1994 PONTIAC FIREBIRD radio controls

Comfort Controls and Audid Systems
Forward
Press and hold “FWD’ to quickly
advance within a track. Release it to
resume playing. The radio will play
during this operation.
Random
Press “RDM’ to hear a random selection
of tracks.
To Stop the Disc Player
Turn the power off or turn the ignition
key
off. The disc stays in the player
and will resume,playing at the point
where it stopped.
Press
“AM/FM’ to stop playing the
disc and switch to radio. Press
“CDPLAY” to restart the disc at the
point wherk it stopped.
Press “EJECT” to eject the disc or
stop the disc
arid switch to radio.
“EJECT” wili work with the ignition
or radio
off. Press “EJECT” to load a
disc when the audio system is
off.
rheft-Deterrent System
Your auklio system is equipped with the
‘THEFTLOCK” theft-deterrent system.
See “Theft-Deterrent System” at the end
3f this section.
rheft-Deterrent Feature
rHEFTZOCK is a security feature for the
Zassette tape and compact disc player. It
:an be used or ignored. If ignored, the
System functions normally:
If it is used,
your system won’t be usable if it’s ever
stolen. When the system is active, the
indicator light will flash while the ignition
is off.
Setting Your Security Code
The instructions below tell you how to
enter a security code into the system. If
your vehicle loses battery power for any
reason, you must enter the security code
again before the system will turn on.
1. Write down any number from 000 to
1999 and keep it in a safe place.
2. Turn the ignition switch to tHk “ACC”
or “Run” position.
3. T~irn the audio system off.
4. Press and hold pushbuttons “1” and
“4” together until “---” shows on the
display.
You are now ready to enter your security
:ode. Don’t wait more than
15 seconds
between steps.
5. Press “MIN” and “000” will appear
on the display.
6. Press “MIN’ again and hold until the
last two digits of your code appear.
Release the button.
7. Press “HR’ until the first one or two
digits of your code appears.
on tine display.
verification.
8. Press “A”.” “rEP” will appear
9. Repeat steps 5 through 7 for
10. Press “A”.” “SEC” will appear
on the display. This means that your audio system is secured.
. . .I20
ProCarManuals.com

Comfort Controls and Audio Systems
Care of Your Cassette Tape
Player
A tape player that is not cleaned regularly
can cause reduced sound quality, ruined
cassettes, or a damaged mechanism.
Cassette tapes should be stored in their
cases away from contaminants, direct
sunlight, and extreme heat.
If they aren’t,
they may not operate properly or cause
failure of the tape player.
Cassettes are subject to wear and the
sound quality may degrade over time.
Always make sure that the cassette tape
is in good condition before you have
your tape player serviced. Your
tape player should be cleaned
after every
50 hours of use for best
performance. If you notice a reduction in
sound quality, regardless of when the tape
player was last cleaned, try a known
good cassette to see
if the tape or the tape
player
is at fault. If this other cassette has
no improvement in sound quality, clean
the tape player.
Clean your tape player with a
scrubbing-action, non-abrasive cleaning
cassette. This wet-type cleaning system
uses a cleaning cassette with pads which
scrub the tape head as the hubs of the
cleaner cassette turn.
If you use this type
of cleaner, the radio
may eject the cartridge. This is normal,
and is the result of a feature in the tape
player that ejects broken tapes. If this
happens, you will need to insert the
cleaning cassette three times to
thoroughly clean
the tape player.
You may prefer to use a non-scrubbing
action wet-type cleaner. This type of cleaning cassette, which uses a fabric belt
to clean the tape head, will not be ejected
but may not clean the tape player as
thoroughly as the scrubbing type cleaner. Whichever method you choose, follow
the
instructions provided with the
cleaning cassette. Cleaning cassettes are
available in most stores that sell audio
products. A scrubbing action cleaning
cassette is available from your dealer
(GM Part No. 12344600).
. . .I22
ProCarManuals.com

Service and Appearance Care
Main Fuse Block
1 - Air Bag: SIR Components
2 - Backup Lights; Daytime Running (15
Amp.)
Lights Module (Canada); Turn
Flasher
(20 Amp.)
3 - HVAC Selector Switch (Heater/Ail
Conditioner); Rear Defogger
(25 Amp.)
4 - Powertrain Control Module;
Instrument Cluster; PASS-Key
II@
Decoder Module (10 Amp.)
5 - Powertrain Control Module;
PASS-Key
11s Decoder Module;
Fuel Pump Relay (15 Amp.)
;
6 - Brake LightKruise Release
Switch; Hazard Flasher
(20 Amp.)
7 - Power Door Locks; Power Mirrors;
Hatch Release (15 Amp.)
8
- Audio Alarm Module; Base@
Relay; Courtesy Lights: Console
Compartment, Glove Box, Dome,
Trunk, Rear Courtesy, Rearview
Mirror and Radio (15 Amp.)
9 - Audio Alarm Module; Daytime
Running Lights Module (Canada);
Diagnostic Energy Reserve
Module; Instrument Cluster; Remote Lock Control Module
( 10 Amp.)
10 - Exterior Lighting (20 Amp.)
11 - Cigarette Lighter; Horn Relay
12 - Power Seats; Rear Defogger
13 - Brightness Control (5 Amp.)
14 - Windshield Wipermasher
(25 Amp.)
15 - Power Windows, Convertible
Top Switch
(30 Amp. Circuit
Breaker)
Module
(3 Amp.)
(15 Amp.)
(25 Amp.)
(30 Amp. Circuit Breaker)
16 - Diagnostic Energy Reserve
17 - Radio; Steering Wheel Controls
. . ,230
ProCarManuals.com