1994 MITSUBISHI 3000GT Ignition

Downloaded from www.Manualslib.com manuals search engine 54-78CHASSIS ELECTRICAL - Lighting System
OPERATION light>l
Battery voltage is always applied to the dome light. When the dome light switch is turned to “ON”,
the dome light will remain lit. After either door is opened if the dome light switch is at “DOOR” position,the dome light will come on.
lWith the dome light turned on (with the ignition switch in the OFF position and with the dome light
switch in the DOOR position), close all doors, and the timer circuit in the ETACS unit will be activatedto gradually vary the voltage for approx. 6 seconds owing to the duty control, and the voltage will
be output to transistor Tr. Since the voltage applied to the dome light gradually decreases, the dome
light will be dimmed.lIf the ignition switch is turned to “ON” while the dome light is lit (while the timer is activated), the
timer circuit will be opened to turn “OFF” transistor Tr. This will immediately turn off the dome light
without dimming. light>-lBattery voltage is always applied to the foot lights and ignition key illumination light.
With the ignition switch in the OFF position, open any door, and all lights will come on.
l
With all lights turned on (with the ignition switch in the OFF position), close all doors, and the timercircuit inside the ETACS unit will operate in the same manner as the dome light to dim all lights.
When the ignition switch is placed in the ON position with all lights turned on (with the timer in operation),the same operation as the dome light will take place.
TROUBLESHOOTING HINTS
Phenomenon
Dome light does not come on
when
a door is opened with the
dome light switch in the DOOR
position.
Check the door switch input signal.
Check the door switch. (Refer to GROUP 42 -
The foot lights and ignitionl
key cylinder illumination
Check the dome light switch.
light illuminate.
lCheck the dome light bulb.
Dome light, foot lights and ignition key illumination light go out
l
at once when doors are closed.Check the door switch input signal.(Refer to P.54-80.)Even if ignition switch is turned on while lights are being
l
dimmed,lightsdo notout at the same time.
Check the ignition switch input signal.
go
(Refer toP.54-80.)
COMPONENT LOCATION
Data ‘link
connect&
TSB Revision

Downloaded from www.Manualslib.com manuals search engine With voltmeterData link connector
’‘:’ ’ ’- Data linkGround ETA,CS 21~33300002230
54-80CHASSIS ELECTRICAL - Lighting System
INPUT SIGNAL

When using the scan tool (MUT) or voltmeter
Using the scan tool or voltmeter, check whether or not the
input signals from each switch are being input to the ETACS
unit.
(1) Connect the scan tool to the data link connector located
at the right side of the junction block or connect the voltme-
ter between the ETACS terminal and the ground terminal.
(2) Check if the buzzer of the scan tool sounds or the needleof the voltmeter moves when each switch is operated.
If the buzzer sounds or the needle moves, the input signalsare being input to the ETACS unit, so that switch can
be considered to be functioning normally. If not, the switch
or switch input circuit is faulty. Check the switch and the
switch input circuit.
When using the MUT-II
cup to 1993 models>
Y2OFOl6400002231
#\,I kQwnd\ \U2OFO163

When using the scan tool (MUT-II)
(1) Connect the scan tool to the data link connector. When
connecting the scan tool to a vehicle up to 1993 models,
use the adapter harness supplied together.
Caution
Turn off the ignition switch beforehand whenever thescan tool is connected or disconnected.
(2) If the scan tool makes a peep sound when each switchis operation (turned ON/OFF), the input signal to ECU
is normally sent from the switch circuit system.
When using the voltmeter
(1)Connect a voltmeter to the ETACS terminal and the ground
terminal of the data link connector using the special tool.
(2) If the voltmeter pointer deflects once when each switchis operated (turned ON/OFF), the input signal to ECU
is normally sent from the switch circuit system.
Ii3
\ ~
id ~
!Lj
[ TSB Revision

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Lighting System54-81DOOR LIGHT AND LUGGAGE COMPARTMENT LIGHT
LCIRCUIT DIAGRAM
FUSIBLE LINK@I
I
IOD ORSTaRAGE
CONNECTOR
(A-11X)
R-E
DOOR LIGHT/.f;;$yik COOR
.POWER WINDOW';;gX$MALARM
.TENSION-RE3UCER
TYPE SEAT 3ELT
v
(RH)(E-09:
Y-b
(E-01)
R-G
(c-34)
R-G
(F)Y
4-----
(F>R-E=)R-B
(F>R-E
)
-----1 r-----/
,; ~ R-BII /
>
I/ II I1; cII II IIY/ ,----Ji-----
R-G
(F)Y
E
(F)Y
1
11 (c-83)(c-71)
R-B
i
(D-44;
.ELCdA/TR-i
. MFI SYSTEM
COMBINATIONrMETER
)
>
iX;? LIGHTR-c
m
(D-43)
l(E-32)
R-G
*FOG LIGHT.HEADLIGHT
-2-l
1C
10
51
$I1',1
SO
10
(RH)(LH)NOTE\/:l:UP TO 1995 MODELS
DOOR SWITCH%2:FROM 1996 MODELS
0.85R-1
0.85R-I
r----'/I/II
R-iI
I
/IIIII/(III/I
i R-B"I R-G":
/IL----.
R-B"R-G";
=I.BUZZER'L"RN;RP.k DOOR
.DOME LIGHT.FOOT LIGHT
AND IGNITION
KEY.CYLINDER6 &L#'NAT'ON
-STARTING.;yE;;iALARMj
7(F-19)
LUGGAGE
COMPARTMENT
LIGHT SWITCH
HR08M14AA
TSB Revision

