1994 Oldsmobile Cutlass Supreme coolant

cold weather, 0°F (-18°C) or colder. If
your vehicle has this option, see
Engine
Coolant Heater
in the Index.
What to Do wifh Used Oil
Did you know that used engine oil
contains certain elements that may be
unhealthy for your skin and could even
cause cancer? Don’t let used oil stay on
your skin for very long. Clean your skin
and nails with soap and water, or a
good hand cleaner. Wash or properly
throw away clothing or rags containing
used engine oil.. (See the manufacturer’s
warnings about the use and disposal of
oil products.)
Used oil can be areal threat to the
environment. If you change your own
oil, be sure to drain all free-flowing oil
from the filter before disposal. Don’t
ever dispose of oil by putting it in the
trash, pouring it on the ground, into
sewers, or into streams or bodies of
water. Instead, recycle it by taking it to
a place that collects used oil. If you
have a problem properly disposing of
your used oil, ask your dealer, a service
station or a local recycling center for
help.
Air Cleaner
Refer to the Maintenance Schedule to
determine when to replace the air filter
and the crankcase ventilation filter.
See
Scheduled Maintenance Services i3
the
Index.
NOTICE:
If the air cleaner is off, a backfire
can cause a damaging engine fire.
And, dirt can easily get into your
engine, which will damage
it.
Always have the air cleaner in place
when you’re driving.
To Check or Replace the Air Filter:
1. Remove the four screws and pull off
the cover.
187

Twin Dual Cam 3.4L V6: Ad,ding
Automatic
Transaxle Fluid
I Engine .Coolant
The follciwing explains your cooling
system and how to add coolant when it
is low. If
you have a problem with
engine overheating or
if y0.u need to add
coolant to your radiator,
see Engine
Overheating in the Index.
The proper coolant for your Oldsmobile
will:
Give freezing protection down to-34”F
Give boiling protection up to 262°F
Protect againstrust and corrosion.
(-37°C).
(128°C).
Help keep the proper engine
Let the warning lights work as they
What to Use
temperature.
should.
Use
a mixture of one-half dean-water
(preferably distilled) and one-half
antifreeze that meets
“GM Specificatkm
1825-M,” which won’t damage
aluminum parts.
You can also use a
recycled coolant conforming
to GM
Specification 1825-M with
a complete coolant
flush and refill.
If you use this
mixture, you don’t need to add
anything
else.

NOTICE:
If you use an improper coolant mix,
your engine could overheat and be
badly damaged. The repair cost
wouldn’t be covered by your
warranty.
Too much water in the
mix can freeze and crack the
engine, radiator, heater core and other parts.
Adding Coolant
To Check Coolant
When your engine is cold, the coolant
level should be at the
COLD mark or a
little higher. When your engine is warm,
the level should be up to the
HOT mark
or a little higher.
1 SECURITY I
P
w OIL LOW
EVEL COOLANT I
If this light comes on, it means you’re
low on engine coolant.
To Add Coolant
If you need more coolant, add the
proper mix
at the coolant recovery
tank.
If the coolant recovery tank is
completely empty, add coolant to the
radiator. (See
Engine Overheating in
the
Index.)
191

Service & Appearance Care
Radiator Pressure Cap
NOTICE:
Your radiator cap is a 15 psi
(105kPa) pressure-type cap and
must be tightly. installed
io prevent
coolant loss and possible engine
damage from overheating. Be sure
the arrows on the cap line up with
192
Add coolant mix at the recovery tank,
but be careful not to spill it.
L I
the overflow tube on the radiator
filler neck.
I Power Steering Fluid
How To Check Power Steering
When you replace your radiator premre
cap, an
AC@ cap is recommended.
Thermostat
Engine coolant temperature is
controlled by a thermostat in the engine
coolant system. The thermostat stops
the flow of coolant through the radiator
until the coolant reaches a preset
temperature.
When you replace your thermostat, an
AC@ thermostat is recommended.
Fluid
-
Unscrew the cap and wipe the dipstick
with a clean rag. Replace the cap and
completely tighten it. Then remove the
cap again and look at the fluid level on
the dipstick.
When the engine compartment is hot,
the level should be at the
H mark.
When the engine compartment is
cool, the level 'should be at the
C
mark.
What to Add
Refer to the Maintenance Schedule to
determine what kind of fluid to use. See

FIuids & Lubricants
ITEM
Antifreeze Coolant ...................................
Chassis Lubricant (Grease Gun Insert) ..
(Ethylene Glycol Base)
Delco Supreme
11s Brake Fluid ............
Automatic Transmission Fluid. ...............
DFXRONB-I11 .....................................
DEXRONa-IIE .....................................
Engine Oil ................................................
GM Engine Oil Supplement (E.O. S .) .....
Engine Oil ...............................................
Windshield Washer Solvent ....................
Power Steering Fluid ..............................
Silicone Grease .......................................
Spray-A-Squeak Silicone Lubricant .......
APPLICATION GM PART NUMBER
Year-round antifreeze for .......................... .lo52753
coolant mixtures
General chassis lube, etc.
........................... 1052497
Brake System
............................................. 1052535
SIZE
1 gal. (3.8 L)
14 oz. (397 g)
16 oz. (0.5L)
Automatic Transaxle
.................................................................... 12346143 32 oz. (1 .OL)
.................................................................... 12345881 32 oz. (1.OL)
Engine lubrication
..................................... See the Index under Engine Oil.
See yourdealer for advice ......................... 1052367
Hood, trunk and door hinges
Windshield washer fluid
Power Steering System
............................. 1050017
1052884
Weatherstrips
............................................ .12345579
General purpose silicone lubricant
.......... .lo52276 (aerosol)
1052277
16 oz. (0.5 L)
32 oz. (1 .O L)
16 oz. (0.5 L)
1 oz. (28 g)
4.5 oz. (127 g)
12 oz. (0.35.L)
229

