Park) to hold your
vehicle in position on a hill.
Maximum engine speed is limited
to
protect driveline components from improper operation.
... 58
ProCarManuals.com

Parking
Parking Brake
The parking brake uses the brakes on the
rear wheels.
To set the parking brake: Hold the brake
pedal down and pull up on the parking brake lever. If the ignition is on, the brake
system warning light will come on.
To release the parking brake: Hold the
brake pedal down.
Pull the parking brake
lever up until you can push in the release
button. Hold the release button in as you
move the brake lever all the way down.
NOTICE:
Driving with the parking brake on
can cause your rear brakes to over-
heat. You may have to replace them,
and you could also damage other
parts of your vehicle.
If you are towing a trailer and are
parking on any hill:
See “Towing a
Trailer” in the Index. That section shows
what to do first to keep the trailer from
moving.
63 ...
ProCarManuals.com

Torque Lock
(AUTOMATIC TRANSMISSION)
If you are parking on a hill and you don’t
shift your transmission into “P” (Park)
properly, the weight of the vehicle may
put too much force on the parking pawl in
the transmission. You may find it difficult
to pull the shift lever out of “P” (Park)
This is called “torque lock.” To prevent
torque lock, set the parking brake and
then shift into “P’7 (Park) properly before
you leave the driver’s Seat. To find out
how, see “Shifting Into “P” (Park)” in
the Index.
When you are ready to drive, move the
shift lever out of
“P” (Park) BEFORE you
release the parking brake.
If “torque lock” does occur, you may
need to have another vehicle push yours
a little uphill to take some of the pressure
from the transmission,
so you can pull the
shift lever out of “P” (Park).
Shifting out of P (Park)
(AUTOMATIC TRANSMISSION)
Your Pontiac has a brake-transmission
shift interlock. You have to fully apply
your regular brake before you can shift
from “P” (Park) when the ignition is in
the “Run” position. See “Automatic
Transmission” in the Index.
If you cannot shift out of
“F”’ (Park), ease
pressure on the shift lever
- push the
shift lever all the way into
“P” (Park) and
release the shift lever button as you
maintain brake application. Then press
the shift lever button and move the shift
lever into the gear you wish.
If you ever hold the brake pedal down but
still can’t shift out of
“P” (Park), try this:
1. Turn the key to “Off.”
2. Apply and hold the brake until the end
3. Shift to “N’ (Neutral).
4. Start the vehicle and then shift to the
drive gear you want.
of
Step
4.
5. Have the vehicle fixed as soon as you
can.
Parking Your Vehicle
(MANUAL TRANSMISSION)
Before you get out of your vehicle, put
your manual transmission in
“R’
(Reverse) and firmly apply the parking
brake.
If your vehicle is equipped
to tow a
trailer, see “Towing a Trailer” in the
Index.
65..
ProCarManuals.com

Running Your Engine While
You’re
Parked (AUTOMATIC
TRANSMISSION)
It’s better not to park with the engine
running. But if you ever have to, here are
some things to know.
Follow the proper steps to be sure your
vehicle won’t move. See “Shifting Into
“P” (Park)” in the Index.
[f you are parlung on a hill and if you’re
pulling a trailer, also see “Towing a
Trailer’’ in the Index.
Windows
Manual Windows
Use the window crank to open and close
each door window.
, , -.
67. .
ProCarManuals.com

If the light comes on while you are driving, pull
off the road and stop
carefully.
You may notice that the pedal is
harder to push. Or, the pedal may
go
closer to the floor. It may take longer to
stop. If the light is still on,
or if the
anti-lock brake system warning light is
flashing, have the vehicle towed for
service. (See “Anti-Lock Brake System
Warning Light” and “Towing Your
Vehicle” in
the Index.) The brake
system warning light will also
come on when you set your parlung
brake, and it will stay on if your parking
brake doesn’t release fully. If
it stays on
after your parking brake
is fully released,
it means
you have a brake problem.
Anti-Lock Brake System Warning
Light
With anti-lock, this light will come on
when you start your engine and it will
stay on for three seconds. That’s normal.
If the light doesn’t come on, have it fixed
so it will be ready to warn you if there is a
problem.
If the light flashes when you’re driving,
you don’t have anti-lock brakes and
there’s a problem with your regular
brakes. Pull
off the road and stop
carefully.
You may notice that the pedal is
harder to push. Or, the pedal may go
closer to the floor. It may take longer to
stop. Have the vehicle towed for service.
(See “Towing
Your Vehicle” in the
Index.)
91 ...
ProCarManuals.com

Your Driving and the Road
You can run the engine to keep warm, but
be careful.
Run your engine only as long as you
must. This saves fuel. When you run the
engine, make it
go a little faster than just
idle. That
is, push the accelerator slightly.
This uses less fuel for the heat that you
get and it keeps the battery charged.
You
will need a well-charged battery to restart
the vehicle, and possibly for signaling
later on with your headlights. Let the
heater run for awhile. Then, shut the engine
off and close the
window almost
all the way to preserve-the
heat. Start the engine again and repeat this only when you feel really uncomfortable
from the cold. But do it as little
as
possible. Preserve the fuel as long as you
can. To help keep warm, you can get out
of the vehicle and do some fairly vigorous
exercises every half hour or
so until help
comes.
Towing a Trailer
. . .I44
ProCarManuals.com