1994 MAZDA MX-5 audio

AUDIO Step 5 1. Disconnect the connector from the suspected faulty headrest speaker and bodysonic. 2. Measure the resistance between the terminals E(G) and w F(G/B) of the headrest speaker and bodysonic connec- tor. I Other I Replace bodysonic I Resistance Step 6 1. Check for continuity between the auto level controller connector (4-pin) and the headrest speaker and body- sonic connector (&pin). Action 1 !::gg 1 continuity I 'peaker I connector I 8!2 I GO to Ste~ 4 I -- ~~ B (RAW) 4-pin ++ F (LN) win Driver-side I A (WB) 4-pin ++ E (UB) 6-pin I Yes Passenger-side 2. If the wiring is OK, replace the auto level controller. 3. If not as specified, repair the wiring. I D (W) 4-pin ++ F (WW) win C (UB) 4-pin +t E (RIB) 6-pin Yes Gartner Banana

AUDIO T REMOVAL / INSTALLATION Remove and install as shown in the figure. AUDIO UNIT 05UOTX-26 MANUAL ANTENNA Gartner Banana

-I- AUDIO DOOR SPEAKERS AND NETWORK Gartner Banana

AUDIO T HEADREST SPEAKERS AND BODYSONIC TYPE 1 HEADRESTSPEAKER TYPE 2 HEADRES Gartner Banana

T AUDIO Gartner Banana

AUDIO T POWER ANTENNA Disassembly 1 Assembly 1. Antenna mast 2. Base 3. Base pad ,, 4. Ground plate 5. Ground base 6. Rod insulator 7. Mast assembly 8. Relay bracket 9. Antenna relay 10. Bracket 11. Motor drive unit 12. Drive mechanism 13. Drive mechanism cover Gartner Banana

AUDIO Inspection c Fuse ness. ml JHFDB If the antenna fails to raise or lower, make the following checks: 1. Check the antenna fuse (10A). 2. Replace fuse after checking and repairing wiring har- Power antenna 1. Check for continuity between the terminals of the power antenna relay. If there is no continuity, replace the relay. Terminal I M: Continuity 2. If the antenna does not function even though there is continuity, the problem may be either in the wiring har- ness or in the audio component assembly. 3. Apply battery positive voltage to the terminals and check the operation. I I A 1 B 1 DOWN I Function of antenna UP Battery Pos. D Neg. A Gartner Banana

T AUDIO / SNAP-RING OUN TlNG NUT BROKEN Antenna Mast Removal / Installation 1. Using snap-ring pliers, remove the mounting nut. 2. With the ignition switch at ACC or ON, turn the radio switch on, and pull out the antenna mast. Check the end of the plastic rack for damage. If the rack end is kinked or broken, replace the motor. 3. With the ignition switch at ACC or ON and the radio on, feed the rack of the new mast into the motor with toothed side facing toward the front of the vehicle. Turn the radio off. While the motor is retracting the rack, feed the mast into the motor. 4. Reinstall the mounting nut. 5. With the ignition switch at ACC or ON, turn the radio on and off a few times and check to see that the antenna op- erates smoothly. Gartner Banana