Maintenance Schedule
242 ~
Explanation of~scheduled
Mainfenance Services
Following are explanations of the
services listed in Schedule I and
Schedule
11.
The proper fluids and lubricants to use
are listed in Section D. Make sure
whoever services your vehicle
uses
these. All parts should be-replaced and
all necessary repairs done before you or
anyone else drives the vehicle.
ITEM SERVICE
NO.
1. Engine Oil and Filter Change* -
Always use SH or SG Energy
Conserving I1 oils of proper viscosity.
The “SH” or “SG” designation may
be shown alone or in combination
with others, such as “SH/CD,” “SH,
SG, CD,”“SG/CD,” etc. To
determine the preferred viscosity for
your vehicle’s engine (e.g., SAE 5W-
30 or SAE 10W-30), see
Engine Oil
in the Index.
2. Chassis Lubrication - Lubricate
suspension and steering linkage.
Lubricate the transaxle shift linkage,
and parking brake cable guides,
underbody contact points and
linkage.
3. Tire and Wheel Rotation and
Inspection
- For proper wear and
maximum tire life, rotate your tires
following the instructions in this
manual. See
Tires, Inspection 6
Rotation in the hdex. Check the
tires for uneven wear or damage.
If
you see irregular or premature wear,
check the wheel alignment. Check for
damaged wheels also.
Inspection *‘ - Inspect the belt for
cracks, fraying, wear and proper
tension. Replace as needed.
5. Camshaft Timing Belt Inspection
(3.4L Code X engine only) * -
Inspect for cracks, wear or oiliness.
Check tensioner for proper operation.
See the service manual.
(To purchase
4. Engine Accessory Drive Belt
a service manual, see Service
Publications
in the Index.) Replace
parts as needed.
6. Cooling System Service* - Drain,
flush and refill the system with new
or approved recycled. coolant
conforming
to GM Specification
1825M. Keep coolant at the proper
mixture as specified. See
Coolant in
the
Index. This provides proper
freeze and boil protection, corrosion
inhibitor level and maintains proper
engine operating temperature.
Inspect hoses and replace
if they are
cracked, swollen or deteriorated.
Clean the outside of the radiator and
air conditioning condenser. Wash the
pressure cap and neck.
To help ensure proper operation, we
recommend a pressure test of both
the cooling system and the pressure
cap.
7. Transaxle Service - Change both
the fluid and filter .every
15,000 miles
(25
000 lm) if the vehicle is mainly

Maintenance Schedule
244
Section B: Owner Checks and Services
Listed below are owner checks and services which. should
be performed at the intervals specified to help ensure the
safety, dependability and emission control performance of
your vehicle.
Be sure any necessary repairs are completed at once.
Whenever any fluids or lubricants are added to
your vehicle
make sure they are the proper ones, as shown in Section D.
At Each Fuel Fill -(It is important for you or a service station attendant to perform these underhood checks at each fuel fill.)
I
CHECK
OR SERVICE WHAT TO DO.
Engine Oil Level
Check
the engine oil level and add the proper oil if necessary. See Engine Oil in the Index for
further details.
Engine Index for further details.
Check
the engine coolant level and add the proper coolant mix if necessary. See Coolant in the
Windshield Washer Check the windshield washer fluid level in the windshield washer tank and add the proper fluid
if
Fluid Level necessary. See Windshield Washer Fluid in the Index for further details.
At Least Once Month
CHECK
OR SERVICE WHAT TO DO
Tire
Inflation Check
tire inflation. Make sure they are inflated to the pressures specified on the Tire-Loading
Information label located on the rear edge of the driver’s door. See Tires in the Index for
further details.
Cassette Deck
I
Clean cassette deck. Cleaning should be done every 15 hours of tape play, See Audio Systems in
the
Index for further details.

I Section D: Recommended Fluids and Lubricants
VOTE: Fluids and lubricants identified below by name, part number or specification may be obtained from your GM dealer.
I 248
USAGE
Engine Oil
Engine Coolant
Hydraulic Brake System
Parking Brake Guides
Power Steering System
Automatic Transaxle
Key Lock Cylinders
Automatic Transaxle Shift Linkage
FLUID/LUBRICANT
API service SH or SG Energy Conserving I1 oils of the proper viscosity. The “SH) or “SG’ designation
may be shown alone or
in combination with others, such as “SH/CD,” “SH,SG,CD,”“SG/CD,” etc.\
To
determine the preferred viscosity for your vehicle’s engine, see Engine Oil in the Index.
50/50 mixture of water (preferably distilled) and good quality ethylene glycol base antifreeze
(GM Part No. 1052753 or equivalent) conforming to GM Specification 1825M or approved
recycled coolant conforming to GM Specification
1825M.
Delco Supreme 1 1s Brake Fluid (GM Part No. 1052535 or equivalent DOT-3 brake fluid).
Chassis lubricant (GM Part No. 1052497 or equivalent) or lubricant meeting requirements of
NLGI Grade
2, Category LB or GC-LB.
GM Hydraulic Power Steering Fluid (GM Part No. 1052884 or equivalent).
DEXRONB-I11
or DEXRONB-IIE Automatic Transmission Fluid.
Lubricate with Multi-Purpose Lubricant (GM Part No. 12345120), synthetic SAE 5W-30 engine
oil or silicone lubricant (GM Part No. 1052276 or 1052277).
Engine oil.