1994 PONTIAC FIREBIRD tow

When you call, tell the towing service:
That your vehicle cannot be towed
from the front or rear with
sling-type equipment.
drive.
That your vehicle has rear-wheel
The make, model, and year of your
Whether you can still move the shift
If there was an accident, what was
When the towing service arrives, let the
tow operator know that this manual
contains detailed towing instructions
and illustrations. The operator may
want to see them. vehicle.
lever.
damaged.
;.
157 I I.
I rl
ProCarManuals.com

Problems on the Road
When your vehicle is being towed, have
the ignition key off. The steering wheel
should be clamped in a straight-ahead
position, with a clamping device designed
for towing service. Do not use the
vehicle’s steering column lock for this.
The transmission should be in “Neutral”
and the parking brake released.
Don’t have your vehicle towed on the rear
wheels, unless you must. If the vehicle
must be towed on the rear wheels, don’t
go more than 35 mph (55 km/h) or farther
than
50 miles (80 km) or your
transmission will be damaged. If these
limits must be exceeded, then the rear
wheels have to be supported on a dolly. Front Towing Hook-Ups
Attach T-hook chains to slots in frame
rearward
of front wheels on both sides.
NOTICE:
Do not attach winch cables or “J”
hooks to suspension components
when using car carrier equipment.
Always use T-hooks inserted in the
T-hook slots.
1
. . .158
ProCarManuals.com

I
I
NOTICE:
Do not tow with sling-type equiment
or fascia/fog light damage will occur.
Use wheel lift or car carrier equip-
ment. Additional ramping may be
required for car carrier equipment.
Use safety chains and wheel straps. Attach a
separate safety chain around
outboard end of each lower control arm.
~TICE:
I
Take care not to damage the brake
pipes and hoses or the
ABS sensor
and wiring.
NOTICE:
Towing a vehicle over rough surfaces
could damage a vehicle. Damage can
occur from vehicle-to-ground
or vehicle-to-wheel-lift-equipment
contact.
To help avoid damage,
install a towing dolly and raise
vehicle until adequate clearance is
obtained between the ground and/or
wheel-lift equipment.
4
159 ...
ProCarManuals.com

Problems on the Road
c
Rear Towing Hook-Ups
Attach T-hook chains in front of rear
wheels in bottom of frame
rail on both
sides.
NOTICE:
Do not attach winch cables or “J”
hooks to suspension components
when using car carrier equipment.
Always use T-hooks inserted in the
T-hook slgts.
b
NOTICE:
Do not tow with sling-type equip-
ment or rear bumper valance will be
damaged.
Use wheel lift or car carrier equip-
ment. Additional ramping may be
required for car carrier equipment.
Use safety chains and wheel straps. Attach a separate safety chain around
outboard end of the rear axle.
I NOTICE:
I
Take care not to damage the brake
pipes and cables.
c
1
. . .160
ProCarManuals.com

I NOTICE:
Towing a vehicle over rough surfaces
could damage a vehicle. Damage
can occur from vehicle-to-ground
or vehicle-to-wheel-lift-equipment
contact.
To help avoid damage, install
a towing dolly and raise vehicle until
adequate clearance is obtained between
the ground and/or wheel-lift equipment.
Engine Overheating
I
If Steam Is Coming from Your Engine:
You will find a coolant temperature gage
on your Pontiac’s instrument panel.
You may also find a low coolant warning
light
on your Pontiac instrument panel.
161 .
ProCarManuals.com

Problems on the Road
If your engine catches fire because
you keep driving with no coolant,
your vehicle can be badly darhaged.
The costly repairs would not be
covered by your warranty.
If No Steam Is Coming from Your
Engine:
If you get the overheat warning but see
or hear
no steam, the problem may not be
too serious. Sometimes the engine can gel
a little too hot when you:
Climb a long hill on a hot day.
Stop after high speed driving.
0 Idle for long periods in traffic.
0 Tow a trailer. If you
get the overheat warning with
no
sign of steam, try this for a minute or so:
1. If you have an air conditioner, turn it
2. Turn on your heater to full hot at the
off.
highest
fan speed and
open the
window as necessary.
3. Try to keep your engine under load
(in a drive gear where the engine runs
slower).
If you no longer have the overheat
warning, you can drive. Just to be safe,
drive slower for about
ten minutes. If the
warning doesn’t come back
on, you can
drive normally.
If the warning continues, pull over, stop,
and park your vehicle right away.
If there’s still no sign of steam,
you can
idle the engine for two or three minutes
while you’re parked, to see if the warning
stops. But then, if you still have the
warning, TURN
OFF THE ENGINE
AND GET EVERYONE OUT
OF THE
VEHICLE until it cools down.
You may decide not to lift the hood but to
get service help right away.
Cooling System
When you decide it’s safe to lift the hood,
here’s what you’ll see on the V6 engine:
1. Coolant recovery tank
2. Radiator pressure cap
3. Electric engine fan
. . .I62
ProCarManuals.com

Problems on the Road
9. Shut the engine off and replace the
pressure cap. Be sure the arrows
on
the cap line up like this.
I
0. Then fill the coolant recovery tank to
;or a complete drain, flush and refill, see
‘our Pontiac dealer or a Pontiac Firebird
Iervice Manual. To purchase a service
nanual, see “Service Publications’’ in
he Index. the proper
level.
If a Tire Goes Flat
[t’s unusual for a tire to “blow out” while
you’re driving, especially
if you maintain
your tires properly. If air goes out of a
;ire, it’s much more likely to leak out
jlowly. But if you should ever have a
‘blowout,” here are a few tips about what
:o expect and what to do:
[fa front tire fails, the
flat tire will create
3 drag that pulls the vehicle toward that
side. Take your foot off the accelerator
pedal and grip the steering wheel firmly.
Steer to maintain lane position,
then
gently brake to a stop well out of the
traffic lane.
A rear blowout, particularly on a curve,
acts much like a
slud and may require the
same correction you’d use in a skid. In
any rear blowout, remove your foot from
the accelerator pedal. Get the vehicle
under control by steering the way you
want the vehicle to go.
It may be very
bumpy and noisy, but you can still steer.
Gently brake to a stop, well
off the road
if possible.
[f a tire goes flat, the next section shows
how to use your jacking equipment to
change a flat tire safely.
. . .I70
ProCarManuals.com

Remove: any rust or dirt from the wheel
bolts, mounting surfaces and spare wheel.
Place the spare on the wheel mounting
surface.
Replace the wheel nuts with the rounded
end
of the nuts toward the wheel. Tighten
each nut by hand until the wheel
is held
against the hub. Replace the wheel nuts with the rounded
end
of the nuts toward the wheel. Tighten
each nut by hand until the wheel
is held
against the hub.
,ewer the vehicle by rotating the wheel
vrench counterclockwise. Lower t&e jack
ompletely.
-4'
L:
-I .
177 ... ProCarManuals.com