Downloaded from www.Manualslib.com manuals search engine 54-82CHASSIS ELECTRICAL. - Lighting System
CIRCUIT DIAGRAM
FUSIBLE LINKG
2W-B
5W-B(c-68) ,,lHORN/ m
J/B @
10A\I\,
(C-70)y-----3
I
(RR-Y
-1
(A-31X)
-2 I
R-f3
DOORC
R-B
QJ-fE#& DOOR
*DOME LIGHT,FOOT LIGHT
AND IGNITION
KEY CYLINDER
ILLUMINATION
LIGHT
-STARTINGjtjg&ALARM
t
11 (C-83)(c-71)
9
R-B
(D-44)
.ELC-4A/TR-B
.MFI SYSTEM
2
.O0.85R-B(F)R-I:F)R-B
(F)R-I
2
_----7 r----
I' I R-l2II
011 (
1 I/
I I\
.Ot
jl
3R-B
(1995 MODELS)
30
;0
2
R-G
FROM1996 MODELS),.----JI-----
R-G
' f
l(F-46)
R-G
(c-34)
R-G
FOG LIGHT
HEADLIGHT
vCOMPARTMENT
(F>‘
I---_
(F>‘
(F)'
NOCONNECTION
r=
(RH)(LH)
DOOR SWITCH
o(C-34)(c-68)Fml m(c-81)(c-83)
(D-04)(D-43)
HROBM15AA
1 TSB RevisionI

Downloaded from www.Manualslib.com manuals search engine BACK-UP LIGHTCHASSIS ELECTRICAL
- Lighting System54-85
i./’CIRCUIT DIAGRAM CUP TO 1993 MODELS>I
IGNITION SWITCH(IG1)
I
J/B
iir-----_--__-__________-_-
1
M/TI
I
I
L_-----------_--_-_------110r-----
---__--__-_____IIII
I
I0.85R-L
BACK UP
LIGHTCRH)
IBi-~~~~~~~~~~
B
!
2B
PARK/NEUTRAL
POSITION SWITCH
(8-26)
NOTEx1:1992 MODELX2:FROM 1993 MODEL
HROSMOGAA
TSB Revision

Downloaded from www.Manualslib.com manuals search engine 54-86ICHASSIS ELECTRICAL
- Lighting System
CIRCUIT DIAGRAM (FROM 1994 MODELS)
IGNITION SWITCH(IG1)
B-W
2B-W,,7 (c-8)CHARGING
J/B
6310A
0.85B-WlS(c-77)
0.85B-W0.85B-R
PlEADLIGHTTAILLIGHT.PARKING/
SIDE MARKER
LIGHT AND
k];$ySE PLATE
FOG LIGHT;;k#TALARMr-
.---------------------SUPPLEMENTAL
M/T2 A/Tf$Eg$giiNT
r
(F)O.85B-W
2
BACK UP,\
LIGHT
SWITCH
(B-25) OFF&
(F)O.85R-L
F>O.85RI
I6
PARK/NEUTRAL
POSITION SWITCH
I
5
(F>O.85R-LIII
:-___-____-____________
t
3 (c-30)
O.S5R-L
0.85R-L
NOTE::UP TO 1995 MODELS
B"
f28
1 TSB Revision
HR09M07AA

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Lighting System54-87 ~
CIRCUIT DIAGRAM
(FROM 1995 MODELS)
IGNITION SWITCH(IG1)
B-W
2B-W,,7 (c-82)CHARGING
J/B
0.85B-W"16 (c-77)
O.S5B-W28)O.B5B-R
0.85B-W
.!lEADLIGHTr---------_____-----___.TA!LLIGHT.452
PARKING/1M/T
;~$..t!$TAL
I,, A/TSYSTEM
SIDE MARKERII
.FOG LIGHT
PARK/NEUTRALPOSITION SWITCH
0.85R-L
5>4 (F-46)
0.85R-L
R-L
0.85R-L
22
NOTE=:UP TO 1995 MODELS
0
2B
n
(B-25)(c-30)cm(c-82) (F-11) (rn(F-46)
f?EJ~1’~‘~~~ m -1
TSB RevisionHROSMOEAA
I

Downloaded from www.Manualslib.com manuals search engine 54-88CHASSIS ELECTRICAL - Lighting System
COMPONENT LOCATION
Park/Neutral position switch 11
OPERATION
lWhen, with the ignition switch at the “ON” posi-tion, the shift lever (or the selector lever) is
moved to the “R”position, the backup light switch
(M/T) is switched ON (or the park/neutral posi-
tion switch
(A/T) is switched to the “R” position),
and the backup light illuminates.
1 TSB Revisibn